NANAMI X1 Manuel utilisateur

Marque
NANAMI
Modèle
X1
Taper
Manuel utilisateur
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference,This device
must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reas-
onable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in acco-
rdance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following.
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
English:
This device complies with Industry Canada licence-exempt
RSS standard( s). Operation is subject to the following two
conditions:
(1)this device may not cause interference.
(2)this device must accept any interference, including interfe-
vrence that may cause undesired operation of the device.
French:
Le présent appareil est conforme aux CNR d'Industrie Ca-
nada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée.
aux deux conditions suivantes:
(1)l'appareil nedoit pas produire de brouillage.
RF warning statement:
The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable
exposure condition without restriction.
(2)l'utilisateur de l'appareil doit accepter tout brouillage ra-
dioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Warning: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to IC
Rules. These limits are designed to provide reasonable pr-
otection against harmful interference in a residential install-
ation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accorda-
nce with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or tel-
evision reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following meas-
ures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for
help.
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment can be
used in portable exposure condition without restriction.

  • Page 1 1

NANAMI X1 Manuel utilisateur

Marque
NANAMI
Modèle
X1
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents