Spectrum Industries 55209IDBW Manuel utilisateur

Catégorie
Chariots multimédia
Taper
Manuel utilisateur
Important
Before using this product:
Read this manual
Comply with all safety and operating instructions
Ensure all parts and correct quantities are included
Any parts damaged during shipment must be reported
within 15 days of receipt. To report information regard-
ing missing parts or damage, to purchase parts or
accessories, or if you have any questions, please
contact us.
Thank you for purchasing Spectrum products!
Spectrum Industries, Inc
925 First Avenue, Chippewa Falls, WI 54729 USA
800 235 1262
715 723 6750
www.spectrumfurniture.com
Owners Manual
0116103R1 Page 1 of 8
Spectrum product page:
http://bit.ly/LT15cart
LT-15 Laptop Cart
55209
(1) 025039
4mm hex wrench
(2) 055001
handle mount
(1) 052577
handle gusset
(12) 035252
3/16” x 1/2”
pinetree button
(10) 052605
1/4-20 x 15mm JC bolts
(15) 0110254-5
2” x 3” Velcro® hook and loop
(8) 044555
3/8” hole plug
(45) 052608
5” x 3/4” Velcro® wrap
(2) 041943
1/4-20 locknut
(3) 042919
5/16” hole plug
(32) 058305
1/4” hole plug
Important Safety and Care Instructions
Hardware
0116103R1 Page 2 of 8
Read this owner’s manual before assembly or operation.
Do not allow children to move the cart.
Proceed slowly and carefully when moving the cart.
For indoor use only. Do not install or store the cart where it will be exposed to
moisture.
Do not block the ventilation openings.
Avoid uneven loading of the equipment into the cart. Uneven weight distribution
could cause the cart to tip when the cart is moving.
Do not allow anyone to sit, stand, or climb on the cart.
Use a damp, soft-cloth, or sponge, with mild soap or detergent solution to clean
dirty surfaces. Do not use harsh solvents or abrasives.
This cart is intended for institutional use. It does not have any user-serviceable
parts or user-maintenance requirements. If servicing is necessary, please
contact Spectrum Industries for assistance.
Electrical Safety:
Keep the power switch in the OFF position before plugging or unplugging
from the wall outlet.
Turn OFF the devices before plugging them into the cart.
Ensure total device / equipment load does not exceed 12-amps.
Do not plug the power cord into an extension cord.
Inspect the power cords for damage before each use. Do not use power
cords that are damaged.
Unplug power cord from electrical outlet by gripping the cord. Do not unplug
the power cord by pulling only on the cord.
Do not step on, drive over, drag, or place objects on the power cord.
For added safety, plug the cart into a grounded outlet controlled by a GFI
(Ground Fault Interrupter) circuit breaker.
Damaged electrical components can create signi cant hazards to users and
is not covered by the warranty. Repairs should always be performed by a
quali ed electrician.
Electrical devices are not toys. Children are often unaware of the hazards
associated with electrical devices. This cart must always be used by adults
or with adult supervision.
Warning - Relocating audio and/or video equipment to furniture not speci cally
designed to support audio and/or video equipment may result in death or
serious injury due to the furnishing collapsing or over turning onto a child.
Warning - Death or serious injury may occur when children climb on audio
and/or video equipment furniture. A remote control or toys placed on the
furnishing may encourage a child to climb on the furnishing and as a result the
furnishing may tip over on to the child.
1. Assemble handle
2. Install handle
1. Attach the handle gusset and handle mounts to the bottom of the handle using
1/4-20 x 15mm JC bolts as shown in Figure 1. Do not tighten completely.
handle mount
Figure 1
Figure 2
1. Determine which side of the cart you would like the handle to be mounted, and open both doors.
LT-15 carts come with the doors hinged on the power strip-side. This is useful if the unit is going to be placed
against a wall. If the cart is going to be placed against a wall, install the handle opposite the hinges.
2. Attach the handle assembly to the side of the cart with (4) 1/4-20 x 15mm JC bolts as shown in Figure 2.
3. Tighten all bolts securely.
handle
handle
gusset
handle
mount 1/4-20 x 15mm
JC bolts
Note: It is critical that all fasteners be
used in the attachment of the handle.
1/4-20 x 15mm
JC bolts
Note: If you have the SR version (2 rigid, and 2 swivel
wheels) on your particular cart, mounting the handle
on the same side as the two swivel wheels will provide
more control of the cart when mobile.
1/4-20 x 15mm
JC bolt
1/4-20 x 15mm
JC bolt
1/4-20 x 15mm
JC bolt
Assembly / Setup
0116103R1 Page 3 of 8
4mm hex
wrench
(included)
Tools
Required
4mm hex
wrench
(included)
Tools Required
7/16” or
adjustable
wrench
5/16” hole plugs
(3 required)
3. Install hole plugs
1. If one side of the unit will not have a handle or the optional ip-up shelf attached,
install pine tree buttons in the unused mounting holes as shown. Figure 3.
2. Install (3) 5/16” hole plugs in the center of the side panel.
3. Install 1/4” hole plugs and pine tree buttons in the remaining open holes as shown.
pine tree buttons
corner column
1/4” hole plugs
pine tree button
pine tree button
Figure 3
left side of cartright side of cart
1/4” hole plugs
0116103R1 Page 4 of 8
4. Route power cord
1. Route the power cord through one of the side panels grommets and wrap
excess cord around the cord wrap brackets as necessary. Figure 4.
0116103R1 Page 5 of 8
Figure 4
power
cord
grommet
grommet
cord wrap
bracket
cord wrap
bracket
5. Cord management
Power strip operation
1. Using the cord management slots in the trays, and Velcro straps provided, bundle the charge cords.
Figure 5 shows a typical wiring example. Be sure to leave enough slack in the power cord to allow the tray to be pulled out.
2. Route the charging plug to the student side of the tray to allow easy-access and removal. Anchor with a Velcro strap.
3. Adhesive-backed Velcro hook and loop strips are also provided to attach the charging transformer to the tray if necessary.
1. With the main power cord unplugged and the power strip switched off,
plug the laptop charge cords into the power strip. Figure 6.
2. The power strip can be turned on and off with the main power switch. The
breaker can be reset in the event of an overload with the reset button.
Velcro straps
Laptop
charging
transformer
Figure 5
student side
power side
bundled charge cords
with Velcro strap
power cord
(leave enough slack
to pull out tray)
power strip
reset button power switch
Figure 6
0116103R1 Page 6 of 8
Options
Tray Edge Trim
applies to shelf pull edge
30 pieces
55172
Flip-up Shelf
adjustable-height, mounts on left or right
18”W x 2058”D (50 lbs max capacity)
55219
Velcro® Strap Kit
(16) 34” x 12”, and (32) 34” x 5”
Velcro® Straps
95004
Note: Power and communication wiring for document cam-
eras, laptop computers, and/or projectors placed on the
ip-up shelf should be routed on top of the audience-side
of the shelf. Use of the shelf grommet hole for wiring will
result in pinching of the cords when the shelf is folded.
0116103R1 Page 7 of 8
4mm hex
wrench
(included)
Tools
Required
Wheel operation
Figure 8
brake lever
Figure 7
Door stop adjustment
If necessary, the offset door stop can be rotated slightly to adjust
the closed position of the doors and lock rods.
1. To rotate, loosen the JC bolt slightly with a 4mm hex wrench. Figure 7.
2. Rotate the door stop until the door is positioned correctly.
3. Re-tighten the JC bolt securely.
1. To lock the wheel rotation, press the brake lever. Figure 8.
2. To resume operation, lift up on brake lever.
Moving and parking the cart
Before moving, unplug and secure all power cords.
Close and lock doors.
Remove any items from the top of the worksurface.
Unlock the wheels.
Push slowly and carefully. Do not move over uneven or irregular surfaces.
Do not allow children to move.
Lock the wheels after moving.
Do not park unit in areas of heavy trafc.
Do not run power cords across hallways, classrooms, or other areas where they will be walked on.
Do not leave unit unattended in areas where children have access.
Keep doors closed and locked whenever unit is unattended or parked.
Keep wheels locked whenever the unit is unattended.
CAN TIP OVER RESULTING IN RISK OF INJURY, DO
NOT ALLOW CHILDREN UNDER 16 TO MOVE CART.
MOVE CART SLOWLY.
ONLY ADULTS SHOULD
MOVE THIS UNIT
APPLY MOVING FORCE ON
NARROW DIMENSION
NEVER APPLY FORCE AT TOP
ALWAYS PUSH NEAR MIDDLE
PUSH, DO NOT PULL
CE MEUBLE DOIT ÊTRE
DÉPLACÉ UNIQUEMENT
PAR DES ADULTES.
LE MEUBLE POURRAIT SE RENVERSER ET CAUSER
DES BLESSURES. NE LAISSER PAS LES ENFANTS
DE MOINS DE 16 ANS DÉPLACER CELUI-CI.
DÉPLACER LE MEUBLE LENTEMENT.
