Philips TAS4405N/00 Manuel utilisateur

Philips
Marque
Philips
Modèle
TAS4405N/00
Catégorie
Hauts-parleurs portatifs
Taper
Manuel utilisateur

Ce manuel convient également à

Register your p roduct and get support at
www.philips.com/support
User manual
4000 series
TAS4405
Wireless Speaker
1
EN
Contents
1 Important 2
Safety 2
2 Your wireless speaker 3
Introduction 3
What's in the box 3
Overview 3
3 Get started 4
Charge the built-in battery 4
Install batteries for the microphone 4
Install a micro-SD card 5
4 Power on/off 5
5 Use Bluetooth devices 6
6 Micro-SD card mode 7
7 Mix your sound with an audio source 7
Record 7
8 Product information 8
10 Notice 8
Compliance 8
Care of the environment 8
FCC Statement 9
Trademark notice 9
Contents
2 EN
1 Important
Safety
Warning
• Never remove the casing of this product.
• Never lubricate any part of this product.
• Never place this product on other
electrical equipment.
• Keep this product away from direct
sunlight, naked fames or heat.
• Read and follow these instructions.
• Make sure that there is enough space
around the product for ventilation.
•
personnel. Servicing is required when the
product has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen
into the product, the product has been
exposed to rain or mositure, does not
operate normally, or has been dropped.
•
by the manufacturer.
• Use only power supplies listed in this user
manual.
• Unplug this product during lightning stroms
or when unused for long periods of time.
• This product should not be exposed to
dripping or splashing.
• Do not place any sources of danger on the
candles).
• Where the plug of the Direct Plug-in
Adapter is used as the disconnect device,
the disconnect device shall remain readily
operable.
• Do not use this product near water.
• Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources wuch
as radiators, heat registers, stoves, or
produce heat.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
This device operates on a no-protection,
Ce dispositif fonctionne sur une base de non-
protection, sans interférence. Si l'utilisateur cherche à
obtenir la protection d'autres services de radio
opérant dans les mêmes bandes de télévision, une
licence de radio est requise. Pour plus de détails,
consultez le document de Innovation, Science et
Développement économique Canada Intitulé La
circulaire CPC-2-1-28 sur les procédures clients,
licence volontaire d'apparatus radio à faible puissance
exempté de licence dans les bandes de télévision.
no-interference basis. Should the user seek to
obtain protection from other radio services
operating in the same TV bands, a radio licence
is required. For further details, consult Innovation,
Science and Economic Development Canada’s
document Client Procedures Circular CPC-2-1-28,
Voluntary Licensing of Licence-Exempt Low-Power
Radio Apparatus in the TV Bands.
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
TAS4405/37-MIC
TAS4405/37-MIC
3
EN
2 Your wireless
speaker
Congratulations on your purchase, and
ZHOFRPHWR3KLOLSV7RIXOO\EHQHÀWIURPWKH
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With this speaker and microphone, you can
• enjoy audio from a Bluetooth device,
• enjoy audio from a micro-SD card,
• one touch recording to micro-SD card.
What's in the box
Please check and identify the contents of your
package:
• Wireless speaker
• Wireless microphone
• USB cable
• Quick start guide
• Safety sheet
Quick start guide
TAPR802
AAA x 2
*%
Overview
1
4
5
2
6
7
8
9
a
• Press and hold for 2 seconds to
power on or off.
b
• Press to start or stop the recording
of audio from both the wireless
microphone and the speaker.
c
• Press to select Bluetooth or micro-SD
card source.
d
/
• Press to adjust the volume.
e
• Press to play or pause.
• Press twice to skip to the next track.
f Micro-USB charging port
g Micro-SD card slot
h Battery compartment lid
i Microphone power switch
4 EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Charge the built-in battery
The speaker is powered by a built-in
rechargeable battery.
Note
•
Fully charge the built-in battery before using.
5V
1.5 A
Connect the USB cable between the micro-
USB socket on the speaker and a USB socket
on your computer or a charger.
LED indicator (Power)
Flashing red Being charged when
powered off
Solid red Fully charged when
powered off
Flashing red/green
alternatively
Being charged when
powered on
Solid green Fully charged when
powered on
Install batteries for the
microphone
1
Open the battery compartment lid.
2 Install 2 AAA alkaline batteries (not
provided) with the correct polarity.
3 Close the battery compartment lid.
AAA x 2
5
EN
Install a micro-SD card
1
Open the lid of the card slot.
2 Insert a micro-SD card (not provided) with
