Midmark 625 Barrier-Free® Examination Table Mode d'emploi

Marque: Midmark

Modèle: 625 Barrier-Free® Examination Table

Catégorie: Garantie

Taper: Mode d'emploi

FCC Compliance Statement

This equipment has been tested and found to comply

with the limits for a Class A digital device, pursuant to

part 15 of the FCC rules. These limits are designed to

provide reasonable protection against harmful interfer-

ence when the equipment is operated in a commercial

environment. This equipment generates, uses, and

can radiate radio frequency energy and, if not installed

and used in accordance with the instruction manual,

may cause harmful interference to radio communica-

tions. Operation of this equipment in a residential area

is likely to cause harmful interference in which case

the user will be required to correct the interference at

their own expense.

Any modications to this product may violate the rules

of the Federal Communications Commission and

make operation of the product unlawful.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.

User’s Guide

625 Wireless Controls

9A429

This guide outlines basic operation of the

wireless hand / foot control and the associated

base station. If service is required, contact your

authorized Midmark dealer.

Dealer (name / phone):

__________________________________

Date of Purchase: __________________

Midmark Corporation

60 Vista Drive

Versailles, OH 45380-0286

Phone: 937-526-3662

Fax: 937-526-5542

www.midmark.com

General Information

003-1945-00 Rev. AA2 (4/24/18)

Compliance Information

Intended Use

This product is intended to control patient positioning

while providing better patient access by eliminating the

cord from the controller(s).

Calling for Service

If service is required, contact your Midmark dealer.

To contact Midmark directly:

1-800-MIDMARK (1-800-643-6275)

Monday-Friday 8:00 am until 5:00 pm (EST)

www.midmark.com

Warranty

SCOPE OF WARRANTY Midmark Corporation (“Midmark”) warrants

to the original retail purchaser that it will, at Midmark’s option, repair or

replace components of the domestic and international medical products

manufactured by Midmark (except for components not warranted under

“Exclusions”) that are defective in material or workmanship under normal

use and service. The sole remedy under this limited warranty is the repair

or replacement, at Midmark’s option, of the applicable components. This

limited warranty shall only apply to defects that are reported to Midmark

within the applicable warranty period and which are determined to exist

upon examination by Midmark,. This warranty extends only to the original

retail purchaser of a product and is not transferable or assignable. Replace-

ment components or products may be used and/or refurbished components

or products, provided they are of like quality and specications as new

components or products.

Midmark warrants to the original retail purchaser that during the appli-

cable warranty period it will repair or replace software contained within the

products manufactured by Midmark (except for those not warranted under

“Exclusions”) if: (1) the media on which the software is furnished exhibits

defects in material or workmanship under normal use; or (2) the software

does not substantially conform to its published specications.

APPLICABLE WARRANTY PERIOD The applicable warranty period, mea-

sured from the date of invoice to the original retail purchaser of the product

and shall be one (1) year for all warranted products and components.

OBTAINING WARRANTY SERVICE Warranty service must be obtained

through either Midmark or an authorized dealer in the Midmark product

line for which warranty service is requested. Midmark may be contacted

for warranty service inquiries or issues via email at www.midmark.com;

by phone at 1-800-MIDMARK or by mail to Midmark Corporation, 60 Vista

Drive, Versailles, Ohio 45380. It is the retail purchaser’s obligation to ar-

range for delivery of a product to Midmark or one of its authorized dealers

for warranty service, which delivery shall be at retail purchaser’s expense.

It is also the retail purchaser’s obligation to comply with the warranty ser-

vice instructions provided either by Midmark or its authorized dealer. The

retail purchaser must provide Midmark with completed warranty registration

information within thirty (30) days after purchase in order to obtain the

benets of this limited warranty.

EXCLUSIONS: This limited warranty does not cover and Midmark shall not

be liable for the following:

(1) Defects, damage or other conditions caused, in whole or in part, by

misuse, abuse, negligence, alteration, accident, freight damage, negligent

storage, tampering or failure to seek and obtain repair or replacement in a

timely manner;

(2) Products which are not installed, used, and properly cleaned and

maintained as required or recommended in the Midmark “Installation” and/

or “Installation/Operation Manual” for the applicable product, including the

specied structural and operational environmental conditions and electrical

requirements;

(3) Products considered to be of a consumable or sterile nature;

(4) Accessories or parts not manufactured by Midmark;

(5) Charges by anyone for adjustments, repairs, replacement parts, instal-

lation or other work performed upon or in connection with such products

which are not expressly authorized in writing in advance by Midmark;

(6) Costs and expenses of routine maintenance and cleaning; and

(7) Representations and warranties made by any person or entity other

than Midmark.

(8) Matching of color, grain or texture except to commercially acceptable

standards;

(9) Changes in color caused by natural or articial light;

(10) Custom manufactured products;

(11) Alterations or modications to the product by any person or entity other

than Midmark; and

(12) Products that would otherwise by covered under this limited warranty,

but are acquired: (i) from a person or entity that is not Midmark or one of its

authorized dealers; or (ii) from a Midmark dealer that is not authorized to

sell the product at issue in the geographic territory where the purchaser is

located, or is not authorized to sell the product at issue within the medical

market.

SOFTWARE; WITH RESPECT TO SOFTWARE THAT IS A PRODUCT OR

COMPONENT THEREOF, MIDMARK DOES NOT WARRANT THAT THE

SOFTWARE: (1) IS ERROR FREE; (2) CAN BE USED WITHOUT PROB-

LEMS OR INTERRUPTIONS; OR (3) IS FREE FROM VULNERABILITY

TO INTRUSION OR ATTACK BY VIRUSES OR OTHER METHODS.

EXCLUSIVE REMEDY; CONSEQUENTIAL DAMAGES DISCLAIMER

MIDMARK’S ONLY OBLIGATION UNDER THIS LIMITED WARRANTY IS

THE REPAIR OR REPLACEMENT OF DEFECTIVE PARTS. MIDMARK

SHALL NOT BE LIABLE FOR AND HEREBY DISCLAIMS ANY DIRECT,

SPECIAL, INDIRECT, INCIDENTAL, EXEMPLARY OR CONSEQUENTIAL

DAMAGES OR DELAYS, INCLUDING, BUT NOT LIMITED TO, DAMAGES

FOR LOSS OF PROFITS OR INCOME, LOSS OF USE, LOSS OF DATA,

DOWNTIME, COVER AND EMPLOYEE OR INDEPENDENT CONTRAC-

TOR WAGES, PAYMENTS AND BENEFITS. THIS DISCLAIMER SHALL

SURVIVE ANY FAILURE OR ASSERTED FAILURE OF THE ESSEN-

TIAL PURPOSE OF THIS LIMITED WARRANTY OR ITS REMEDIES

SPECIFIED HEREIN. WARRANTY DISCLAIMER THIS WARRANTY IS

MIDMARK’S ONLY WARRANTY AND IS IN LIEU OF ALL OTHER WAR-

RANTIES, EXPRESS OR IMPLIED. MIDMARK MAKES NO IMPLIED

WARRANTIES OF ANY KIND INCLUDING ANY IMPLIED WARRANTIES

OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT OF

DEFECTIVE PARTS.

STATUTE OF LIMITATIONS No action may be brought against Midmark for

breach of this limited warranty, an implied warranty, if any, or for any other

claim arising out of or relating to the products, more than ninety (90) days

following expiration of the limited warranty period.

NO AUTHORIZATION No person or rm is authorized to create or approve

for Midmark any other obligation or liability in connection with the products.

Style D

Specifications

Range of Operation ............. 20 ft. (6 m) radius

Batteries:

Hand Control ................................. AA (qty. 2)

Foot Control ..................................AA (qty. 2)

Troubleshooting

When any control button is pressed, that controller

sounds a single “beep”. (All functions operate)

Cause: Low battery

Solution: Replace batteries

When any control button is pressed,

nothing happens. (No “beeps”, no movement, etc.)

Cause: 1. Batteries completely dead

2. Wireless controller has lost

“association” to chair

Solution: 1. Replace batteries

2. Perform Association Procedure*

The wireless controllers will only function with the

chair they have been “associated” with. This prevents

unwanted movement in locations with more than one

chair.

If further service is required,

contact your authorized Midmark dealer.

Association Procedure

The wireless controller will only function with the chair it has been “associated” with.

This prevents unwanted movement in locations with more than one chair.

Each wireless controller’s association is preset at the factory. This procedure is only

required in the event of a malfunction, if a new controller is purchased, or if you are

attempting to use the controller with a chair other than the one it was originally

associated with.

Association Procedure:

A) Disconnect power to the table for at least 3 seconds.

B*) Reconnect power, wait for the power up beep sequence from

the table, then press & hold the Stop & Home buttons on the

wireless controller until you hear three “beeps”.

* Note: Step B must be performed within 10 seconds of the power up beep

sequence from the table.

C) Check for proper operation of wireless controller.

D) If associating a hand and foot control, repeat procedure using

the other wireless controller.

Stop

Home

MA771100i

Home

Compliance Information - continued...

IC Compliance Statement

Interference

“This device complies with Industry Canada license-exempt RSS standard(s). Operation

is subject to the following two conditions: (1) this device may not cause interference,

and (2) this device must accept any interference, including interference that may cause

undesired operation of the device.”

“Le présent appareil est conforme aux CNR ďIndustrie Canada applicables aux

appareils radio exempts de licence. Ľexploitation est autorisée aux deux conditions

suivantes: (1) ľappareil ne doit pas produire de brouillage, et (2) ľutilisateur de

ľappareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible ďen compromettre le fonctionnement.”

Antennas

“Under Industry Canada regulations, this radio transmitter may only operate using an

antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry

Canada. To reduce potential radio interference to other users, the antenna type and its

gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not

more than that necessary for successful communication.”

“Conformément à la réglementation ďIndustrie Canada, le présent émetteur radio peut

fonctionner avec une antenne ďun type et ďun gain maximal (ou inférieur) approuvé

pour ľémetteur par Industrie Canada. Dans le but de réduire les risques de brouillage

radioélectrique à ľintention des autres utilisateurs, il faut choisir le type ďantenne et son

gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas

ľintensité nécessaire à ľétablissement ďune communication satisfaisante.”

Stop

Midmark 625 Barrier-Free® Examination Table Mode d'emploi

Marque: Midmark

Modèle: 625 Barrier-Free® Examination Table

Catégorie: Garantie

Taper: Mode d'emploi

Télécharger le PDF

rapport

dans d''autres langues

English: Midmark 625 Barrier-Free® Examination Table User guide

Midmark 625 Barrier-Free® Examination Table Mode d'emploi

Midmark 625 Barrier-Free® Examination Table Mode d'emploi

dans d''autres langues

Documents connexes