Garmin IPH-04556 Manuel utilisateur
- Catégorie
- S'occuper d'un animal
- Taper
- Manuel utilisateur
Quick Start Manual 2
Manuel de démarrage rapide 9
Manuale di avvio rapido 17
Guía de inicio rápido 25
Краткое руководство по эксплуатации 33
Quick Start Manual
Getting Started
WARNING
See the Important Safety and Product
Information guide in the product box for
product warnings and other important
information.
Dog Collar Device
NOTE: Your dog collar device may look
different than the device pictured.
VHF antenna
GPS antenna
Power button
Contact points
Status LED and flashing beacon LEDs
Turning On the Device
• On the dog collar device, hold the
power button until the status LED
flashes and the collar beeps.
Turning Off the Dog Collar Device
Hold the power button until the status
LED turns solid red and the device
beeps.
Charging the Dog Collar Device
NOTICE
To prevent corrosion, thoroughly dry the
contacts on the collar and the
surrounding area before connecting the
charging clip.
NOTE: Your dog collar device may look
different than the device pictured.
2 Quick Start Manual
EN
You should fully charge the battery before
you use the device for the first time.
Charging a fully depleted battery takes
about five hours.
1Snap the charging clip onto the
device .
2Plug the small end of the power cable
into the mini-USB port on the charging
clip cable.
3Plug the power cable into a power
source.
The status LED is solid red when the
collar is charging.
4After the status LED turns solid green,
remove the charging clip from the
collar.
Acquiring Satellite Signals
Both the collar and handheld device must
acquire satellite signals before you put
the collar on your dog. Acquiring
satellites can take a few minutes.
1Go outdoors to an open area.
2Turn on both devices.
in the status bar shows the GPS
signal strength.
When the collar has acquired satellite
signals, the status LED flashes a double-
blink or triple-blink in green.
Adding a Dog to the Handheld
Using Wireless Pairing
1If the dog collar device is on, turn off
the dog collar device.
2Hold the power key on the dog collar
device until the device emits two
series of beeps (about 2 seconds),
and then release the power button.
The status LED flashes rapidly in
green. The dog collar device is now
ready to be linked, or paired, with a
handheld device.
3On the handheld device, select Dog
List > Add Dog.
4Select an option:
• If you are near the dog collar
device, select Pair Collar, and
follow the on-screen instructions.
Quick Start Manual 3
EN
• To pair a dog collar device by
receiving the information from
another handheld device, select
Receive from Handheld.
NOTE: To successfully pair the
device, the other handheld device
must be wirelessly sharing the
dog collar device information.
5After successfully adding the dog
collar device, enter the name of the
dog, and select .
Selecting and Installing the Contact
Points
CAUTION
To prevent irritation from the contact
points, remove the collar for at least eight
hours out of every 24-hour period.
Do not spray the device or collar with
harsh chemicals including but not limited
to flea or tick spray. Always ensure that
any flea or tick spray that is applied to
the dog is completely dry before placing
the collar on the dog. Small amounts of
harsh chemicals can damage the plastic
components and collar laminate.
For best results, select the correct
contact points based on your dog's coat.
1Select the correct contact point
length for your dog's coat type:
• For dogs with thicker coats, use
the longer contact points.
• For dogs with shorter coats, use
the shorter contact points.
2If necessary, use the included wrench
to remove the contact points.
3Twist the contact points into the
collar.
4Tighten with the included wrench, but
do not overtighten.
When you put the collar on the dog, make
sure the contact points are tight against
the neck.
Fitting the Collar on Your Dog
CAUTION
To prevent irritation from the contact
points, remove the collar for at least eight
hours out of every 24-hour period.
This device is not intended for human
use. Do not attempt to use on any
person.
Do not spray the device or collar with
harsh chemicals including but not limited
to flea or tick spray. Always ensure that
any flea or tick spray that is applied to
4 Quick Start Manual
EN
the dog is completely dry before placing
the collar on the dog. Small amounts of
harsh chemicals can damage the plastic
components and collar laminate.
In order to effectively train the dog, the
collar and device must fit the dog
properly. If the collar is too loose or
positioned incorrectly, stimulation may
be inconsistent. This can delay or prevent
successful training.
1Position the device at the front of the
dog's neck, with the status LED facing
toward the dog's chin and the contact
points against the throat.
2Tighten the strap so that it is very
snug around the dog's neck, and
fasten the buckle.
NOTE: The collar should fit tightly and
should not be able to rotate or slide
on the dog's neck. The dog must be
able to swallow food and water
normally. You should observe your
dog's behavior to verify that the collar
is not too tight.
3Wiggle the device to work the contact
points through the dog's coat.
NOTE: The contact points must have
contact with the dog's skin to be
effective.
4If the strap is too long, cut off the
excess, leaving at least 8 cm (3 in.) to
spare.
TIP: You can mark the hole used to
fasten the buckle for future reference.
Dog Tracking and Training
One handheld device can track multiple
dog collar devices and other handheld
devices.
Dog Tracking
The handheld device allows you to track
your dog or multiple dogs, using the
Quick Start Manual 5
EN
tracking compass or map. The map
displays your location and your dog's
location and tracks. The compass pointer
indicates the direction of the dog's
current location.
