IR-1000 user manual
Wireless controller
contents
Product Description --------------------------------------------- p.3
Steps for usage -------------------------------------------------- p.4
Technical parameter ------------------------------------------- p.4
Warning ----------------------------------------------------- p.4~p.5
Product Description
1. Indicator light--Lights up white when the controller is being operated, and flashes
red after being operated when the battery is low.
2. Photograph--Can control the camera to take pictures
3. Focus ---Can control camera focus
4. Freeze--The camera software can be controlled to freeze the screen
indicator light
AF/MF
Mute
freeze
focus
Photograph
control loop
Product Name:Wireless controller
Model No.: IR-1000
FCC ID: JVPIR-1000
IC: 6175A-IR1000
XXX-XXXXXX
Product Name: USB receiver
Model No.: IR-1000R
FCC ID: JVPIR-1000R
IC: 6175A-IR1000R
XXX-XXXXXX
5. Mute--Software-controlled mute
6. Control loop--Controllable screen size
7. AF/MF – AF/MF function can be controlled
Usage scenario: The camera can be controlled through a computer connection,
which belongs to the spare parts used around the computer.
Steps for usage
1. Remove the battery cover, install 2*AAA batteries, and close the battery cover
2. Open the software on the computer to connect the camera and plug in the USB
receiver
3. Functions available on the controller
Technical parameter
3.1 Electrical parameters
Operating Voltage：AAA*2；
3.2 RF parameters
Frequency Range
Occupied bandwidth
Transmit power
2400-2483.5MHz
≤ 2MHz
-6.0 dBm(EIRP)
RF exposure statement
This equipment complies with the FCC and ISED radiation exposure limits set forth
for an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux rayonnements de la FCC
et de l'ISED établies pour un environnement non contrôlé. Cet émetteur ne doit pas
être co-localisé ou fonctionner en conjonction avec une autre antenne ou un autre
émetteur.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
IC WARNING
This device contains licence-exempt transmitter(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
-
1
-
2
-
3
-
4
-
5
-
6
