Chief FCA115 Guide d'installation
- Catégorie
- Accessoires pour écran plat
- Taper
- Guide d'installation
INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Extra Fusion™ Wall Plate
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
FCA115
FCA115 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! Adding the
FCA115 wall plate to the XSM1U/XTM1U wall mount
provides additional support but does not change the weight
capacity listed for the mount.
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
3.00
8.6
4.75
120.7
76.2
1.82
46.2
0.34
Installation Instructions FCA115
3
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Drill Hole
Perforar
Bohrloch
Fazer furo
Praticare un foro
Gat boren
Percez un trou
Adjust
Ajustar
Einstellen
Ajustar
Regolare
Afstellen
Ajuster
Remove
Quitar
Entfernen
Remover
Rimuovere
Verwijderen
Retirez
Optional
Opcional
Optional
Opcional
Opzionale
Optie
En option
Security Wrench
Llave de seguridad
Sicherheitsschlüssel
Chave de segurança
Chiave di sicurezza
Veiligheidssleutel
Clé de sécurité
FCA115 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
7/32" (5.5mm) - wood studs
1/2" (12.7mm)
3/8" (9.5mm) - concrete
A (1)
[wall plate]
B (2) C (2)
D (2)
E (2)
[wall plate cap]
5/16 x 2-1/2" UX10x60mm
[Slotted
washer]
Installation Instructions FCA115
5
Assembly And Installation
Installing FCA115 Wall Plate to XTM1U/XSM1U
Mount
1. Remove caps from one side of mounting rails on XTM1U/
XSM1U mount. (See Figure 1)
Figure 1
2. Slide FCA wall plate (A) onto XTM1U/XSM1U mount rails.
(See Figure 2)
3. Reinstall caps onto mounting rails. (See Figure 2)
Figure 2
4. Position three wall plates 16" apart from each other on rails.
(See Figure 3)
Figure 3
Installing to a Wood Stud Wall
1. Determine the center of the TV screen, and where it should
be located on the wall.
2. Locate the closest stud to the selected location.
NOTE: Center of display should be located either directly over
or near a stud.
3. Line up the notches on mount with center of screen marking
to determine vertical center. (See Figure 4)
4. Measure up 8" (203mm) from the center point to mark
location of the upper mounting slots.
Figure 4
1
3
2
2
2
16"
16"
Center of screen
8"
Vertical center
of mount
(203.2mm)
FCA115 Installation Instructions
6
5. Using a level, mark the wall on each stud to attach the
mount through the upper mounting slots. (See Figure 5)
6. Drill one 7/32" (5.5mm) pilot hole in each stud.
7. Partially install three 5/16 x 2-1/2" flanged lag bolts (B) into
pilot holes but do not tighten to wall.
8. Hang mount, aligning upper mounting slots over lag bolts
and adjust side-to-side for proper location.
9. Place one slotted washer (D) over each flanged lag bolt.
(See Figure 5)
10. Tighten lag bolts to secure mount to wall at upper mounting
slots.
11. Mark the attachment points for the lower mounting slots,
making sure the attachment points are located on the studs.
(See Figure 5)
12. Drill 7/32" (5.5mm) pilot holes at markings for lower
mounting holes. (See Figure 5)
13. Use three 5/16 x 2-1/2" flanged lag bolts (B) and two 5/16"
slotted washers (D) to attach the mount to the wall through
the lower mounting holes. (See Figure 5)
14. Slide rails to approximate center of screen location.
Figure 5
Installing to a Concrete Wall
1. Determine the center of the TV screen, and where it should
be located on the wall.
2. Line up the notches on mount with center of screen marking
to determine vertical center. (See Figure 6)
3. Measure up 8" (203.2mm) from the center point to mark
location of the upper mounting slots. (See Figure 6)
4. Using a level, mark the wall through both upper mounting
slots. (See Figure 6)
Figure 6
5. Drill one 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot hole at each
marking. (See Figure 6)
6. Install an anchor (C) into each pilot hole using a hammer,
making sure that the anchor is flush with the wall. (See
Figure 6)
7. Partially install three 5/16 x 2-1/2" flanged lag bolts (B) into
pilot holes but do not tighten to wall. (See Figure 6)
8. Hang mount, aligning upper mounting slots over lag bolts
and adjust side-to-side for proper location.
9. Place one slotted washer (D) over each flanged lag bolt.
(See Figure 6)
10. Tighten lag bolts to secure mount to wall at upper mounting
slots.
11. Mark the attachment points for the lower mounting slots,
making sure the attachment points are located on the studs.
(See Figure 6)
12. Drill 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot holes at markings
for lower mounting holes. (See Figure 6)
13. Use three 5/16 x 2-1/2" flanged lag bolts (B) and two 5/16"
slotted washers (D) to attach the mount to the wall through
the lower mounting holes. (See Figure 6)
14. Slide rails to approximate center of screen location.
See XSM1U/XTM1U Installation Instructions to complete
installation.
11 12
56
7
10
(B) x 3
9
(D) x 6
13
(B) x 3
13
11
5
64
12
x 6
(C) x 6
10 7 10
(B) x 3
(D) x 6
9
13
13
(B) x 3
Installation Instructions FCA115
7
FCA115 Installation Instructions
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P800.582.6480 / 952.225.6000
F877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P+31 (0) 495 580 852
F+31 (0) 495 580 845
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P852 2145 4099
F852 2145 4477
Chief, a products division of
Milestone AV Technologies
8800-002782 Rev00
2015 Milestone AV Technologies
www.chiefmfg.com
08/15
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Chief FCA115 Guide d'installation
- Catégorie
- Accessoires pour écran plat
- Taper
- Guide d'installation
dans d''autres langues
- English: Chief FCA115 Installation guide