Avantco 194UCB77A Undercounter Ice Machine Manuel utilisateur

Taper
Manuel utilisateur
- 1 -
User ManualUser Manual
Undercounter Ice Machine
Users Manual
Please read the manual thoroughly prior to equipment set-up,
operation and maintenance.
194UCB77A
07/2022
- 2 -
User Manual
Warning and Safety
DANGER – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. TO BE REPAIRED ONLY
BY TRAINED SERVICE PERSONNEL. DO NOT PUNCTURE REFRIGERANT TUBING.
PELIGRO - RIESGO DE INCENDIO O EXPLOSION. REFRIGERANTE INFLAMABLE UTILIZADO. PARA
SER REPARADO SOLAMENTE POR PERSONAL DE SERVICIO CALIFICADO. NO PINCHAR LA TUBERÍA
REFRIGERANTE.
DANGER – RISQUE DE FEU OU D’EXPLOSION. LE FRIGORIGÈNE EST INFLAMMABLE. CONFIER LES
RÉPARATIONS À UN TECHNICIEN SPÉCIALISÉ. NE PAS PERFORER LA TUBULURE CONTENANT LE
FRIGORIGENE.
CAUTION – RISK OF FIRE OR EXPLOSION. FLAMMABLE REFRIGERANT USED. CONSULT REPAIR
MANUAL/OWNER’S GUIDE BEFORE ATTEMPTING TO SERVICE THIS PRODUCT. ALL SAFETY
PRECAUTIONS MUST BE FOLLOWED.
ATENCION - RIESGO DE INCENDIO O EXPLOSIÓN. REFRIGERANTE INFLAMABLE UTILIZADO.
CONSULTEEL MANUAL DE REPARACIÓN / GUÍA DEL PROPIETARIO ANTES DE INTENTAR DAR
SERVICIO A ESTE PRODUCTO. DEBEN CUMPLIR CON TODAS LAS PRECAUCIONES DE SEGURIDAD.
ATTENTION – RISQUE DE FEU OU D’EXPLOSION. LE FRIGORIGÈNE EST INFLAMMABLE. CONSULTER
LE MANUEL DU PROPRIÉTAIRE/GUIDE DE RÉPARATION AVANT DE TENTER UNE RÉPARATION.
TOUTES LE MESURES DE SÉCURITÉ DOIVENT ÊTRE RESPECTÉES.
CAUTION – RISK OF FIRE OR EXPLOSION DUE TO PUNCTURE OF REFRIGERANT TUBING; FOLLOW
HANDLING INSTRUCTIONS CAREFULLY. FLAMMABLE REFRIGERANT USED.
ATENCION - RIESGO DE INCENDIO O EXPLOSIÓN DEBIDO A LA PERFORACION DE LA TUBERÍA
REFRIGERANTE; SIGA LAS INSTRUCCIONES DE MANIPULACIÓN CON CUIDADO. REFRIGERANTE
INFLAMABLE UTILIZADO.
ATTENTION – RISQUE DE FEU OU D’EXPLOSION SI LA TUBULURE CONTENTANT LE FRIGORIGÈNE
EST PERFORÉE; SUIVRE LES INSTRUCTIONS DE MANUTENTION AVEC SOIN. LE FRIGORIGÈNE EST
INFLAMMABLE.
CAUTION – RISK OF FIRE OR EXPLOSION DUE TO FLAMMABLE REFRIGERANT USED. FOLLOW
HANDLING INSTRUCTIONS CAREFULLY IN COMPLIANCE WITH LOCAL GOVERNMENT
REGULATIONS.
ATENCIÓN – RIESGO DE INCENDIO O EXPLOSIÓN DEBIDO A REFRIGERANTE INFLAMABLE
UTILIZADO. SIGA LAS INSTRUCCIONES DE MANIPULACIÓN CON CUIDADO CONFORME A LAS
REGLAS DE LA MUNICIPALIDAD.
ATTENTION – RISQUE DE FEU OU D’EXPLOSION SI LE FRIGORIGÈNE EST INFLAMMABLE. SUIVRE
LES INSTRUCTIONS DE MANUTENTION AVEC SOIN CONFORMÉMENT AUX RÈGLEMENTATION
GOUVERNEMENTALE LOCAUX.
- 3 -
User Manual
This product cannot be used in outdoor environments. Not intended for use by children, persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge.
The installation, repair or maintenance of this ice machine must be carried out by professional and
qualified personnel. Electric shock, fire, personal injury may result from incorrect operation.
After the ice machine is delivered, please keep the machine upright for at least 24 hours to have the
refrigerant be fully precipitated before startup. Otherwise the compressor may be damaged.
When handling, keep the cabinet upright with the inclination not exceeding 45 degrees. Do not invert the
machine or lay it horizontally.
This ice machine should not be placed in wet or easily splashed areas.
The grounding of this ice machine cannot be connected to a gas pipe, water pipe, telephone line or
lightning rods, etc.
There are rotating components in this ice machine. Do not insert slim objects into ventilation or exhaust
ports, or serious mechanical damage and injury may occur.
Do not store volatile or flammable substances in this ice machine or it may result in explosion or fire.
Do not store any sundries or freeze any food in the storage bin. Keep the ice scoop clean.
The ice machine must be placed on a floor sufficient enough to support its weight. Insufficient base may
cause the equipment to fall over and cause injury.
There should be sufficient ventilation space around the ice machine. See page 5 for clearance
requirements.
Only the power supply specified on the machine nameplate can be used with this ice machine.
This ice machine cannot be connected to hot water.
Outlet for this ice maker must be reliably grounded with leakage protection.
The ice machine must be disconnected from power before manual cleaning, repairing and maintenance.
Before cleaning, repairing and maintenance, the remaining ice in the ice bin should be removed from the
ice machine to avoid contamination to ice.
Do not splash water directly onto the surface of the ice machine during the cleaning process; otherwise it
may cause short circuit, leakage or other faults.
Flammable foaming agent is used during the foaming process. The ice maker should be disposed of and
recycled by qualified personnel and institutions.
The ice machine should be properly managed to ensure that children will not play with the machine.
When the ice machine malfunctions, turn off the power and contact professional personnel to be repaired.
This product cannot be used in outdoor envrionments. Not intended for use by children,
persons with reduced physical, sensory or mental capabilities or lack of experience and
knowledge.
- 4 -
User Manual
194UCB77A Bullet Ice 96 lbs.
- 5 -
User Manual
Schematic Diagram
Power Cord
Water Inlet Pipe
Water Filter
3/4" Joint
Inner Thread
1/2" Joint
External Thread
1/2" Joint
Inner Thread
Drain Pipe
Mounting hole for water filter
- 6 -
User Manual
Installation Steps
- 7 -
User Manual
Startup and Operation
- 8 -
User Manual
- 9 -
User Manual
- 10 -
User Manual
- 11 -
User Manual
- 12 -
User Manual
- 13 -
User Manual
Cleaning Process
Items you need
· Screwdriver or drill
· Scissors and zip ties
· Spray bottle
· Measuring cup
1. Turn off and unplug the machine from the power source.
2. Remove the screws holding on the roof of the machine in the back and remove to roof by sliding it backwards
and then up. Set aside.
3. Then, remove the 6 screw’s holding in the back plate and remove. Set aside.
4. Open the front door to the ice bin. Because the roof in now removed you will be able to slide the door up and
out of its tracks.
5. Remove the water curtain by lifting on the two plastic hooks holding it in place. Place the water curtain in the
soaking tub.
6. Then, reach into the water trough (opening left by the water curtain removal) and pull the spray rack up and
then out. Unlatch the water tube and remove the spay rack. Place the spray rack in the soaking tub.
7. Remove the four screws holding the connecting bar on the back end of the top of the unit and remove this bar.
· Soaking tub
· Scrubbing brushes
· Draining pump
- 14 -
User Manual
8. Then, remove the 5 screws holding the water pump on the back of the machine and remove the water pump.
Unlatch the water tube connected to the water pump and place the tube only in the soaking tub.
9. Mix a solution of cleaner and water according to your ice machine cleaner instructions. Pour this cleaner
solution over the items in the soaking tub until completely submerged.
10. Fill the spray bottle with the cleaning solution and spray the ice machine bin, water trough, and water pump
holder. Wipe down with a clean towel.
11. Scrub the items in the soaking tub with the cleaning solution using the brush. Disassemble the spray rack
and scrub all compartments and pieces with cleaning solution. Then reassemble the spray rack and replace
the included clamp.
12. Reinstall the spray rack into its original position with the water tube facing down. Reattach the water curtain.
- 15 -
User Manual
13. Reattach the water pumps tube and replace the included clamp to secure.
. Place the water pump into its original position and replace the 5 screws.
14. Plug in the machine and turn it on. Hold the Clean button until CLE shows on the screen. Pour your
cleaning solution into the water trough and then while CLE is blinking on the display, press the Clean Button
again to initiate the cleaning function. When finished drain the cleaning solution from the water trough.
15. Repeat this process using a solution of sanitizer and water according to your ice machine sanitizer
instructions. Drain the sanitizer solution and then dry off the ice bin.
16. Reinstall the door, back plate, and roof in that order. Turn on the ice machine and throw out the first
batch of ice to prevent residual cleaner or sanitizer.
17. Remove air filter and clean excess dust and dirt, reinstall air filter."
- 16 -
User Manual
Service Call
If the ice machine works abnormally, please confirm below before making a service call:
1. Check the water supply
• Whether there is water in the water trough;
• Whether the water pressure for the is 18.75 psi to 80 psi; the water temperature is
40-90°F;
• Whether the water valve is open;
• Whether there is no water leakage;
2. Check the power
• Whether the indicator on the display panel is ON;
• Whether the panel display does not display the OFF standby state;
• If the LED on the display panel is not ON, check whether the plug and socket are
normal, and whether the power supply switch is ON.
3. Check nameplate and serial number
• Check the nameplate located on the side or back of the ice machine and record the
model and series number of the ice machine.
Note: If the machine fails due to the users faults, such as failure to use and maintain a
water filter, no supply of water, electricity or environmental factors, rather than the fault of the ice
maker, the door-to-door service will be charged.
- 17 -
User Manual
- 18 -
User Manual
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18

Avantco 194UCB77A Undercounter Ice Machine Manuel utilisateur

Taper
Manuel utilisateur