Toshiba 6157-001 Manuel utilisateur

Taper
Manuel utilisateur
Model: 6157-001
AI Camera
Telecommunication regulatory statement
This product is not intended to be connected directly or indirectly by any
means whatsoever to interfaces of public telecommunications networks,
nor is it intended to be used in a public services network.
Electronic emission notices
When you attach a monitor to the equipment, you must use the designated
monitor cable and any interference suppression devices that are supplied
with the monitor.
Federal Communications Commission (FCC) statement
Note: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful inter-
ference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of
this equipment in a residential area is likely to cause harmful interference,
in which case the user will be required to correct the interference at his
own expense.
Properly shielded and grounded cables and connectors must be used in or-
der to meet FCC emission limits. Toshiba Global Commerce Solutions is
not responsible for any radio or television interference caused by using
other than recommended cables and connectors or by unauthorized chang-
es or modifications to this equipment. Unauthorized changes or modifica-
tions could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interfer-
ence that might cause undesired operation.
Industry Canada Class A emission compliance statement
This Class A digital apparatus complies with Canadian ICES-003.
Avis de conformité à la réglementation d'Industrie
Canada
Cet appareil numérique de la classe A est conforme à la norme NMB-003
du Canada.
Australia and New Zealand Class A statement
Attention: This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may be re-
quired to take adequate measures.
European Union EMC Directive conformance statement
This product is in conformity with the protection requirements of EU
Council Directive 2014/30/EU on the approximation of the laws of the
Member States relating to electromagnetic compatibility. Toshiba Global
Commerce Solutions cannot accept responsibility for any failure to satisfy
the protection requirements resulting from a nonrecommended modifica-
tion of the product, including the fitting of non-Toshiba Global Commerce
Solutions option cards.
This product has been tested and found to comply with the limits for Class
A Information Technology Equipment according to CISPR 32/European
Standard EN 55032. The limits for Class A equipment were derived for
commercial and industrial environments to provide reasonable protection
against interference with licensed communication equipment.
Attention: This is an EN 55032 Class A product. In a domestic environ-
ment this product may cause radio interference in which case the user may
be required to take adequate measures.
Responsible manufacturer:
Toshiba Global Commerce Solutions
3901 South Miami Blvd.
Durham, NC 27703 USA
European Community contact:
Toshiba Global Commerce Solutions, Inc.
Brand Manager - Europe, Middle East & Africa
Z.1 Researchpark 160, 1731 Asse, Belgium
Tel:33-6845-35093
e-mail: cthery@toshibagcs.com
Germany Class A statement
Deutschsprachiger EU Hinweis: Hinweis für Geräte der Klasse A EU-
Richtlinie zur Elektromagnetischen Verträglichkeit
Dieses Produkt entspricht den Schutzanforderungen der EU-Richtlinie
2014/30/EU zur Angleichung der Rechtsvorschriften über die
elektromagnetische Verträglichkeit in den EU-Mitgliedsstaaten und hält
die Grenzwerte der EN 55032 Klasse A ein.
Um dieses sicherzustellen, sind die Geräte wie in den Handbüchern
beschrieben zu installieren und zu betreiben. Des Weiteren dürfen auch
nur von der Toshiba Global Commerce Solutions empfohlene Kabel an-
geschlossen werden. Toshiba Global Commerce Solutions übernimmt
keine Verantwortung für die Einhaltung der Schutzanforderungen, wenn
das Produkt ohne Zustimmung der Toshiba Global Commerce Solutions
verändert bzw. wenn Erweiterungskomponenten von Fremdherstellern
ohne Empfehlung der Toshiba Global Commerce Solutions ges-
teckt/eingebaut werden.
EN 55032 Klasse A Geräte müssen mit folgendem Warnhinweis versehen
werden: “Warnung: Dieses ist eine Einrichtung der Klasse A. Diese Ein-
richtung kann im Wohnbereich Funk-Störungen verursachen; in diesem
Fall kann vom Betreiber verlangt werden, angemessene Maßnahmen zu
ergreifen und dafür aufzukommen.”
Deutschland: Einhaltung des Gesetzes über die elektromagnetische
Verträglichkeit von Geräten
Dieses Produkt entspricht dem “Gesetz über die elektromagnetische Ver-
träglichkeit von Geräten (EMVG)”. Dies ist die Umsetzung der EU-
Richtlinie 2014/30/EU in der Bundesrepublik Deutschland.
Zulassungsbescheinigung laut dem Deutschen Gesetz über die
elektromagnetische Verträglichkeit von Geräten (EMVG) (bzw. der
EMC EG Richtlinie 2014/30/EU) für Geräte der Klasse A
Dieses Gerät ist berechtigt, in Übereinstimmung mit dem Deutschen
EMVG das EG-Konformitätszeichen - CE - zu führen.
Verantwortlich für die Einhaltung der EMV Vorschriften ist der Hersteller:
Toshiba Global Commerce Solutions
3901 South Miami Blvd.
Durham, NC 27703 USA
Der verantwortliche Ansprechpartner des Herstellers in der EU ist:
Toshiba Global Commerce Solutions, Inc.
Brand Manager - Europe, Middle East & Africa
Z.1 Researchpark 160,
1731 Asse, Belgium
Tel:33-6845-35093
e-mail: cther[email protected]
Generelle Informationen:
Das Gerät erfüllt die Schutzanforderungen nach EN 55024 und EN 55032
Klasse A.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection
of other channels is not possible.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled envi-
ronment. This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body.
Section 15.204(b) states that an approved "transmission system" must always be marketed as a
complete system including the antenna.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Sci-
ence and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscep-
tible d’en compromettre le fonctionnement.
This device is restricted to indoor use.
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm be-
tween the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement
non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20cm de distance entre la
source de rayonnement et votre corps
The transmitter module may not be co-located with any other transmitter or antenna.
Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne.
The Country Code Selection feature is disabled for products marketed in the US/Canada
Camera Introduction
Warning: Do not defeat the safety purpose of grounding type plug. Only use the power supplying
cord in combination with earthing socket-oulet.
Key Component
FCC ID
FCC ID
2AW3T-6157-001
Tips on Placement
Assemble the bracket and camera
And lock the bracket with the screw
Note: Screw drawing
Operation Frequency and Radiation Power
FCC
CE
Antenna Specification
Both antennas support Dual-Band(2.4GHz/5GHz)
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11

Toshiba 6157-001 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues