Spectra Focus Mode d'emploi

Taper
Mode d'emploi
QUICK START GUIDE/
REGULATORY INFORMATION DOCUMENT
The Spectra Geospatial® FOCUS® data collector model 2 is an attachable controller
designed to run eld software for surveying.
For enhanced security, it is recommended that you set a PIN, Password or Pattern
on the device before eld use.
The FOCUS data collector model 2 can be attached to a Spectra Geospatial FOCUS
50 total station, or it can be used with a Robotic Holder Model 2 or Docking Station
Model 2.
FOCUS DATA COLLECTOR
MODEL 2
2
IN THE BOX
FOCUS data collector model 2,
including screen protector Warranty Activation Card
Docking Station Model 2 Quick Start Guide/Regulatory
Information Document
Stylus with tether cord and extra tip Hirose-to-USB (PC) cable
Power supply Hirose-to-USB stick cable
Declaration of Conformity
3
FOCUS DATA COLLECTOR MODEL 2 FEATURES
FOCUS DATA COLLECTOR MODEL 2 SPECIFICATION
Power rating
Power input 12 V DC, <5 W
Environmental specication
IP Classication / dust and water proong IP 65
Operating temperature range -20 °C to +50 °C (-4 °F to +122 °F)
Humidity 95%, non-condensing
For further specications, refer to the FOCUS data collector model 2 data sheet
available from www.spectrageospatial.com.
3 4
Touch screen
display with
screen protector
Power key
Stylus
Keyboard
Speaker
Lock release
Regulatory label Power and
communication
connectors
Catch Catch
Identication label
DOCKING STATION MODEL 2 FEATURES
DOCKING STATION MODEL 2 SPECIFICATION
Power rating
Power input 12 V DC, <5 W
TETHERING THE STYLUS
4
Power and communication connectors
Lock catch
+12 V connector
COM connector
Identication label
Foldable leg
Foldable leg
4
POWER SUPPLY
C CAUTION – The power supply for the FOCUS data collector model 2 (Docking
Station Model 2) is intended for indoor use only and shall not be exposed to
moisture or liquids.
OPERATION OF THE FOCUS DATA COLLECTOR MODEL 2
To operate the FOCUS data collector model 2 it must be attached to a FOCUS 50
total station, a Docking Station Model 2, or to a Robotic Holder Model 2 for power
supply.
C CAUTION – If the equipment is used in a manner not specied by Spectra
Geospatial, the protection provided by the equipment may be impaired.
ATTACHING TO THE DOCKING
STATION MODEL 2
1. Hook the catches in place on the
Docking Station Model 2.
2. Push towards the Docking Station
Model 2 until it locks in place.
REMOVING FROM THE DOCKING
STATION MODEL 2
1. Push the lock release to unlock from the Docking Station Model 2.
2. Remove from the Docking Station Model 2.
CONNECTING THE DOCKING STATION MODEL 2
5
To the power supply To computer via the Hirose
to USB cable or to memory
stick via the Hirose-to-USB
stick cable.
6
POWER ON/OFF
Press the power key to start the FOCUS data collector model 2. To shutdown the
FOCUS data collector model 2, press and hold the power key. Select Power off
from the menu.
REGULATORY INFORMATION
INFORMATION ABOUT INCLUDED RADIO MODULES
The FOCUS data collector model 2 contains a Bluetooth® wireless technology
radio and Wi-Fi module.
SX-SDMAC-2830S Frequency band Output power
Bluetooth 2.4 GHz 2400 MHz-2483.5 MHz < 4 dBm eirp
Wi-Fi 2.4 GHz 2400-2483.5 MHz < 20 dBm eirp
Wi-Fi 5.0 GHz 5150-5350 MHz, 5470-5725 MHz < 14 dBm eirp
SPECIFIC ABSORPTION RATE (SAR) SIMULTANEOUS TRANSMISSION
SAR10g(W/kg) in Body-Worn Conguration: 1.44
SAR10g(W/kg) in Limb Conguration: 1.44
NOTICE TO OUR EUROPEAN CUSTOMERS
For product recycling instructions, please go to:
www.spectrageospatial.com/weee-and-rohs/
USA
Suppliers Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identier
Spectra Geospatial FOCUS data collector model 2
Trimble Docking Station Model 2
7
Responsible Party
Spectra Geospatial
10368 Westmoor Drive
Westminster CO 80021
USA
www.spectrageospatial.com
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
C CAUTION – Changes or modications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
Spectra Geospatial
10368 Westmoor Drive
Westminster CO 80021
USA
© 2022, Trimble Inc. All rights reserved. Spectra Geospatial is a division of
Trimble Inc. FOCUS, Spectra Geospatial and Trimble are registered trademarks of
Trimble Inc. or its subsidiaries. The Bluetooth word mark and logos are owned by
the Bluetooth SIG, Inc. and any use of such marks by Trimble Inc. is under license
All other trademarks are the property of their respective owners.
P/N 57127052-ENG, Revision B, August 2022. www.spectrageospatial.com
C CAUTION – Please read the full user guide including
all safety warnings, before operating this product.
PDF
7
CANADA
This Class B digital apparatus complies with Canadian ICES-003.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canadas licence-exempt RSS(s).
Operation is subject to the following two conditions: (1) This device may not cause
interference. (2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Cet appareil numérique de la classe B est conforme à la norme NMB.003 du Canada.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
SAFETY INFORMATION
Before using the FOCUS data collector model 2, Docking Station Model 2 and power
supply, make sure that you have read and understand this document, as well as all
equipment and job site safety requirements.
ADDITIONAL INFORMATION
The original document is written in English. All documents in other languages
are translations from the original English document. For more information and
information in other languages, www.spectrageospatial.com.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Spectra Focus Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues