WYZE SPRINKLER CONTROLLER
Manual
WSPRK1
Introduction
Congratulations on purchasing a Wyze Sprinkler Controller. This Quick Reference
Guide describes how to install, operate, and maintain your controller. Please read the
instructions below.
Package List
Mount screws and anchors power adapter
Sprinkler Controller
Controller Stations
Wyze Sprinkler is an 8-station controller. Each station is connected to a sprinkler
valve. The specific valve turns on when it receives a signal from the controller, and
then the sprinkler will start watering. When the watering task is finished, the
controller will shut off the valve and turn on the next one in sequence.
Step-by-Step Instructions
Step 1 Drilling on the wall
Drill two holes at the installation position, the size of the holes is φ 6mm × 40mm,
and the distance between the two holes is 90mm. If the installation wall is made of
wood, please see step 3.
Step 2 Installing anchors
Tap the anchors into the holes on the wall.
Step 3 Mounting
Screw the mount on the wall.
Step 4 Wiring
Connect power adapter, valve wires and sensors to corresponding terminals.
Step 5 Installing controller
Place the back of the controller at the lower end of the mount and push the
controller up into the mount.
Step 6 App setup
Download the Wyze APP and select “Add a product”, then the app will guide you
to complete the setup process. After finishing the system setup, you can create the
irrigation tasks.
Manual Controls
You can run the zone watering easily on the device. Press the left and right button to
select a zone. Press the WATERING button (the upper one) to start a quick run
immediately and press the STOP button (the lower one) to stop the watering.
Troubleshooting
One or more stations do not turn on:
1. Faulty valve.
2. Wire broken or not connected.
One station is stuck on and will not shut off:
1. Faulty valve.
2. Particles of dirt or debris stuck in the valve.
3. Valve diaphragm faulty.
Controller is not online:
1. Power adapter not plugged into an operational AC outlet.
2. Wi-Fi connection unstable.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the followi
ng two conditions: (1) this device may not cause harmful interference, and (2) this de
vice must accept any interference received, including interference that may c
ause undesired operation.
Changes or modifications not expressly approved by the party responsible for compl
iance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Cla
ss B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installatio
n. This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interferen
ce to radio communications. However, there is no guarantee that interference will no
t occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help important ann
ouncement
Important Note:
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
ISED Statement
-English: This device complies with Industry Canada license‐exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause in
terference, and (2) This device must accept any interference, including interference t
hat may cause undesired operation of the device.The digital apparatus complies with
Canadian CAN ICES‐3 (B)/NMB‐3(B).
‐ French:Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux
appareils
radio exempts de licence. L'exploitationestautorisée aux deux conditions suivantes: (
1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareildoit ac
cepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'enc
ompromettre le fonctionnement.
This radio transmitter (ISED certification number: 26041-WSPRK1) has been
approved by Industry Canada to operate with theantenna types listed with the
maximum permissible gain indicated. Antenna types not included in this list, having
a gain greater than the maximum gain indicated for that type, are strictly prohibited
for use with thisdevice.
Le présentémetteur radio (ISED certification number: 26041-WSPRK1) aétéapprouvé
par Industrie Canada pour fonctionner avecles types d'antenneénumérés ci-dessous
et ayant un gain admissible maximal. Les types d'antenne non inclusdanscetteliste,
etdont le gain estsupérieur au gain maximal indiqué, sontstrictementinterdits pour
l'exploitation de l'émetteur.
Radiation Exposure Statement
This equipment complies with Canada radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Déclarationd'exposition aux radiations
Cetéquipementestconforme Canada limitesd'exposition aux radiations dans un
environnement non contrôlé. Cetéquipementdoitêtreinstallé et utilisé à distance
minimum de 20cm entre le radiateur et votre corps.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
dans d''autres langues
- English: Wyze WSPRK1 User manual
Documents connexes
-
Wyze Light Strip Pro 10M Mode d'emploi
-
Wyze Battery Cam Pro Outdoor Smart Camera Mode d'emploi
-
-
Wyze B09L8DJ2L6 Mode d'emploi
-
Wyze WVOD2 Mode d'emploi
-
-
Wyze WSCALX Mode d'emploi