FCC Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
lf this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
Should you need further certification information (FCC ID, IC)
please open the product from the bottom.
FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure
limits set forth for an uncontrolled environment. This
transmitter should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your
body and must not be co-located or operating in conjunction
with any other antenna or transmitter. This equipment
complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Caution!
Any changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Legal notice
“Made for iPod”, “Made for iPhone”, “Made for iPad” mean
that an electronic accessory has been designed to connect
specifically to iPod, iPhone and iPad and has been certified
by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its
compliance with safety and regulatory standards.
Please note that the use of this accessory with iPhone may
aect wireless performance.
Safety warnings
This device is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Before inserting the batteries, check that the contacts in
the device and on the batteries are clean, and clean them
if necessary. Note the polarity (+/-) when inserting the batteries.
Do not throw the batteries into a fire, short-circuit it or
dismantle it. Keep children away from batteries. Seek medical
attention immediately if a battery is swallowed.
Consignes de sécurité
Cet appareil n’est pas destiné à être utilisé par des personnes
(notamment des enfants) dont les capacités physiques,
sensorielles ou mentales sont réduites, ou qui n’ont pas
d’expérience et de connaissances, à moins qu’elles ne
soient surveillées ou instruites concernant l’utilisation de
l’appareil par une personne responsable de leur sécurité.
Les enfants doivent être surveillés pour s’assurer qu’ils ne
jouent pas avec l’appareil.
Avant d’insérer les piles, vérifiez que les contacts de
l’appareil et des piles sont propres, et nettoyez-les si
nécessaire. Respectez la polarité (+/-) lors de l’insertion des
piles.
Ne pas jeter les piles dans un incendie, créer de court-
circuit ou les démanteler. Gardez les enfants loin des piles.
Consulter immédiatement un médecin si une pile est avalée.
Canadian Compliance Statement
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Cet appareil est conforme aux normes CNR exemptes de
licence d’Industrie Canada. Le fonctionnement est soumis
aux deux conditions suivantes: (1) cet appareil ne doit pas
provoquer d’interférences et (2) cet appareil doit accepter
toute interférence, y compris celles susceptibles de
provoquer un fonctionnement non souhaité de l’appareil.
This Class B digital apparatus complies with Canadian ICES-
003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
This device and its antenna(s) must not be co-located
or operating in conjunction with any other antenna or
transmitter.
Cet appareil et son antenne (s) ne doit pas être co-localisés
ou fonctionnant en conjonction avec une autre antenne ou
transmetteur.
Copyright Netatmo (c) 2016. All rights reserved.
Reproduction and distribution prohibited without
written authorization from Netatmo.
Product Model: NRG02
FCC ID: N3A-NWS02RG
IC: 10860A-NWS02RG