TOUCAN TSLC10WU Security Light Camera Mode d'emploi
- Taper
- Mode d'emploi
We Make Security Easy
Security Light Camera
User Manual
TSLC10WU
Regulations & Compliance
Fcc Statement
Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular Installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
ISED Regulatory Compliance
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
RF Exposure Compliance
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
Cet équipement est conforme aux limites d’exposition aux radiations FCC/IC établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre
corps.
VuPoint Solutions, Inc. (USA):
710 Nogales Street, City of Industry, CA 91748
VuPoint (Europe) Company Limited:
Innovation Center, Longbridge Technology Park,
Longbridge, Birmingham B31 2TS
©2021 VUPOINT SOLUTIONS, INC. All Rights Reserved.
The Toucan logo and Toucan are trademarks or registered trademarks of VuPoint Solutions Inc. in the United States and other
countries. App Store is a registered trademark of Apple Inc. iOS is a registered trademark of Cisco Technology, Inc. in the
U.S. and other countries and is under license. Android and Google Play are registered trademarks of Google LLC. Product
names, logos, brands and other trademarks referred to herein are the property of their respective trademark holders. All
trademarks remain the property of their respective holders, and are used only to describe the products or services being
provided. These trademark holders are not aliated with VuPoint Solutions, Inc. They do not sponsor or endorse VuPoint
Solutions, Inc’s products or services.
facebook.com/toucansmarthome
Instagram.com/toucansmarthome
Youtube.com/c/toucansmarthome
Items Included
Security Light Camera Secure Camera Mount
ScrewsWall Anchors 2m Power Supply
Thank You Card
Warranty Card
Quick Start Guide
6m Power Cable
wall anchors x 4 screw x 4
tighten
Get to know your Security Light Camera
Set up your Security Light Camera
Install your Security Light Camera
White and
Infrared LEDs
Camera Lens
Microphone
LED Indicator
Light level Sensor
RADAR motion sensor
(below camera lens)
Scan QR code or visit
https://www.toucansolution.com/
pages/toucan-smart-home-app
Available at Apple© App Store© and Google Play™
Flashing BLUE
Flashing PURPLE
Flashing RED
Setup Mode
Connecting to cloud server, DO NOT TURN OFF POWER
Connection Failed
Camera Mount
Screw Hole
SET button
Antenna
Speaker 12v DC Power Input
Follow the In-App
instructions and
device voice prompts
to complete the setup
Tap the “+” to
add a device
* Do not force or remove the antenna
Tightening
Collar
Tightening
Ring
Download the Toucan App
1Login to the App
2
Create your
Toucan account
and login
Add and pair your device
3
LED
Description
Tools Needed
Drill
Mark the holes
1Drill the holes
2
Insert anchors
3Attach the mount
4
Attach the Security Light Camera
5Tighten the mount
6
Philips
screwdriver
(cross head)
¼” Drill bit
-
1
-
2
