Cellular
Broadband Adapter
CBA250
2
2
Quick Start Guide
11
Connect Power:
To setup the CBA250, unbox
the packaging. Next, plug the
power adapter into the CBA250 first,
then plug the adapter into the wall
socket.
12
Connect Device:
Plug in an activated USB or
ExpressCard device into the
appropriate slot. Note that your
device must be on the supported list.
For more information:
http://www.cradlepoint.com/support
O - Configuration mode
I - Normal mode (Pass Through)
LED Status:
1. Power
On - Solid Green
2. Ethernet
Connected - Solid Green
Activity - Blinking Green
3. Not Used
4. USB Status
Standby/Connecting - Orange
Connected - Solid Green
Activity - Blinking Green
Red - Unsupported Device Error
1
2
3
4 5
6
5. ExpressCard
Standby/Connecting - Orange
Connected - Solid Green
Activity - Blinking Green
Red - Unsupported Device Error
6. Signal Strength
Signal strength is displayed in 4
bars but is measured in half
bars. A full bar will be solid, and
a half bar will blink.
Parts List:
Cellular Broadband Adapter
Power Adapter
Quick Start Guide
Notice: Taking these actions will erase all settings and changes
you have made to the router. All passwords and settings will
return to the factory defaults.
Manually Updating Firmware
1. Switch the unit to Configuration mode - O.
2. Connect to the adapter via Ethernet.
3. Use a browser to access the Admin page (http://192.168.0.1).
4. The Admin password is the last six digits of the unit’s MAC address.
5. Select the 'Tools' tab on the top, then the 'Firmware' menu on the left.
6. Select the button “Check Online Now for Latest Firmware Version”
7. Select the Upgrade Router button. (If new Firmware available.)
8. Do not turn off or unplug the device while it is upgrading.
9. The upgrading process should take a few minutes.
Factory Reset
1. Ensure the adapter is unplugged from the wall socket.
2. Press and hold the reset button.
3. Continuing to hold the reset button, plug the device into a power source.
4. Release the reset button when the lights flash (10 seconds).
5. The adapter will restart and be available on the default settings.
3
13
Connect LAN:
Connect a client device to the
CBA250 with an Ethernet cable.
For most users, the CBA250 can be used without congura-
tion. When needed, the Cong switch is used to place the
unit in the conguration mode. Conguration mode is used
to setup user parameters, download new Firmware and
enable cellular modem diagnostics.
Conguration mode is accessed by browsing to the Admin
page at http://192.168.0.1