the pin side facing down till you hear a
click. Then close the lid of the card slot.
4 Power on/off
1 Press and hold for 2 seconds to power
on or off the speaker.
2 sec.
2 Slide up the power switch to power on the
microphone.
Mic up to 5 m wireless range
6 EN
5 Use Bluetooth
devices
With this speaker, you can enjoy audio from
your Bluetooth device.
Note
•
Make sure that the Bluetooth function is enabled on
your device.
• Keep away from any other electronic device that may
cause interference.
1 Press and hold for 2 seconds to enter
the Bluetooth pairing mode.
2 sec.
2 Select “Philips S4405” in the Bluetooth list
on your device.
» If a message prompts for permission
IRU%OXHWRRWKFRQQHFWLRQFRQÀUPLW
» If a password is required, enter 0000
DQGWKHQFRQÀUP
» The speaker beeps when successfully
connected.
Philips S4405
BEEP
10m
LED indicator (Bluetooth)
Flashing blue Bluetooth pairing
Solid blue Bluetooth connected
Note
•
To disconnect, disable the Bluetooth connection with
this product on your device or press
again to switch
to micro-SD card mode.
7
EN
6 Micro-SD card
mode
You can enjoy audio from a micro-SD card that
VWRUHVDXGLRÀOHV
Press
repeatedly to select the micro-SD
source. The Bluetooth LED indicator will be
turned off for micro-SD auto playback.
7 Mix your sound
with an audio
source
Note
•
Do not directly point the microphone to the speaker
to prevent microphone feedback.
By using the wireless microphone, you can mix
your sound with an audio source
Record
In the Bluetooth mode, press to start or stop
the recording.
LED indicator (REC)
Flashing red Error (no micro-SD card
inserted or the card is full)
Solid red Recording
8 EN
8 Product
information
Note
Product information is subject to change without prior
notice.
General information
Power supply:
5V
1.5A
Speaker driver 1.5”
Charging time
(Speaker)
2.5 hours
Playtime 6 hours
Built-in Lithium battery
(Speaker)
3.7V, 1500mAh
Dimensions (Speaker) 105 x 105 x 38 mm
Weight (Speaker) 250 g
Bluetooth
Bluetooth version V4.2
Bluetooth range 10 m / 32.1 ft
10 Notice
device that are not expressly approved by
MMD Hong Kong Holding Limited may void
the user’s authority to operate the product.
Compliance
Hereby, MMD Hong Kong Holding Limited
declares that this product is in compliance with
the essential requirements and other relevant
the Declaration of Conformity on
www. philips.com/support.
Care of the environment
Disposal of your old product and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU.
This symbol means that the product contains
batteries covered by European Directive
2013/56/EU which cannot be disposed of with
normal household waste.
Inform yourself about the the local separate
collection system for electrical and electronic
products and batteries. Follow local rules and
Mic wireless range max 5m
Mic
9
EN
never dispose of the product and batteries
with normal household waste. Correct disposal
of old products and batteries helps prevent
negative consequences for the environment and
human health.
Removing the disposal batteries
To remove the disposable batteries, see battery
install section.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
FCC Statement
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any
interference received, including interference that
may cause undesired operation.
Warning:
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
mea
sures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between
the equipment and receiver. (3) Connect the
equipment into an outlet on a circuit different
from that to which the receiver is connected. (4)
Consult the dealer or an experienced radio/TV
technician for help.
RF Warning Statement
The device has been evaluated to meet general
RF exposure requirements. The device can be
used in portable exposure conditions without
restriction.
Trademark notice
The Bluetooth ® word mark and logos are
registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by MMD
Hong Kong Holidng Limited is under license.
Other trademarks and trade names are those of
their respective owners.
For INSPIRATION only
6SHFLÀFDWLRQVDUHVXEMHFWWRFKDQJHZLWKRXWQRWLFH
3KLOLSVDQGWKH3KLOLSV6KLHOG(PEOHPDUHUHJLVWHUHGWUDGHPDUNVRI.RQLQNOLMNH3KLOLSV19DQGDUHXVHGXQGHUOLFHQVH
7KLVSURGXFWKDVEHHQPDQXIDFWXUHGE\DQGLVVROGXQGHUWKHUHVSRQVLELOLW\RI00'+RQJ.RQJ+ROGLQJ/LPLWHGRU
RQHRILWVDIÀOLDWHVDQG00'+RQJ.RQJ+ROGLQJ/LPLWHGLVWKHZDUUDQWRULQUHODWLRQWRWKLVSURGXFW
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

Philips TAS4405N/00 Manuel utilisateur

Philips
Marque
Philips
Modèle
TAS4405N/00
Catégorie
Hauts-parleurs portatifs
Taper
Manuel utilisateur
Ce manuel convient également à
Télécharger le PDF
rapport

dans d''autres langues

Documents connexes