Tefal FV1242X0 Manuel utilisateur

INSTRUCTIVO DE OPERACION

Le invitamos a leer cuidadosamente este instructivo antes de usar su aparato, en el encontrarà sus

caracteristicas e instrucciones para el mejor aprovechamiento del mismo. Verifique que el voltaje de su

instalación sea igual al de su aparato el cual se indica en este instructivo.

Mod. FV12XX

127V ~ 60Hz -1200W

Color Edition

Groupe SEB México, S.A. de C.V.

Calle Goldsmith 38-401 Piso 4

Polanco, Distrito Federal C.P. 11560

México.

Servicio al Consumidor :

01 (800) 112.83.25 / 01 (800) 505.45.00

www.tefal.com

EN

ES

FR

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page1

2

EN Depending on model

• ES Según el modelo

• FR Selon modèle

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page2

3

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page3

4

1. EN First use / ES Primer uso / FR Première utilisation

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page4

2

OK

5

NO

m

a

x

m

a

x

6

3

4

6

78

NO

1

8

5

1. EN First use / ES Primer uso / FR Première utilisation

EN Depending on model

• ES Según el modelo

• FR Selon modèle

2. EN Water tank filling / ES Llenado del tanque de agua FR Remplissage

du réservoir

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page5

OK

23

1

34

2

3.1. EN Temperature setting / ES Ajuste de temperatura

FR Réglage de la température

6

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page6

3.2. EN Steam setting / ES Ajuste del vapor

FR Réglage de la vapeur

7

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page7

x1

1

2 sec /2 s

x1

23

2

5. EN Spray / ES Spray / FR Superpressing

4. EN Extra steam / ES Extra vapor / FR vapeur

8

EN Depending on model • ES Según el modelo • FR Selon modèle

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page8

10 cm

4

x5

10 sec

10 s

NO

23

56

7

1

9

6. EN Vertical steam / ES Vapor vertical

FR Vapeur verticale

EN Depending on model • ES Según el modelo • FR Selon modèle

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page9

1

30-45 min

NO

23

46

7

89

5

7. EN Iron storing / ES Almacenamiento de la plancha

FR Rangement du fer

10

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page10

1

NO

32

1/4

NO

OK

11

4 h

12

30-45 min

45

79

10

6

8

Self

Clean

8. EN Anti-calc valve cleaning (once a month) / ES Válvula de limpieza antical

(una vez al mes) / FR Nettoyage de la tige anti calcaire (une fois par mois)

11

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page11

1/4

14

15

13

8. EN Anti-calc valve cleaning (once a month) / ES Válvula de limpieza antical

(una vez al mes) / FR Nettoyage de la tige anti calcaire (une fois par mois)

12

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page12

13

9. EN Self-cleaning (once a month) / ES Auto-limpieza

(una vez al mes)

FR Auto nettoyage (

une fois par mois)

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page13

9. EN Self-cleaning (once a month) / ES Auto-limpieza

(una vez al mes)

FR Auto nettoyage (une fois par mois)

O

14

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page14

3

30 min

OK

12

456

7

8 9

10. EN Soleplate cleaning / ES Limpieza de la suela

FR Nettoyage de la semelle

15

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page15

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using the iron.

When using your iron, basic safety precautions should always be followed, including the following:

1. Use iron only for its intended use.

2. To protect against a risk of electric shock, do not immerse the iron in water or other liquids.

3. Always turn the iron OFF before plugging or unplugging the iron from the electrical outlet. Never pull

on the cord to disconnect the iron from the electrical outlet; instead, grasp the plug and pull on the plug

to disconnect the iron.

4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loo-

sely around iron when storing.

5. Always disconnect iron from electrical outlet when filling with water or emptying and when not in use.

6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk

of electric shock, do not disassemble the iron. Contact our Consumer Service Department for examination,

repair or adjustment. Incorrect reassembly can cause a risk of electric shock when the iron is used.

7. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unat-

tended while connected or on an ironing board.

8. Burns can occur from touching hot metal parts, hot water or steam. Use caution when you turn a steam

iron upside down - there may be hot water in the reservoir.

9. This appliance is only for domestic and personal use.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.

2. If an extension cord is absolutely necessary, a 15 amp. cord should be used. Cords rated for less amper

may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS

For your safety

PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE REFERENCE.

This appliance complies with the technical rules and standards for safety currently in force (Electroma-

gnetic Compatibility, Low Voltage, Environnement).

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or ins-

truction concerning use of the appliance by a person responsible for their safety. Children must be su-

pervised to ensure that they do not play with the appliance.

•

During the first few uses, a harmless odour and a small amount of smoke may be given off. This has

no effect on the use of the iron and will disappear quickly.

• Warning ! The voltage of your electrical installation must correspond to that of the iron (120V

or 127 V). Connecting to the wrong voltage may cause irreversible damage to the iron and will

invalidate the guarantee.

