FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation.
lf this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Should you need further certification information (FCC ID, IC) please open the cover at the
bottom of the product by rotating it counterclockwise with the palm of your hand.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body and must not be co-located or operating in
conjunction with any other antenna or transmitter. This equipment complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Caution!
Any changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Legal notice
“Made for iPod”, “Made for iPhone”, “Made for iPad” mean that an electronic accessory has
been designed to connect specifically to iPod, iPhone and iPad and has been certified by the
developer to meet Apple performance standards. Apple is not responsible for the operation of
this device or its compliance with safety and regulatory standards.
Please note that the use of this accessory with iPhone may aect wireless performance.
Safety warnings
This device is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
Before inserting the batteries, check that the contacts in the device and on the batteries are
clean, and clean them if necessary. Note the polarity (+/-) when inserting the batteries.
Do not throw the batteries into a fire, short-circuit it or dismantle it. Keep children away from
batteries. Seek medical attention immediately if a battery is swallowed.
Consignes de sécurité
Cet appareil n’est pas destiné à être utilisé par des personnes (notamment des enfants) dont
les capacités physiques, sensorielles ou mentales sont réduites, ou qui n’ont pas d’expérience
et de connaissances, à moins qu’elles ne soient surveillées ou instruites concernant l’utilisation
de l’appareil par une personne responsable de leur sécurité. Les enfants doivent être surveillés
pour s’assurer qu’ils ne jouent pas avec l’appareil. Avant d’insérer les piles, vérifiez que les
contacts de l’appareil et des piles sont propres, et nettoyez-les si nécessaire. Respectez la
polarité (+/-) lors de l’insertion des piles. Ne pas jeter les piles dans un incendie, créer de
court-circuit ou les démanteler. Gardez les enfants loin des piles. Consulter immédiatement un
médecin si une pile est avalée.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil est conforme aux normes CNR exemptes de licence d’Industrie Canada.
Le fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas
provoquer d’interférences et (2) cet appareil doit accepter toute interférence, y compris celles
susceptibles de provoquer un fonctionnement non souhaité de l’appareil.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnant en conjonction
avec une autre antenne ou transmetteur.
Copyright Netatmo (c) 2016. All rights reserved.
Reproduction and distribution prohibited without
written authorization from Netatmo.
Product Model: NWS01OUT
FCC ID: N3A-NWS01OUT
IC: 10860A-NWS01OUT