Yamaha SKEA7D-06 Mode d'emploi

SKEA7D-06
Yamaha
Marque
Yamaha
Modèle
SKEA7D-06
Taper
Mode d'emploi
【 Confidential 】
SKEA7D-06
Brand : YAMAHA
1.Smart Keyless functions
The Smart Keyless functions (Keyless entry system) enables the following operations while the
Hand Unit is being carried.
・When the operator pushes the Start Button, the system is activated and the engine start
propriety (permission / prohibition) is determined.
・The engine start is permitted if the operator is only within operational range while the Hand
Unit is being carried.
・The operational range for the engine start permission is up to 80 cm (2.6 feet) from the center
of the Start Button in the control panel.
1) Engine start permission
(1) In the case of permission
LED on the control panel turns on for about two seconds.
(2) In the case of permission
LED on the control panel turn off after flashing.
2) The System stop
The System will run out when pushing the Start Button.
LED on the control panel turned off.
2. Remote answer-back function
1) In the engine stop state, the Remote function can blink the hazard lamp by pushing a button
on the Hand Unit.
3. Child Lock mode of the Hand Unit
1) When you continue pushing the button on the Hand Unit (1 second or more), it will be the
Child Lock mode.
When it comes to tte Child Lock mode, LED of the Hand Unit is turned on 0.5 seconds.
In the Child Lock mode, the function of the 1 and 2 above can not operate.
2) To cancel the Child Lock mode, you must push the button of the Hand Unit (1 second or
more) again.
When the Child Lock mode is released, LED of the Hand Unit is turned on 0.1 seconds.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
FCC/ISED
This device complies with part 15 of FCC Rules and Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low levels
of RF energy.
User's Mmanual_SKEA7D-06 & -02.xlsx
  • Page 1 1

Yamaha SKEA7D-06 Mode d'emploi

SKEA7D-06
Yamaha
Marque
Yamaha
Modèle
SKEA7D-06
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Autres documents