Alula DWS-LL LongLife Door-Window Sensor Mode d'emploi

Marque
Alula
Modèle
DWS-LL LongLife Door-Window Sensor
Taper
Mode d'emploi

Ce manuel convient également à

LongLife Door/Window Sensor is a transmitter with a
ten year battery life. Typically used to sense opening and
closings of doors and windows, it will alarm when the
magnet is pulled away from the sensor.
Features
• Ten year battery life
• Quick peel and press mounting
• Secure encrypted wireless transmissions
Enroll by placing the panel into wireless enrollment mode
and then sending an enrollment signal from the sensor.
Alternatively, the sensor can be enrolled by entering its
8-character serial number in the AlulaConnect™ portal.
Options for sending an Enrollment Signal
• Remove the battery tab, which can be done
without removing the cover, OR
• Remove the cover to trip the tamper
Note: Slide the cover to open and close
Install by removing the adhesive paper and adhering
the sensor and magnet on a door or window. Leave a
minimum of 3/16 inch clearance around the ends of the
sensor to allow the cover to open. Make sure to align
the alignment marks on the sensor and magnet when
mounting.
3M VHB Tape works great if the surface is properly
prepared and rm pressure is applied for over 10
seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is
above 50°F
Use the panel installation guide to verify proper system setup.
LongLife Door/Window Sensor
Connect+™ Encrypted (DWS-LL)
I
N
S
T
A
L
L
G
U
I
D
E
I
Slide to
Open
3/16”
3/16”
TRADEMARKS
Alula, Connect+, and AlulaConnect are trademarks owned by
Alula Holdings, LLC. All trademarks, logos and brand names are
the property of their respective owners. All company, product and
service names used in this document are for identication purposes
only. Use of these names, trademarks and brands does not imply
endorsement.
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modications not expressly approved by Alula could
void the user’s authority to operate this equipment.
FCC ID: U5X-DWSLL
Specications
IC NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
IC: 8310A-DWSLL
47-00016 • Rev B • 2022-08-17
Tech Support Line • (888) 88-ALULA • (888) 882-5852
alula.com
01
Physical
Housing Dimensions
Weight with Battery
Mounting Fastener
2.90 x 1.04 x 0.39 inches (7.4 x 2.6 x 1.0 cm)
0.79 ounces (22.5 grams)
3M VHB Tape
Environmental
Operating Temperature
Maximum Humidity
32°F to 120°F (0°C to 49°C)
85% non-condensing relative humidity
Sensor Specications
Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications
Magnet Gap Distance
433.92 MHz
One Panasonic CR2032
10 years
3.0 VDC (Nominal)
20 mA (Maximum), 0.5uA (Quiescent)
Cover Tamper, Low Battery, Supervision
0.75 inches maximum (1.9 cm)
Certications
DWS-LL FCC, IC
Specications subject to change without notice
  • Page 1 1
  • Page 2 2

Alula DWS-LL LongLife Door-Window Sensor Mode d'emploi

Marque
Alula
Modèle
DWS-LL LongLife Door-Window Sensor
Taper
Mode d'emploi
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes

Autres documents