Dell PowerVault NX3000 Guide de démarrage rapide

Dell™ PowerVault™

NX3000 Systems

Getting Started

With Your System

Guide de mise en route

Introdução ao uso do sistema

Procedimientos iniciales con el sistema

www.dell.com | support.dell.com

Dell™ PowerVault™

NX3000 Systems

Getting Started

With Your System

Notes, Cautions, and Warnings

NOTE: A NOTE indicates important information that helps you make better use

of your computer.

CAUTION: A CAUTION indicates potential damage to hardware or loss of data if

instructions are not followed.

WARNING: A WARNING indicates a potential for property damage,

personal injury, or death.

____________________

Information in this document is subject to change without notice.

Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc.

is strictly forbidden.

Dell, the DELL logo, and PowerVault are trademarks of Dell Inc.; Intel and Xeon are registered

trademarks of Intel Corporation in the U.S. and other countries; Microsoft and Windows are either

trademarks or registered trademarks of Microsoft Corporation in the United States and/or other

countries.

Other trademarks and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and

trade names other than its own.

Model E02S

Regulatory Type E02S001

April 2009 P/N G225N Rev. A00

Getting Started With Your System 3

Installation and Configuration

WARNING: Before performing the following procedure, review the safety

instructions that came with the system.

Unpacking the System

Unpack your system and identify each item.

Installing the Rails and System in a Rack

Assemble the rails and install the system in the rack following the safety

instructions and the rack installation instructions provided with your system.

4 Getting Started With Your System

Optional – Connecting the Keyboard, Mouse, and Monitor

Connect the keyboard, mouse, and monitor (optional).

The connectors on the back of your system have icons indicating which cable

to plug into each connector. Be sure to tighten the screws (if any) on the

monitor's cable connector.

Connecting the Power Cable(s)

Connect the system’s power cable(s) to the system and, if a monitor is used,

connect the monitor’s power cable to the monitor.

Getting Started With Your System 5

Securing the Power Cable(s)

Bend the system power cable(s) into a loop as shown in the illustration and

secure the cable(s) to the bracket using the provided strap.

Plug the other end of the power cable(s) into a grounded electrical outlet or

a separate power source such as an uninterruptible power supply (UPS) or

a power distribution unit (PDU).

Turning On the System

Press the power button on the system and on the optional monitor, if used.

The power indicators should light.

6 Getting Started With Your System

Installing the Optional Bezel

Install the bezel (optional).

Supported Operating System

Your system is preinstalled with Microsoft

®

Windows

®

Storage Server 2008

Standard x64 Edition.

NOTE: For the latest information on supported operating systems, see www.d ell.com

Other Information You May Need

WARNING: See the safety and regulatory information that shipped with

your system. Warranty information may be included within this document or

as a separate document.

• The rack documentation included with your rack solution describes how to

install your system into a rack.

•The

Hardware Owner’s Manual

provides information about system features

and describes how to troubleshoot the system and install or replace system

components. This document is available online at

support.dell.com.

• Any media that ships with your system that provides documentation and

tools for configuring and managing your system, including those pertaining

to the operating system, system management software, system updates, and

system components that you purchased with your system.

NOTE: Always check for updates on support.dell.com and read the updates

first because they often supersede information in other documents.

Getting Started With Your System 7

Obtaining Technical Assistance

If you do not understand a procedure in this guide or if the system does not

perform as expected, see your Hardware Owner’s Manual. Dell

™

offers

comprehensive hardware training and certification. See www.dell.com/training

for more information. This service may not be offered in all locations.

NOM Information (Mexico Only)

The following information is provided on the device described in this

document in compliance with the requirements of the official Mexican

standards (NOM):

Importer:

Model number: E02S

Supply voltage: 100–240 VAC

Frequency: 50/60 Hz

Current consumption: 7.0–3.5A

8 Getting Started With Your System

Technical Specifications

Processor

Processor type One or two quad-core Intel

®

Xeon

®

Processor 5500

series

Expansion Bus

Bus type PCI Express Generation 2

Expansion slots via riser card:

Riser 1 (Center Riser)

One full-height, 9.5-inch length, x4 link (slot 1)

NOTE: This slot can be upgraded to 12.2 inches.

