Turtle Beach TBS-2350-02 Manuel utilisateur

Taper
Manuel utilisateur
Any questions?
turtlebeach.com/stealth300 | support.turtlebeach.com
FOR MODEL: Stealth 300 for Xbox One
426-023-001-001 RA
Stealth 300 Headset USB Charging Cable
1 tone = Signature Sound
2 tones = Bass Boost
3 tones = Bass + Treble Boost
4 tones = Treble Boost
EQ Presets
USB Charge Port
Mic Mute
Flip up mic to mute
Preset Button
Press = Cycle EQ Audio Presets
Mic Monitor Volume
Master Volume
Power LED
Solid Green = Headset On
Blinking Green/Red = Battery Low
(USB Connected)
Blinking Red = Charging
Blinking Green = Fully Charged
Power Button
Press and Hold = Power On/Off
For updated setup instructions visit:
turtlebeach.com/sonic
SURROUND SOUND SETUP (AVAILABLE ONLY ON XBOX ONE)
EN
1. Press the Xbox Button on your controller
2. Go to the System tab
3. Select Settings >> Display & Sound >> Audio Output
4. Set Headset format to Windows Sonic for Headphones
The Stealth 300 requires an Xbox One controller with a 3.5mm headset jack. Other controllers may
require the Headset Audio Controller (sold separately).
Note/ Remarque :
1. Press the Xbox Button on your controller
2. Go to the System tab >> Audio
a. Set Headset Volume to Maximum
b. Set Headset Chat Mixer to the middle setting
c. Set Mic monitoring to minimum
Originally created for the Elite Pro Tournament Gaming Headset,
Turtle Beach’s exclusive ProSpecs glasses friendly technology is
built into the Stealth 300, featuring an advanced ear cushion design and
materials that allow gamers who wear glasses to finally play in comfort.
PROSPECS
GLASSES FRIENDLY DESIGN
Console
The Stealth 300 uses a rechargeable battery. Make sure to charge it regularly.
Headset Storage:
Always charge your headset before storing it for any extended period of time
(greater than 3 months). Never store the unit in temperatures above 113°F/45°C.
Note: If your PC uses separate Green/Pink connectors for audio
you will need a PC Splitter Cable. This adapter is available
online at turtlebeach.com
PC/Mac & Mobile Setup Charging
Immunity: EN 55024: 2010, CISPR 24: 2010
EN 61000-4-2: 2009, EN 61000-4-3: 2006 + A1: 2008 + A2: 2010,
EN 61000-4-8: 2010
These products are licensed, as required, for additional country specific standards for the
International Marketplace. Additional issued licenses available upon request.
Environmental: Low Voltage Directive 2014/35/EU, RoHS 2011/65/EU, REACH 2006/1907/EC,
WEEE 2012/19/EU, Packaging 94/62/EC, Battery 2006/66/EC,
Toys Safety Directive 2009/48/EC
Warning! This is a Class B product. In a domestic environment, this product may cause radio interference, in which case, the user may be required to take appropriate measures.
Achtung! Dieses ist ein Gerät der Funkstörgrenzwertklasse B. In Wohnbereichen können bei Betrieb dieses Gerätes Rundfunkstörungen auftreten, in welchen Fällen der Benutzer
für entsprechende Gegenmaßnahmen verantwortlich ist.
Attention! Ceci est un produit de Classe B. Dans un environnement domestique, ce produit risque de créer des interférences radioélectriques, il appartiendra alors à l’utilisateur
de prendre les mesures spécifiques appropriées.
Please visit the following URL for a complete copy of the Declaration of Conformity: http://www.turtlebeach.com/homologation
This symbol on the product or its packaging indicates that this product must not be disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling
of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal
will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For
more information about where you can drop off your waste for recycling, please contact your local authority, or where you purchased
your product.
Turtle Beach Europe Ltd is obligated as a producer with a main activity of selling under The Producer Responsibility Obligations (Packaging Waste) Regulations 2007. To fulfil
our obligation we are registered with Comply Direct and their Recycling Room. Here you will find advice and information on packaging waste management, recycling symbols
and the waste hierarchy principles of reduce, reuse and recycle.
https://www.complydirect.com/the-recycling-room/
Regulatory Compliance Statements for the Stealth 300 for Xbox One
Federal Communications Commission (FCC) Compliance Notices
Class B Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
This product is compliant with the Consumer Product Safety Improvement Act of 2008, Public Law 110-314 (CPSIA)
Canadian ICES Statements
Canadian Department of Communications Radio Interference Regulations
This digital apparatus does not exceed the Class B limits for radio-noise emissions from a digital apparatus as set out in the Radio Interference Regulations of the Canadian
Department of Communications. This Class B digital apparatus complies with Canadian ICES-003.
Règlement sur le brouillage radioélectrique du ministère des Communications
Cet appareil numérique respecte les limites de bruits radioélectriques visant les appareils numériques de classe B prescrites dans le Règlement sur le brouillage
radioélectrique du ministère des Communications du Canada. Cet appareil numérique de la Classe B est
conforme à la norme NMB-003 du Canada.
European Union and European Fair Trade Association Regulatory Compliance
This equipment may be operated in the countries that comprise the member countries of the European Union and the European Fair Trade Association. These countries,
listed below, are referred to as The European Community throughout this document:
AUSTRIA, BELGIUM, BULGARIA, CYPRUS, CZECH REPUBLIC, DENMARK, ESTONIA, FINLAND, FRANCE,, GERMANY, GREECE, HUNGARY, IRELAND, ITALY, LATVIA,
LITHUANIA, LUXEMBOURG, MALTA, NETHERLANDS, POLAND, PORTUGAL, ROMANIA, SLOVAKIA, SLOVENIA, SPAIN, SWEDEN, UNITED KINGDOM, ICELAND,
LICHTENSTEIN, NORWAY, SWITZERLAND
Declaration of Conformity
Marking by this symbol:
indicates compliance with the Essential Requirements of the Radio Equipment Directive (RED) of the European Union (2014/53/EU). This equipment meets the following
conformance standards:
Safety: EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12: 2011 + A2: 2014 (T-Mark License),
IEC 60950-1: 2005 (2nd Ed.) + Am 1: 2009 + Am 2: 2013 (CB Scheme Certificate),
EN 50332-1: 2013, EN 50332-2: 2013, EN 71-3: 2013
Additional licenses issued for specific countries available on request
Emissions: EN 55032: 2012, CISPR 32: 2015
Class B
(Broadcasting Communication Equipment for Home Use)
As an electromagnetic wave equipment for home use (Class B), this equipment is intended to use mainly for home use and may be used in all areas.
To Access the Rating Label:
1. Remove the left ear pad, start by pulling the
ear pad straight up using your thumb.
To replace the ear pad, follow the same process in reverse.
2. Once you've released the cloth from the lip on top, pull the
ear pad straight back and it should slip right off.
Setup for Xbox One
Headset Controls
Package Contents
  • Page 1 1

Turtle Beach TBS-2350-02 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues