CABERG Pro Speak EVO Intercom Mode d'emploi

Pro Speak EVO Intercom
Marque
CABERG
Modèle
Pro Speak EVO Intercom
Taper
Mode d'emploi
Wired microphone
Micro USB
recharge plug Boom mike
Button +Button -
Speakers
DESCRIPTION - LEGENDA
Button-/Button+
OPERATION
X”
Press X sec.
xX
Press X times
AUDIO FEEDBACK
Sound alert
VISUAL FEEDBACK
Blue led blinking
Red led blinking
Red/blue led blinking
Purple led
Steady blue led
Steady red led
POWER ON
3”
Press 3 sec.
Led Blinking
“Power on”
Battery status
POWER OFF
3”
Pres 3 sec.
Led Blinking
“Power o”
PAIRING TO PHONE/GPS
Status: power o
4”
Press 4 sec.
Led blinks alternately
CABERG
Searching Bluetooth
device on your phone.
If needed, enter
PIN code (0000).
Four led blinkings
“Pairing successful”
“Device connected”
PAIRING ANOTHER
CABERG PRO SPEAK EVO
Status: Both units powered on
5”
Press 5 sec.
on both devices
“Pairing”
Led blinks alternately
on both devices
Three led blinkings
on both devices
“Pairing
successful”
PAIRING TO A DIFFERENT
MODEL/BRAND UNIT
Status: Both units powered on
5”
Press 5 sec.
Follow the “phone”
pairing procedure
Led blinks
alternately
“Pairing”
Both units stop flashing
“Pairing successful”
OPEN/CLOSE INTERCOM
Status: units on and paired
x1
Press once
“Beep”
Led blinks:
audio active
RESET ALL PAIRINGS
Status: power o
7”
Press 7 sec.
Steady led for
3 sec.
“Beep”
VOICE CALL
Status: unit on and connected to a phone
x2
Press twice
Voice assistant
(Google assistant, Siri)
x2
Press twice
to end the call
Note: Double click on + control -> Redial.
ANSWER A CALL
Status: phone rings
x1
Press once
to answer a call
x1
Press once
to end a call
3”
Press 3 sec.
to reject a call
Note: if the automatic reply is activated, after
8 seconds the call automatically starts.
VOLUME ADJUSTMENT
Status: while listening to an audio source
(intercom, music, phone call...)
Keep pressed to
increase the volume
Keep pressed to
decrease the volume
MUSIC
Status: unit on and connected to
the phone
Select a music APP
from the phone
x1
Press once
Play/Pause
Blinking
x2
Press twice
Song forward
x2
Press twice
Song backward
CHANGE LANGUAGE
Status: unit on
+7”
Keep pressed for more
than 7 seconds
“Battery status” in the
various languages.
Release + button to
select the desired one.
Distributed by:
CABERG S.P.A.
Via Emilia, 11 - 24052 Azzano S.Paolo
Bergamo (Italy)
www.caberg.it
Read the instructions carefully before
installation and use.
Produced or imported by:
MIDLAND EUROPE srl
Via R. Sevardi 7 - 42124 Reggio Emilia - Italy
To download the complete user manual please visit www.caberg.it/en
POCKET GUIDE Frequency 2.4GHz
Max power 2.5mW
Distributed in Canada by:
..................................................................
..................................................................
..................................................................
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d' en compromettre le fonctionnement.
  • Page 1 1
  • Page 2 2

CABERG Pro Speak EVO Intercom Mode d'emploi

Pro Speak EVO Intercom
Marque
CABERG
Modèle
Pro Speak EVO Intercom
Taper
Mode d'emploi
Télécharger le PDF
rapport

dans d''autres langues

Autres documents