One low-profile, 9.5-inch length, x4 link (slot 2)

Riser 2 (Left Riser)

Two full-height, 9.5-inch length, x8 link (slot 3 and 4)

or

One full-height, 9.5-inch length, x16 link (slot 3)

NOTE: Support for up to 25W is available only on the first

two cards installed in the system; any additional cards

installed in the system must be 15W or under.

Memory

Architecture 800, 1066, or 1333 MHz DDR3 registered or unbuffered

Error Correcting Code (ECC) DIMMs. Support for

Advanced ECC or Memory Optimized operation.

Memory module

sockets

Eighteen 240-pin

Memory module

capacities

1 GB or 2 GB UDIMMs and 2 GB, 4 GB,

or 8 GB RDIMMs

(single, dual, or quad-rank dependent on capacity)

Minimum RAM 1 GB with a single processor (1 DIMM per processor)

Maximum RAM 96 GB (with quad-rank 8 GB RDIMM), 144 GB

(with dual-rank 8 GB RDIMM), or 24 GB (with 2 GB

UDIMMs)

Getting Started With Your System 9

Drives

Hard drives Up to six 3.5-inch, internal, hot-swappable SAS or

SATA hard drives without optional internal tape

drive support

Diskette Drive Optional external USB 1.44-MB drive

Optical drive One optional internal slimline SATA DVD-ROM or

DVD+RW drive

Optional external USB DVD

NOTE: DVD devices are data only

Flash Drive Optional internal Secure Digital (SD) memory card

Optional external SD memory card

Connectors

Back

NIC

Four RJ-45 10/100/1000 Mbps Ethernet

Serial

9-pin, DTE, 16550-compatible

USB

Two 4-pin, USB 2.0-compliant

Video

15-pin VGA

Optional external

VFlash card

One flash memory card slot on the back panel

Front

Video

15-pin VGA

USB

Two 4-pin, USB 2.0-compliant

Internal

USB

One 4-pin, USB 2.0-compliant

Optional internal

SD module

One internal flash memory card slot

Video

Video type Integrated Matrox G200

Video memory 8 MB shared

10 Getting Started With Your System

Power

AC Power Supply (per power supply)

Wa tt ag e

870 W (High Output)

570 W /200840 KB (Energy Smart)

Voltage

90–264 VAC, autoranging, 47-63 Hz

Heat dissipation

2968.6 BTU/hr maximum (High Output)

1944.9 BTU/hr maximum (Energy Smart)

Maximum inrush

current

Under typical line conditions and over the entire system

ambient operating range, the inrush current may

reach 55 A per power supply for 10 ms or less.

Batteries

System battery

CR 2032 3.0-V lithium coin cell

RAID battery

(optional)

3.7-V lithium ion battery pack

Physical

Height 8.64 cm (3.4 in)

Width 48.24 cm (18.99 in) with rack latches

44.31 cm (17.4 in) without rack latches

Depth 72.06 cm(28.4 in) with power supplies and bezel

68.07 cm(26.8) without power supplies and bezel

Weight (maximum

configuration)

26.1 kg (57.54 lb)

Weight (empty) 17.7 kg (39 lb)

Getting Started With Your System 11

Environmental

NOTE: For additional information about environmental measurements for specific

system configurations, see www.dell.com/environmental_datasheets

Temperature

Operating

10° to 35°C (50° to 95°F) with a maximum temperature

gradation of 10°C per hour

NOTE: For altitudes above 2950 feet, the maximum operating

temperature is derated 1°F/550 ft.

Storage

–40° to 65°C (–40° to 149°F) with a maximum temperature

gradation of 20°C per hour

Relative humidity

Operating

20% to 80% (non-condensing) with a maximum humidity

gradation of 10% per hour

Storage

5% to 95% (non-condensing) with a maximum humidity

gradation of 10% per hour

Maximum vibration

Operating

0.26 Gms from 5–350 Hz for 5 minutes in operational

orientations

Storage

1.54 Gms from 10–250 Hz for 10 minutes in all orientations

Maximum shock

Operating

Half sine shock in all operational orientations of 31 G plus

or minus 5% with a pulse duration of 2.6 ms plus or minus

10%

Storage

Half sine shock on all six sides of 71 G plus or minus 5%

with a pulse duration of 2 ms plus or minus 10%

Square wave shock on all six sides of 27 G with a velocity

change at 235 in/sec or greater

Altitude

Operating

–16 to 3048 m (–50 to 10,000 ft)

NOTE: For altitudes above 2950 feet, the maximum operating

temperature is derated 1°F/550 ft.

Storage

–16 to 10,600 m (–50 to 35,000 ft)

12 Getting Started With Your System

www.dell.com | support.dell.com

Systèmes Dell™

PowerVault™ NX3000

Guide de mise

en route

Remarques, précautions et avertissements

REMARQUE : une REMARQUE indique des informations importantes qui peuvent

vous aider à mieux utiliser votre ordinateur.

PRÉCAUTION : une PRÉCAUTION indique un risque de dommage matériel ou de

perte de données en cas de non respect des instructions.

AVERTISSEMENT : un AVERTISSEMENT vous avertit d’un risque

d'endommagement du matériel, de blessure corporelle ou de mort.

____________________

Les informations contenues dans ce document sont sujettes à modification sans préavis.

La reproduction de ce documents, de quelque manière que ce soit, sans l'autorisation écrite de Dell Inc.

est strictement interdite.

Dell, le logo DELL et PowerVault sont des marques de Dell Inc. ; Intel et Xeon sont des marques

déposées d'Intel Corporation aux États-Unis. et dans d'autres pays ; Microsoft et Windows sont des

marques ou des marques déposées de Microsoft Corporation aux États-Unis et/ou dans d'autres pays.

D'autres marques et noms de marque peuvent être utilisés dans ce document pour faire référence aux

entités se réclamant de ces marques et de ces noms ou de leurs produits. Dell Inc. dénie tout intérêt

propriétaire vis-à-vis des marques commerciales et des noms de marque autres que les siens.

Modèle E02S

Type réglementaire E02S001

Avril 2009 N/P G225N Rév. A00

Guide de mise en route 15

Installation et configuration

AVERTISSEMENT : avant de commencer, consultez les consignes de sécurité

fournies avec le système.

Déballage du système

Sortez le système de son emballage et identifiez chaque élément.

Installation des rails et du système dans un rack

Assemblez les rails et installez le système dans le rack en suivant les consignes

de sécurité et les instructions d'installation du rack fournies avec votre

système.

16 Guide de mise en route

Facultatif – Connexion du clavier, de la souris et du moniteur

Connectez le clavier, la souris et le moniteur (si nécessaire).

Les icônes des connecteurs situés à l'arrière du système indiquent où insérer

chaque câble. N'oubliez pas de serrer les vis situées sur le connecteur du câble

du moniteur, s'il en est équipé.

Branchement du ou des câbles d'alimentation

Branchez le ou les câbles d'alimentation au système et, si vous utilisez un

moniteur, connectez son câble d'alimentation à celui-ci.

Guide de mise en route 17

Fixation du ou des câbles d'alimentation

Repliez le câble et faites-le passer dans le clip comme la figure le montre, puis

fixez-le à l'aide de la sangle fournie.

Branchez ensuite l'autre extrémité du ou des câbles sur une prise de courant

mise à la terre ou sur une source d'alimentation autonome (onduleur ou unité

de distribution de l'alimentation [PDU]).

Mise sous tension du système

Appuyez sur le bouton d'alimentation du système et du moniteur en option,

si vous l'utilisez. Les voyants d'alimentation s'allument.

18 Guide de mise en route

Installation du cadre en option

Installez le cadre (facultatif).

Système d'exploitation pris en charge

Microsoft

®

Windows

®

Storage Server 2008 Édition Standard x64 est

préinstallé sur votre système.

REMARQUE : pour obtenir les informations les plus récentes sur les systèmes

d'exploitation pris en charge, rendez-vous sur le site www .dell.com.

Autres informations utiles

AVERTISSEMENT : consultez les informations sur la sécurité et les

réglementations fournies avec votre système. Les informations sur la garantie se

trouvent soit dans ce document, soit à part.

• La documentation fournie avec le rack indique comment installer le

système dans un rack.

• Le document

Hardware Owner's Manual

(Manuel du propriétaire) présente

les caractéristiques du système et contient des informations de dépannage et

des instructions d'installation ou de remplacement des composants. Il est

disponible en ligne sur le site

support.dell.com

.

La page charge ...

Dell PowerVault NX3000 Guide de démarrage rapide

Dell PowerVault NX3000 Guide de démarrage rapide

dans d''autres langues

Documents connexes