VTech Press & Pull Racer Parents' Manual

Catégorie
Jouets
Taper
Parents' Manual
91-003771-000
CAUS
Press & Pull Racer
Parents Guide
TM
528400 IM .indd 1 09/06/2019 9:10:13
2
INTRODUCTION
Thank you for purchasing the Press & Pull Racer
!
This little bear loves to race! Press the bear or pull back on the race
car and release it to send the car zooming, encouraging toddlers to
chase after it. Songs, phrases and melodies teach colors, numbers
and vocabulary with flashing lights and buttons to press. On your mark,
get set, play!
Racing Flag
Color Buttons
Flashing Light
On/Off/Volume
Selector
Bear Racer Button
528400 IM .indd 2 09/06/2019 9:10:13
3
INCLUDED IN THIS PACKAGE
- One Press & Pull Racer
- One parent’s guide
WARNING:
All packing materials, such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE:
Please keep this parent’s guide as it contains important information.
ATTENTION :
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE :
Il est conseillé de conserver ce guide des parents car il comporte des
informations importantes.
Unlock the packaging locks:
Rotate the packaging locks counterclockwise
90 degrees.
Pull out the packaging locks and discard.
528400 IM .indd 3 09/06/2019 9:10:13
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the
bottom of the race car. Use a coin or
screwdriver to loosen the screw and
open the battery cover.
3. Remove old batteries by pulling up on
one side of each battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance.)
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance
• Useonlybatteriesofthesameorequivalenttypeasrecommended
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable, or new and used batteries
• Donotusedamagedbatteries
• Insertbatterieswiththecorrectpolarity
• Donotshort-circuitthebatteryterminals
• Removeexhaustedbatteriesfromthetoy
• Removebatteriesduringlongperiodsofnon-use
• Donotdisposeofbatteriesinfire
• Donotchargenon-rechargeablebatteries
Removerechargeablebatteriesfromthetoybeforecharging
(if removable)
Rechargeable batteries are onlyto be charged under adult
supervision
528400 IM .indd 4 09/06/2019 9:10:14
5
MISE EN GARDE
Utiliser des piles alcalines neuvespour des performances
maximales
• Seulesdespilesdutyperecommandédoiventêtreutilisées
• Ne pas mélanger différents types de piles ou d’accumulateurs,
nepasmélangerdespilesoudesaccumulateursneufsavecdes
usagés
• Nepasutiliserdespilesoudesaccumulateursendommagés
• Mettreenplacelespilesoulesaccumulateursenrespectantles
polarités+et–
• Nepasmettrelesbornesd’unepileoud’unaccumulateurencourt-
circuit(enreliantdirectementle+etle–)
• Enleverlespilesoulesaccumulateursusagésdujouet
• Retirer les piles ou les accumulateurs en cas de nonutilisation
prolongée
• Nelesjeterniaufeunidanslanature
• Nepastenterderechargerdespilesnonrechargeables
• Enleverlesaccumulateursdujouetpourlesrecharger
• Lesaccumulateursnedoiventêtrechargésquesouslasurveillance
d’unadulte
528400 IM .indd 5 09/06/2019 9:10:14
6
PRODUCT FEATURES
1. On/Off/Volume Selector
To turn the unit On, slide the On/Off/
Volume Selector to the Low or
High volume position. You will hear
a sound, phrase and a song. To turn
the unit Off, slide the On/Off Volume
Selector to the Off position.
2. Automatic Shut Off
To preserve battery life, the Press & Pull Racer™ will automatically
power down after approximately 30 seconds without input. The
unit can be turned on again by pressing any button.
Note:
If the unit repeatedly powers down while playing or the light fades out,
we suggest changing the batteries.
ACTIVITIES
1. Bear Racer Button
Press the Bear Racer Button to
propel the car forward. You will hear
a song, exciting phrases, sounds and
music. The light will flash with the
sounds.
Note:
For your child’s safety, do not press and release the race car on
clothing, skin or hair. Adult supervision is recommended.
528400 IM .indd 6 09/06/2019 9:10:14
7
2. Pull Back and Release
Pull the car back and release it to
launch the car forward and watch it
zoom across the oor.
Note:
The car moves best on smooth, at
surfaces.
3. Color Buttons
Press the Color Buttons on the side
of the car to learn about colors, racing
phrases, sounds and music. The light
will ash with the sounds.
4. Racing Flag
Turn the Racing Flag to hear it click.
MELODY LIST
1. Bear Went Over the Mountain
2. Here We Go 'Round the Mulberry Bush
3. Humpty Dumpty
4. Skip to My Lou
5. Oh! Susanna
6. Pop! Goes the Weasel
7. Looby Loo
8. Row, Row, Row Your Boat
528400 IM .indd 7 09/06/2019 9:10:15
8
9. Blow the Man Down
10. This Old Man
11. Big Rock Candy Mountain
12. Camptown Races
13. Aiken Drum
14. Glow Worm
15. Froggy Went a Courtin'
SING-ALONG SONG LYRICS
Song 1
Vroom, Vroom! Look at me!
Driving makes me so happy!
Pull me back, and let me go,
Racing is the life for me.
Song 2
1-2-3! I'm in rst place,
Driving fast, I know I'm going to win the race.
Song 3
I'm a little speed racer.
I like to feel the wind in my fur,
Zooming down the road in my speedy car.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
528400 IM .indd 8 09/06/2019 9:10:15
9
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off
2. Interrupt the power supply by removing the batteries
3. Let the unit stand for a few minutes, then replace the batteries
4. Turn the unit On. The unit should now be ready to use again
5. If the unit still does not work, install a new set of batteries
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S. or 1-877-352-8697 in
Canada, or by going to our website at vtechkids.com and lling
out our Contact Us form located under the Customer Support
link. Creating and developing VTech
®
products is accompanied
by a responsibility that we take very seriously. We make every
effort to ensure the accuracy of the information, which forms the
value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products
and encourage you to contact us with any problems and/or
suggestions that you might have. A service representative will
be happy to help you.
Caution:
Changes or modifications not expressly approved by the party
responsible for compliance could void the users authority to operate
the equipment.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
528400 IM .indd 9 09/06/2019 9:10:15
10
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
Supplier's Declaration of Conformity
Trade Name: VTech
®
Model: 5284
Product name: Press & Pull Racer
TM
Responsible Party: VTech Electronics North America, LLC
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)
528400 IM .indd 10 09/06/2019 9:10:15
Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
TM & © 2019 VTech Holdings Limited.
All rights reserved.
Printed in China.
91-003771-000
CAUS
Read our complete warranty policy online at
vtechkids.com/warranty
528400 IM .indd 11 09/06/2019 9:10:15
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

VTech Press & Pull Racer Parents' Manual

Catégorie
Jouets
Taper
Parents' Manual

dans d''autres langues