Whirlpool AKR 904-1 IN Program Chart

Marque: Whirlpool

Modèle: AKR 904-1 IN

Catégorie: Hottes

Taper: Program Chart

Ce manuel convient également à

AKR 904 AL-1



5019 100 75164

AKR 904 IX-1

INSTALLATIONSANGABEN

Mindestabstand zur Kochfläche: 65 cm (Elektroplatten), 75 cm (Gas-, Öl-,

Kohlekochplatten). Folgen Sie bei der Installation der Nummerierung

.....). Das Auslassrohr (16) wird nicht mitgeliefert und muss gesondert

erworben werden. Das Gerät darf erst nach erfolgter Installation an die

Stromversorgung angeschlossen werden. Der Stecker der Dunstabzugshaube

muss mit einer normgerechten und gut zugänglichen Steckdose verbunden

werden. Wenn die Dunstabzugshaube nicht mit einem Stecker versehen ist

(direkter Netzanschluss), muss ein zweipoliger, normgerechter, gut zugänglicher

Schalter eingebaut werden, dessen Kontakte einen Abstand von mindestens

3mm aufweisen.

INSTALLATION SHEET

Minimum height above cooker: 65 cm (electric cookers), 75 cm (gas, gas oil or

coal cookers). To install follow points (1

.....). The exhaust pipe (16) is not

supplied, and should be bought separately. Do not connect the appliance to the

electrical power supply until installation is completed. The power plug of the

hood must be connected to a socket that complies with current regulations,

located in an easily accessible point. If the hood is not fitted with a plug (direct

connection to the power supply), fit a two-pole switch in compliance with

regulations, with minimum break distance between contacts of 3 mm (easily

accessible).

FICHE D'INSTALLATION

Distance minimale par rapport à la cuisinière : 65 cm (cuisinière électrique), 75 cm

(cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la numérotation

.....). Le tuyau d’évacuation (16) n’est pas fourni avec l’appareil et doit

être acheté à part. Ne branchez pas l’appareil tant que l'installation n’est pas

terminée. La fiche de la hotte doit être branchée dans une prise conforme aux

normes en vigueur placée dans un endroit accessible. Si la hotte est branchée

sans fiche (branchement direct sur le réseau), appliquez un interrupteur bipolaire

conforme aux normes ayant une ouverture minimale de 3 mm entre les contacts

(accessible).

INSTALLATIEKAART

Minimumafstand tot het kooktoestel: 65 cm (elektrische kooktoestellen), 75 cm

(kooktoestellen op gas, gasolie of kolen). Volg voor de montage de nummering

.....). De afvoerleiding (16) wordt niet bijgeleverd en dient aangeschaft

te worden. Geef het apparaat geen stroom totdat de installatie geheel voltooid is.

De stekker van de kap moet op een goed toegankelijk stopcontact aangesloten

worden dat aan de geldende veiligheidsvoorschriften voldoet. In het geval dat de

kap geen stekker heeft (directe aansluiting op het elektriciteitsnet) dient u een

tweepolige schakelaar te gebruiken met een afstand tussen de contacten van

minstens 3 mm (toegankelijk).

75164.fm5 Page 1 Monday, April 10, 2000 1:47 PM



5019 100 75164

AKR 904 IX-1

FICHA DE INSTALACIÓN

Distancia mínima de los quemadores: 65 cm (quemadores eléctricos), 75 cm

(quemadores a gas, gasóleo o carbón). Para el montaje, siga la numeración

.....). El tubo de descarga (16) no se suministra con la campana sino que

se debe comprar aparte. No enchufe el aparato hasta que su instalación no esté

terminada. La clavija eléctrica de la campana debe conectarse a un enchufe que

sea conforme a las normas vigentes y esté en un lugar accesible. Si la campana

está desprovista de clavija (conexión directa a la red), se deberá aplicar un

interruptor bipolar según las normas con una distancia de abertura entre los

contactos no inferior a 3 mm, que naturalmente deberá ser accesible.

FICHA DE INSTALAÇÃO

Distância mínima dos fogões: 65 cm. (fogões eléctricos), 75 cm. (fogões a gás,

óleo ou carbono). Para montar siga a numeração (1

.....). O tubo de

descarga (16) não é fornecido com o aparelho pelo que deve ser adquirido. Não

ligue o aparelho à corrente eléctrica até a instalação estar concluída. A ficha

eléctrica do exaustor deve estar ligada a uma tomada em conformidade com as

normas em vigor, e colocada num sítio acessível. Se o exaustor não estiver

equipado com uma ficha (ligação directa com a rede eléctrica) aplique um

interruptor bipolar segundo as normas com uma distância dos contactos à

abertura não inferior a 3 mm (acessível).

