iHome iCVBT20 Mode d'emploi

Taper
Mode d'emploi
Model: iCVBT20 QSG - US English
size: 408mm(W) x 150mm(H)
Folded Size: 102 x 150 mm
Mat’l: 85gsm, WF paper, 1C + 1C
Color: Black text on white background
Oct. 22, 20.
231
Quick Start Guide
iCVBT20
• Press the Light Button to select a brightness level:
Hi, Mid, or Low.
Note: When not connected to the charger, the mirror light
runs on a timer that will automatically power o after 60
minutes.
Audio Function
Charging the Mirror
Connect the included USB charging cable to the micro
USB Charging Port on the back of the unit, and the
standard end to a powered USB port.
Light Function
Press and hold the Light Button to turn the light ON or
OFF. (Lights are independent from Power ON/OFF.)
USB AC
adaptor
(not included)
USB charging
cable
(included)
Status LED
Red = Charging Status
Blue = Pairing Status
Bluetooth
Pairing
Button
USB
Charging
Port
Reset
Button
Power
ON/OFF
Volume
Down
Play/Pause
Volume
Up
Light
Button
PORTABLE
iHome Beauty
FCC Information
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment.
This device complies with Part 15 of the FCC Rules, operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
ISED Information
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
The device comply with ISED RF exposure requirement, users can obtain
Canadian information on RF exposure and compliance.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Cet équipement est conforme aux limites d'exposition aux radiations IC
CNR-102 établies pour un environnement non contrôlé.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
L'appareil est conforme aux exigences d'exposition RF ISED, les utilisateurs
peuvent obtenir des informations canadiennes sur l'exposition aux RF et la conformité.
Tout changement ou modification non expressément approuvé par la partie
responsable de la conformité peut annuler l'autorité de l'utilisateur à utiliser
l'équipement.
CAN ICES-3(B) / NMB-3(B) 654
Adjusting the Mirror
The door on the back of the unit also works as a kickstand
for the mirror.
Reset
In the event of interrupted operation, use the extended
wire of a paper clip or other thin tool to push in the Reset
Button on the back of the unit.
Maintenance
This unit comes with a cleaning cloth to keep the mirror
smudge free. (If more cleaning is needed, unplug the unit
and wipe down with a slightly damp cloth.)
WARNING/DISPOSAL OF UNIT
Do NOT attempt to change the battery. Doing so will void the warranty and could cause
injury and damage to your device. To dispose of the unit, follow the instructions below:
Never dispose of used batteries/electronics with ordinary solid wastes, since they may
contain toxic substances.
• Always dispose of used batteries/electronics in accordance with the prevailing community
regulations.
• Many electronics retailers now recycle batteries and other electronic components at no
charge. To find a drop-o location near you, visit www.call2recycle.com
GENERAL BATTERY PRECAUTIONS
• Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any
way abnormal.
• Never disassemble the unit or attempt to remove battery as that could cause leakage of
alkaline solution or other electrolytic substances.
Avoid charging a rechargeable battery when the temperature is not within 5°C - 35° C
(41° - 95° Fahrenheit).
Never expose a battery to any liquid.
• Never expose a battery to excessive heat such as direct sunlight or fire. Never use a
battery pack in an unventilated vehicle where excessive internal temperatures may be
encountered.
Always keep batteries out of the reach of infants and small children.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions
handy for future reference.
1. Do not use this product near water. Unplug unit and clean only with damp cloth.
2. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
3. Heat – This product should be situated away from heat sources such as radiators,
heat registers, stoves or other appliances (including amplifiers) that produce heat.
4. Only use attachments/accessories specified by the manufacturer.
5. Unplug this product during lightning storms or when unused for long periods of time.
6. Damage Requiring Service – This product should be serviced by qualified service
personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been exposed to rain. The unit has been dropped or the enclosure
damaged.
- The unit exhibits a marked change in performance or does not operate normally.