Dog Training
NOTICE
You should research and investigate the
training methods best suited for you, your
dog, and your needs. This manual
provides some basic guidelines for
training, but each dog has unique training
needs.
When used properly, the training
system is a very effective training tool to
aid your dog in reaching its full potential.
The use of the training system should be
part of an overall training program.
Begin training your dog on a leash,
without the training system. You
should train your dog how to heel, sit, and
come to you. After the dog understands
these three basic commands, you can
begin training with the dog collar device
and the leash. Finally, when the dog
consistently obeys commands using the
leash and collar, you may be able to
remove the leash to train with only the
dog collar device.
Communication with the Collar
You should keep an unobstructed line of
sight between your handheld device and
the dog collar device to produce the best
communication signal. To achieve the
best line-of-sight conditions, you should
move to the highest elevation point in
your area (for example, on the top of a
hill).
Best
Good
Poor
Entering Sleep Mode
NOTE: This feature is not available with
all dog collar device models.
Before you can enter sleep mode, you
must track your dog's location using the
compatible dog collar device.
When connected with the handheld
device, the dog collar device can be put
6 Quick Start Manual
EN
into sleep mode to conserve the battery
when you are not actively tracking your
dog.
1Select Dog List.
2Select a dog.
3Select > Adjust Collar Sleep Mode
> Sleep.
Exiting Sleep Mode
NOTE: This feature is not available with
all dog collar device models.
You can exit sleep mode on the
compatible dog collar device while you
are not actively tracking your dog.
1Select Dog List.
2Select a dog.
3Select > Adjust Collar Sleep Mode
> Wake.
Device Information
Getting the Owner's Manual
You can get the latest owner's manual
from the web.
1Go to www.garmin.com/support.
2Select Manuals.
3Follow the on-screen instructions to
select your product.
Updating the Dog Collar Device
Software
Before you can update the dog collar
device software, you must connect the
dog collar device to a computer.
NOTE: PC only. Updating the software
does not erase any of your data or
settings.
1Go to www.garmin.com/products
/webupdater.
2Follow the on-screen instructions.
VHF Radio Information
This product may be used only on
specific radio frequencies, which vary
depending on the country of use. The
handheld device and the dog device allow
the user to install a different antenna.
Changing the antenna can result in
improved radio performance and higher
radiated power. You must not use the
device with a third party antenna or an
antenna not approved by Garmin®. Go to
www.garmin.com/tracking-legal for
details about the performance and radio
frequency of this product, lawful
accessories, and power limits for
countries.
Quick Start Manual 7
EN
Securing the Antenna and Antenna
Keeper to the Collar
NOTICE
When using cable ties, ensure no sharp
edges are in contact with your dog's skin.
You can secure the antenna and antenna
keeper to the collar to optimize the fit of
the dog collar device on your dog.
For maximum radio performance, the
antenna should be pointed straight up
when positioned on your dog. Depending
on the size of your dog's neck, you may
need to use cable ties to properly
position the antenna.
1Secure the antenna keeper to the
collar with one of the provided cable
ties .
2Secure the antenna to the collar
with one of the provided cable ties .
3Cut off the excess length from the
cable ties.
Dog Collar Device Specifications
Battery type Rechargeable, replace‐
able lithium-ion,
361-00029-04
Operating
temperature
range
From -20° to 60°C (from
-4° to 140°F)
Charging
temperature
range
From 0° to 40°C (from
32° to 104°F )
Wireless
frequencies/
protocols
152-169 MHz @ 24.2 dBm
maximum, 2.4 GHz @ 6.9
dBm maximum
EU SAR
0.06 W/kg simultaneous
torso, 0.07 W/kg simulta‐
neous limb
Mini Dog Collar Device Specifications
Battery type Rechargeable, replace‐
able lithium-ion,
361-00035-09
Operating
temperature
range
From -20° to 60°C (from
-4° to 140°F)
8 Quick Start Manual
EN
Charging
temperature
range
From 5° to 40°C (from
41° to 104°F)
Wireless
frequencies/
protocols
155 MHz @ 32.77 dBm
maximum, 2.4 GHz @
-1.7 dBm maximum
Manuel de démarrage rapide
Mise en route
AVERTISSEMENT
Consultez le guide Informations
importantes sur le produit et la sécurité
inclus dans l'emballage du produit pour
prendre connaissance des
avertissements et autres informations
importantes sur le produit.
Appareil pour collier de chien
REMARQUE : votre appareil pour collier
de chien peut avoir une apparence
différente par rapport à l'image.
Antenne VHF
Antenne GPS
Bouton Marche/Arrêt
Points de contact
Voyant DEL d'état et balises cligno‐
tantes à LED
Mise sous tension de l'appareil
• Sur l'appareil pour collier canin,
appuyez sur le bouton Marche/Arrêt
jusqu'à ce que le voyant LED d'état
Manuel de démarrage rapide 9
FR
support.garmin.com
© 2021 Garmin Ltd. or its subsidiaries
Garmin®, the Garmin logo, and are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other
countries. TT™ is a trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express
permission of Garmin.
Other trademarks and trade names are those of their respective owners.
Printed in Taiwan
January 2022
190-02918-00_0B
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
Garmin IPH-04556 Manuel utilisateur
- Catégorie
- S'occuper d'un animal
- Taper
- Manuel utilisateur
dans d''autres langues
- English: Garmin IPH-04556 User manual