SCHEDA INSTALLAZIONE

Distanza minima dai fuochi: 65 cm (fuochi elettrici), 75 cm (fuochi a gas, gasolio

o carbone). Per il montaggio seguire la numerazione (1

.....), il tubo di

scarico (16) non è fornito e va acquistato. Non dare corrente all’apparecchio

finché l’installazione non è totalmente completata. La spina ellettrica della cappa

deve essere allacciata ad una presa conforme alle norme vigenti posta in zona

accessibile. Se la cappa è sprovvista di spina (collegamento diretto alla rete)

applicare un interruttore bipolare a norme con una distanza dei contatti in

apertura non inferiore a 3 mm (accessibile).

ùüùü+ùùùþ

ü$12.)12.1.)2"0120"FP02!"0120"FP0120"

.0! #02!0. #0! #.+.22  21.  #1202

.!1





1&."..&"/0/.202.02 

. !! 32!..!0.. 20$&!122! 3 / 20200

02!)!0*.21#10#!2  !&12"0.212.1" 

02!)3"2 #. !! 32!.!0.1#/0010!.102 #

1$* 2 ". 1 *2  0210! 101 10 ü 

. !! 32!."/0/.203". 0 #0."1*/0102 /2# 2  02120

./ )/.)2102&. 1+00$12  .02.*2&

0.3+PP10! 101 10 

75164.fm5 Page 2 Monday, April 10, 2000 1:47 PM



5019 100 75164

AKR 904 IX-1

Deflektor, nur bei Gebrauch der Haube in der

Umluftversion installieren

Deflector for filter version only

Déflecteur à installer uniquement pour la version filtrante

De deflector hoeft alleen te worden geïnstalleerd bij de

versie met een filter

Deflector sólo para versión filtrante

Deflector para instalar apenas na Versão filtrante

Deflettore da installare solo per uso in Versione filtrante

ü2! ." #0.12.2.) .$!10 2 

0..*&1

75164.fm5 Page 3 Monday, April 10, 2000 1:47 PM



5019 100 75164

AKR 904 IX-1

1. Control panel.

2. Grease filters.

3. Grease filter handles.

4. Halogen bulb.

5. Telescopic flue.

Cleaning the grease filter

Wash the grease filter once a month, or

whenever the grease filter saturation indicator

flashes (Extraction speed indicator 2).

1. Unplug the appliance or disconnect the mains

power supply.

2. Remove the grease filters (Fig. 1 - a,b,c).

3. After cleaning the grease filter, remount in

reverse order ensuring the entire extraction

surface is covered.

Replacing bulbs

1. Unplug the appliance or disconnect the mains

power supply.

2. Unscrew the lighting unit (Fig. 2 - d).

3. Remove the burnt-out bulb (Fig. 2 - e).

Replace with 20W max.halogen bulbs only.

4. Screw the lighting unit back in place

Fitting or renewing the carbon filter:

1. Unplug the appliance or disconnect the mains

power supply.

2. Remove the grease filters (Fig. 1 - a,b,c).

3. Fit the carbon filter by fixing it with the two

screws supplied (Fig. 3 - f).

4. If the carbon filter needs renewing, remove

the old filter and fit a new one.

Change the carbon filter once a year and, in

any event, every time the carbon filter

saturation indicator flashes (Extraction speed

indicator 3).

5. Refit the grease filters.

THE CONTROL PANEL

1. Extraction OFF button.

2. Extraction ON speed increase button

- 1

1......

3. Extraction speed indicator 1.

4. Extraction speed indicator 2 and grease filter

saturation indicator (when flashing).

5. Extraction speed indicator 3 and carbon filter

saturation indicator (when flashing):

this

function is normally deactivated. In order to

activate it press button 1, then buttons 2 and

7 at the same time, until the carbon filter

saturation indicator starts flashing. To

deactivate the function repeat the operation

until the carbon filter saturation indicator

stops flashing.

6. Intensive extraction speed indicator.

7. Timed intensive speed button: the hood

operates at this speed for 5 minutes and then

returns to the previous settings.

This function can be cancelled by pressing

button 1 or 2.

8. Light OFF button.

9. Light ON button.

Reset filter indicator: Press the button OFF

until LED 2 and/or LED 3 stop flashing.

FIG. 1

FIG. 2

FIG. 3

F NL E PGBD IGR

PRODUCT SHEET

75164.fm5 Page 6 Monday, April 10, 2000 1:47 PM

Whirlpool AKR 904-1 IN Program Chart

Marque: Whirlpool

Modèle: AKR 904-1 IN

Catégorie: Hottes

Taper: Program Chart

Ce manuel convient également à

AKR 904 AL-1

Télécharger le PDF

rapport

Whirlpool AKR 904-1 IN Program Chart

Ce manuel convient également à

Whirlpool AKR 904-1 IN Program Chart

dans d''autres langues

Documents connexes

Autres documents