7. No naked flame sources, such as lighted candles, should be placed on this product.
8. Attention should be drawn to the environmental aspects of battery disposal.
9. This product is suitable for use in tropical and/or moderate climates.
WARNING:
- To reduce the risk of fire or electric shock, do not expose this product to rain or moisture.
- Do not dispose of batteries in the household trash or fire.
- The mains plug of power adaptor is used as the disconnect device, it shall remain readily
operable.
- If the unit is to be unused for an extended period of time, such as a month or longer,
charge the unit fully before storage.
- Always use a UL/ETL certified charging adapter (not included), and the supplied USB
charging cable.
- Sunlight: Never place the mirror in or expose the mirror to direct sunlight. The sun’s rays
can reflect to become focused and cause excessive heat and/or fire. Do not use mirror in
direct sunlight as reflected sunlight could injure eyes.
Limited One Year Warranty
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI),
warrants this product to be free from defects in workmanship and materials, under
normal use and conditions, for a period of one (1) year from the date of original
purchase.
Should this product fail to function in a satisfactory manner, it is best to first return
it to the store where it was originally purchased. Should this fail to resolve the
matter and service still be required by reason of any defect or malfunction during
the warranty period, SDI will repair or, at its discretion, replace this product
without charge. This decision is subject to verification of the defect or malfunction
upon delivery of this product to the Factory Service Center authorized by
Customer Service.
If service is required, please call contact Customer Service at
ihome.com/support/contact to obtain a Return Authorization Number and
shipping instructions. A copy of the sales receipt is required to validate
in-warranty coverage. If proof of purchase cannot be produced, the product will
be deemed out-of-warranty. The date of purchase, vendor, product model
number, and purchase price must be legible and verifiable.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it
was designed. It does not cover (i) products which have been damaged by
negligence or willful actions, misuse or accident, or which have been modified or
repaired by unauthorized persons; (ii) cracked or broken cabinets, or units
damaged by excessive heat; (iii) damage to digital media players, CD’s or tape
cassettes (if applicable); (iv) the cost of shipping this product to the Factory
Service Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend to
owners of the product other than to the original purchaser. In no event will SDI or
any of its aliates, contractors, resellers, their ocers, directors, shareholders,
members or agents be liable to you or any third party for any consequential or
incidental damages, any lost profits, actual, exemplary or punitive damages.
(Some states do not allow limitations on implied warranties or exclusion of
consequential damages, so these restrictions may not apply to you.) This warranty
gives you specific legal rights, and you may also have other rights which vary from
state to state.
Your acknowledgment and agreement to fully and completely abide by the above
mentioned disclaimer of warranty is contractually binding to you upon your
transfer of currency (money order, cashier's check, or credit card) for purchase of
your SDI product.
© 2020 SDI Technologies, Inc. All rights reserved.
Questions? Visit www.ihome.com
Printed in China
iCVBT20-QSG-102220-A
Press and hold power button to turn
speaker ON or OFF (located on top of mirror)
The first time the mirror is powered ON, it will
automatically enter pairing mode, indicated
by a voice prompt and blue flashing LED. To
pair manually:
When mirror is ON, press and hold the
Bluetooth Pairing Button (located on back
of mirror) to enter pairing mode.
• Select ‘iHome PORTABLE’ on your device’s
Bluetooth menu to connect
Press to play / pause Bluetooth audio
Quick press twice for Next Track
Quick press three times for Previous Track
Press to lower or raise volume
Note: If no audio is playing for 60 minutes, the unit will
automatically power o to conserve the battery.
To reset Bluetooth settings, press and hold the Bluetooth
Pairing Button for 10 seconds.
charging
fully charged
low battery (fast flash)
RED
OFF
RED
BATTERY STATUS
pairing (flashing)
connected
BLUE
BLUE
BLUETOOTH STATUS
Status LED
  • Page 1 1

iHome iCVBT20 Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues