George Kovacs GKADP0005-467 Manuel utilisateur

Taper
Manuel utilisateur

Ce manuel convient également à

120V FLEXIBLE TRACK PENDENT ADAPTOR
Adapts direct wire or track pendants for use with 120V Flexible Track system.
For use with Minka EC series line flexible track. 60 Hz 120V/ Pour l'usage avec l'EC de Minka les séries rayent la voie flexible. 60 hertz 120V.
Installation Instructions
IMPORTANT: Before installing, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box./
IMPORTANT: Avant l'installation, déconnectez la puissance en arrêtant le disjoncteur ou en enlevant le fusible à la boîte de fusible.
Step1:
1. Open the adaptor cover by removing the set screw.
2. Loosen the three set screws on the lower portion of the wiring terminal.
3. Determine the desired location of the pendant.
4. When the desired length is established, mark the pendant wire.
5. Cut the wire at the mark.
NOTE: If installing more than one pendant and the same height is desired for all pendants make sure the mark on all pendants are at the
same length before cutting.
6. The pendant wire has three (3) smaller wires running inside of it. Remove 1 ½” of the outer insulation exposing the three (3) smaller
wires inside.
CAUTION: Be careful not to cut or damage the insulation on the inside wires when removing the outer insulation./ATTENTION: Faites
attention à ne pas couper ou ne pas endommager l'isolation sur les fils intérieurs en enlevant l'isolation externe.
STEP2:
1. Pull the pendant wire through the bottom hole in the pendant adapter, and then secure the strain relief to the pendant wire. (NOTE:
Do not fully tighten the strain relief set screw, but secure with only 2 or 3 rotations so that the pendant wire can still be moved as
needed.
2. Remove a 3/8 inch of the insulation on all three (3) of the smaller wires.
3. Twist the copper wire strands.
STEP 3:
1. Carefully identify and connect the 3 wires following the pendant wiring instructions included with the pendant.
NOTE: Please Read all instruction of the pendant head (sold separately), to identify polarity of the wires, then connect Live to Live, Neutral
to Neutral, Ground to Ground. If you have any doubt, please contact or consult a qualified electrician.
2. Tighten screws to secure the wire.
3. Slide the strain relief to a suitable position on the wire and tighten the screws.
4. Position the strain relief to its original position in the adaptor.
5. Close the adaptor cover, and tighten the set screw.
INSTALLING ADAPTER TO TRACK:
1. Make sure that the power is turned off.
2. Remove the retaining cap on the power connector.
3. Open the power connector cover and align the two slots of the track to the two tabs on the power connector.
4. Close the power connector cover and replace the retaining cap.
5. Restore the electrical power.
Power connector
Track (Sold Separately)
Retaining cap
Track pendant (Sold Separately)
Power connector cover
Adaptor
cover
Set screw
White wire
(neutral)
Black wire (live)
Wiring terminal
Strain relief
Screw
Pendant wire
1
3/8
Step 1
Step 2
Step3
Align the two slots of the
track to the two tabs on the
power connector.
  • Page 1 1

George Kovacs GKADP0005-467 Manuel utilisateur

Taper
Manuel utilisateur
Ce manuel convient également à

dans d''autres langues