POUSSER DANS LE SENS
DE LA LONGUEUR.
NE JAMAIS EXERCER LA FORCE EN
HAUT. POUSSER PRÈS DU MILIEU.
POUSSER, NE PAS TIRER.
PUEDE VOLCARSE Y PROVOCAR LESIONES. NO
PERMITA QUE LOS NIÑOS MENORES DE 16 AÑOS
MUEVAN EL CARRO. MUEVA EL CARRO LENTAMENTE.
SOLO LOS ADULTOS
DEBERÁN MOVER ESTA
UNIDAD
APLIQUE LA FUERZA
MOTRIZ EN DIMENSIONES
ESTRECHAS
JAMÁS APLIQUE FUERZA EN LA
PARTE SUPERIOR. SIEMPRE EMPUJE
CERCA DE LA PARTE INTERMEDIA
EMPUJE, NO JALE
0108899
WARNING
AVERTISSEMENT
ADVERTENCIA
Warranty
0116103R1 Page 8 of 8
WE WILL MAKE IT RIGHT FOR YOU!
Spectrum is committed to provide complete customer satisfaction. Each of our products is manufactured from the best materials available and each
product is stringently monitored throughout the production process through our P.A.C.E. program (Product Assurance to meet Customer Expectations).
We expressly warrant that Spectrum products will be of good quality and workmanship and free from defect for the period set out in the warranty table
below from the date of delivery. This warranty shall not apply to defects or damage resulting from misuse, abuse, neglect, improper care, modifi cation
or repair not authorized by Spectrum, or any other cause outside the control of Spectrum. Spectrum will, at its sole option, either repair or replace the
defective product.
This warranty is exclusive; no other warranty, written or oral, is expressed or implied. This warranty is given by Spectrum to Buyer and to no other per-
son or legal entity. No Spectrum dealer, distributor, agent or employee is authorized to make any modifi cation or addition to this warranty.
NOTWITHSTANDING ANYTHING TO THE CONTRARY, SPECTRUM WILL NOT UNDER ANY CIRCUMSTANCES BE LIABLE FOR INDIRECT OR
LIQUIDATED DAMAGES, INCLUDING CONSEQUENTIAL, INCIDENTAL AND SPECIAL DAMAGES. IN NO EVENT SHALL SPECTRUM’S LIABIL-
ITY, WHETHER UNDER CONTRACT OR WARRANTY, IN TORT OR OTHERWISE, EXCEED THE PURCHASE PRICE RECEIVED BY SPECTRUM
FOR THE PRODUCT AT ISSUE AND “RECALL ACTION” EXPENSES. SPECTRUM SHALL NOT BE SUBJECT TO ANY OTHER OBLIGATIONS
OR LIABILITIES, WHETHER ARISING OUT OF BREACH OF CONTRACT, WARRANTY, TORT (INCLUDING NEGLIGENCE AND STRICT LIABIL-
ITY) OR OTHER THEORIES OF LAW, WITH RESPECT TO PRODUCTS SOLD OR SERVICES RENDERED BY SPECTRUM, OR ANY UNDERTAK-
INGS, ACTS OR OMISSIONS RELATING THERETO.
Our Customer Service Department is ready to provide immediate attention to any questions, comments or concerns. They are available to answer your calls
Monday through Friday from 7 am to 5 pm CST. In addition your product comments or concerns are welcome via e-mail at: [email protected].
Warranty Table
Item Warranty Period
Adjustable Crank/Electric Desk Legs 1 Year
Flat Panel Desk Gas Cylinders
Adjustable Height Chair Parts – including frames,
gas cylinders, wood and plastic parts, and control
handles Adjustable Height Chair Parts Casters
Adjustable Height Chair Upholstery
In-Stock Upholstery
Graded-In Fabrics and Customer Owned Material
7 Years
2 Years
2 Years
No Warranty
Height Adjustable Columns and Lifts
1 Year
General Use Casters
Electrical
Keyboard/Mouse Trays
Flat Panel Monitor Arm – General Parts
Flat Panel Monitor Arm – Gas Cylinders
5 Years
2 Years
Computer Desk Chassis
Cart Chassis
Lectern Chassis
10 Years
925 First Avenue, PO Box 400, Chippewa Falls, WI 54729 Ph: 800-235-1262, 715-723-6750 Fax: 800-335-0473, 715-738-2309
E-mail: [email protected] web: www.spectrumfurniture.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Spectrum Industries 55209IDBW Manuel utilisateur

Catégorie
Chariots multimédia
Taper
Manuel utilisateur

dans d''autres langues