• If it is absolutely essential to use an extension cable, choose a 15 amp one.

• If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Cen-

tre to avoid any danger.

• The appliance should not be used if it has fallen, if it has obvious damage, if it leaks or functions incor-

rectly. Never dismantle your appliance : have it inspected by an Approved Service Centre, so as to avoid any

danger.

• Never immerse your iron in water !

• Do not unplug your appliance by pulling on the cord. Always unplug your appliance: before filling or rin-

sing the water tank, before cleaning it, after each use.

16

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page16

17

• Never leave the appliance unattended when it is connected to a power source or if it has not cooled

down for approximately 1 hour.

• Your appliance gives off steam, which may cause burns. Take extra care especially when you are iro-

ning close to the edge or on a corner of your ironing board. Never direct the steam towards people

or animals.

• Your iron should be used and placed on a flat, stable, heat-resistant surface. When you put your iron

onto its iron rest, make sure that the surface on which you put it is stable.

• This product has been designed for domestic use only. Any commercial use, inappropriate use or fai-

lure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee

will not apply.

• The auto-stop light will be lit during normal use!

What water to use?

Your appliance has been designed to function with untreated tap water. However, it is necessary to

operate the Self-Clean function regularly in order to eliminate hard water deposits from the steam

chamber.

If your water is very hard (check with your local water authority), it is possible to mix untreated tap

water with store-bought distilled or demineralised water in the following proportions : - 50% un-

treated tap water, - 50% distilled or demineralised water.

Types of water not to use?

Heat concentrates the elements contained in water during evaporation.The types of water listed

below contain organic waste or mineral elements that can cause spitting, brown staining, or pre-

mature wear of the appliance : water from clothes dryers, scented or softened water, water from re-

frigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not

be used in your iron. Also do not use boiled, filtered or bottled water.

Environment

Environment protection first !

i Your appliance contains valuable materials which can be recovered or recycled.

‹ Leave it at a local civic waste collection point.

EN

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page17

If you have any problem or queries, please contact our Customer

Relations team first for expert help and advice.

18

PROBLEM POSSIBLE CAUSE

SOLUTION

Water drips from the

holes in the soleplate.

The iron drips

when you start ironing.

The chosen temperature is too

low and does not allow for the

f

ormation of steam.

Y

ou are using steam while the iron

is not hot enough.

You are using the Shot of Steam

button too often.

There is too much steam.

You have stored the iron horizon-

tally, without emptying it and

without setting it to

.

You have removed the anti-scale

rod to fill your iron.

Position the thermostat in the steam range

(from •• to MAX).

Wait until the thermostat light goes out.

Wait a few seconds between each use of the

button.

Reduce the steam.

See the section "Storing your iron".

Do not extract the anticalc valve when filling

the iron.

Brown streaks come

through the holes in the

soleplate and stain the

linen.

You are using chemical descaling

agents.

You are not using the right type of

water.

Fabric fibres have accumulated in

the holes of the soleplate and are

burning.

Your linen has not been rinsed

sufficiently or you have ironed a

new garment before washing it.

Do not add any descaling agents to the water

in the water tank.

Perform a self-cleaning operation and consult

the chapter "What water should I use?".

Perform the self-cleaning operation and clean

the soleplate with a damp sponge. Vacuum

the holes of the soleplate from time to time.

Make sure that your laundry is rinsed

sufficiently so as to remove any deposits of

soap or chemical products on new clothes.

The soleplate is dirty or

brown and can stain the

linen.

Your are ironing with an inappro-

priate program (temperature too

high).

You are using starch.

Clean the soleplate as indicated above. Select

the appropriate program.

Clean the soleplate as indicated above.

Always spray starch onto the reverse side of

the fabric to be ironed.

There is little or no

steam.

The water tank is empty.

The anti-calc valve is dirty.

Your iron has a build-up of scale.

Your iron has been used dry for too

long.

Fill it.

Clean the anti-calc valve.

Clean the anti-calc valve and carry out a self-

clean.

Carry out a self-clean.

The soleplate is scrat-

ched or damaged.

You have placed your iron flat on a

metallic rest-plate or ironed over a

zip.

Always set your iron on its heel.

Do not iron over zips.

Steam or water come

from the iron as you

finish filling the tank.

The steam control is not set to the

position.

The water tank is overfilled.

Check that the steam control is set to the

position.

Never exceed the Max level.

The spray does not

spray.

The water tank is not filled enough. Fill up the water tank.

If there is a problem?

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page18

19

EN

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page19

20

1800133990-FV12XX-X0_110x154 TF 19/06/14 10:11 Page20

La page charge ...

Tefal FV1242X0 Manuel utilisateur

Tefal FV1242X0 Manuel utilisateur

dans d''autres langues

Documents connexes

Autres documents