Polycom VTX 1000 Mode d'emploi

Taper
Mode d'emploi
Polycom® Wireless Microphone Quick Start Guide Polycom® Wireless Microphone Quick Start Guide
Polycom®
Wireless Microphone
Quick Start Guide
For use with Polycom SoundStation VTX 1000®,
Polycom SoundStation2TM EX and
Polycom SoundStation® IP 6000
Linking the Receivers and Microphones
Turning On the Microphone
After you charge the microphone, turn on the microphone so it can
establish a link with the receiver.
To turn on the microphone:
Switch the Power On/Off switch on the bottom of the
microphone to the On position (the position marked with the “--”
symbol).
The microphone will establish a radio link with the receiver. When a link
is established, the Microphone Pair/Power LED and the Receiver
Status LED glow a solid green, and the microphone is ready to use.
If a link is not established, the Microphone Pair/Power LED and
the Receiver Status LED will ash green to indicate that the microphone
and receiver may not be paired. (To pair, see below.)
Pairing the Microphone and Receiver
Your microphones and receivers are automatically “paired” at the factory.
However, if the Microphone Pair/Power LED and the Receiver
Status LED ash green, you may need to re-pair the microphone and
receiver.
To pair the microphone and receiver:
1. Press and hold the Pair/Page button on the bottom of the receiver
for at least ve seconds, until the Receiver Status LED fast-ashes
green (“pairing” mode). The LED will fast-ash green for 30 seconds.
2. While the Receiver Status LED fast-ashes green, press and hold the
Mute/Pair button on the microphone for at least ve seconds, until
the Microphone Pair/Power LED glows solid green (“pairing”
mode). The microphone is ready to use.
Paging the Microphone
You can page a microphone to identify the microphone that is paired with
a particular receiver, or to locate a microphone.
To page a microphone:
Press and release the Pair/Page button on the bottom of the
receiver. The paired microphone will beep and the Microphone
Pair/Power LED will glow red. To stop the microphone from
beeping, press the Pair/Page button again, or press the Mute/Pair
button on the microphone.
Warranty, Copyright, Safety Notices
LIMITED WARRANTY. Polycom warrants to the end user (“Customer) that this
product will be free from defects in workmanship and materials, under normal use
and service, for one year from the date of purchase from Polycom or its authorized
reseller.
Polycom’s sole obligation under this express warranty shall be, at Polycom’s
option and expense, to repair the defective product or part, deliver to Customer
an equivalent product or part to replace the defective item, or if neither of the two
foregoing options are reasonably available, Polycom may, on its sole discretion,
refund to Customer the purchase price paid for the defective product. All products
that are replaced will become the property of Polycom. Replacement products or parts
may be new or reconditioned. Polycom warrants any replaced or repaired product
or part for ninety (90) days from shipment, or the remainder of the initial warranty
period, whichever is longer.
Products returned to Polycom must be sent prepaid and packaged appropriately for
safe shipment, and it is recommended that they be insured or sent by a method that
provides for tracking of the package. Responsibility for loss or damage does not
transfer to Polycom until the returned item is received by Polycom. The repaired or
replaced item will be shipped to Customer, at Polycom’s expense, not later than thirty
(30) days after Polycom receives the defective product, and Polycom will retain risk of
loss or damage until the item is delivered to Customer.
EXCLUSIONS. Polycom will not be liable under this limited warranty if its testing and
examination disclose that the alleged defect or malfunction in the product does not
exist or results from:
Failure to follow Polycom’s installation, operation, or maintenance instructions.
Unauthorized product modification or alteration.
Unauthorized use of common carrier communication services accessed through the
product.
Abuse, misuse, negligent acts or omissions of Customer and persons under
Customer’s control; or
Acts of third parties, acts of God, accident, fire, lightening, power surges or
outages, or other hazards.
WARRANTY EXCLUSIVE. IF A POLYCOM PRODUCT DOES NOT OPERATE AS WARRANTED
ABOVE, CUSTOMERS SOLE REMEDY FOR BREACH OF THAT WARRANTY SHALL BE
REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT POLYCOM’S
OPTION. TO THE FULL EXTENT ALLOWED BY LAW, THE FOREGOING WARRANTIES AND
REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, TERMS,
OR CONDITIONS, EXPRESS OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW,
STATUTORY OR OTHERWISE, INCLUDING WARRANTIES, TERMS, OR CONDITIONS OF
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, SATISFACTORY QUALITY,
CORRESPONDENCE WITH DESCRIPTION, AND NON-INFRINGEMENT, ALL OF WHICH
ARE EXPRESSLY DISCLAIMED. POLYCOM NEITHER ASSUMES NOR AUTHORIZES ANY
OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE
SALE, INSTALLATION, MAINTENANCE OR USE OF ITS PRODUCTS.
SERVICE AGREEMENTS. Please contact your Polycom Authorized Reseller for
information about service agreements applicable to your product.
SOFTWARE SUPPORT. Polycom will provide support for software running on the
Product if all of the following conditions are satisfied:
The product is under warranty or is covered by a Polycom service contract;
The product is operating on a Polycom-approved partner platform; and
The product software is the current major version or the next preceding major
version (software revisions are labeled as “x.y.z,” with the first two digits
designating major versions).
The product software comes with 90-day software warranty, providing for
software updates (minor releases/bug fixes). To continue to receive support,
purchasing a maintenance contract is the most economical solution.
Requests for software support should be made through the Polycom Reseller from
whom the product was purchased.
LIMITATION OF LIABILITY. TO THE FULL EXTENT ALLOWED BY LAW, POLYCOM
EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN
CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL,
INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF
REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATA, OR
OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE,
INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION
OF ITS PRODUCTS, EVEN IF POLYCOM OR ITS AUTHORIZED RESELLER HAS BEEN
ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO
REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT POLYCOM’
S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF
ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.
DISCLAIMER. Some countries, states, or provinces do not allow the exclusion or
limitation of implied warranties or the limitation of incidental or consequential
damages for certain products supplied to consumers, or the limitation of liability
for personal injury, so the above limitations and exclusions may be limited in their
application to you. When the implied warranties are not allowed to be excluded in
their entirety, they will be limited to the duration of the applicable written warranty.
This warranty gives you specific legal rights which may vary depending on local law.
GOVERNING LAW. This Limited Warranty and Limitation of Liability shall be
governed by the laws of the State of California, U.S.A., and by the laws of the United
States, excluding their conflicts of laws principles. The United Nations Convention on
Contracts for the International Sale of Goods is hereby excluded in its entirety from
application to this Limited Warranty and Limitation of Liability. All rights reserved
under International and Pan-American Copyright Conventions. No part of the
contents of this manual may be copied, reproduced, or transmitted in any form or by
any means, or translated into another language or format, in whole or part, without
written consent from Polycom, Inc. Do not remove (or allow anybody else to remove)
any product identication, copyright or other notices. Polycom, the Polycom logo
design, and SoundStation are trademarks of Polycom, Inc. in the U.S. and various
other countries.
COPYRIGHT. All rights reserved under International and pan-American Copyright
Conventions. No part of the contents of this manual may be copied, reproduced, or
transmitted in any form or by any means, or translated into another language or
format, in whole or part, without written consent of Polycom, Inc.
Polycom® and the logo design are registered trademarks and Polycom SoundStation
Wireless Microphone is a trademark of Polycom, Inc. in the United States, and
various countries.
Do not remove (or allow any third party to remove) any product identification, copyright
or other notices.
SAFETY AND REGULATORY INFORMATION. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interferences received, including interference that may cause undesired
operation.
Note: This equipment is tested and complies with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
This PWM-10T is marked with the CE mark. This mark indicates compliance with
EC Directives 2006/95/EC and 2004/108/EC. A full copy of the Declaration of
Conformity can be obtained from Polycom Ltd., 270 Bath Road, Slough, Berkshire,
SL1 4DX, UK.
In accordance with Part 15 of the FCC Rules, the user is cautioned that any changes
or modifications not expressly approved by Polycom, Inc. could void the user’s
authority to operate the equipment.
Installation must be performed in accordance with all relevant national wiring rules.
L’Installation doit être exécutée conforment à tous les règlements nationaux
applicable au filage électrique.
The outlet to which this apparatus is connected must be installed near the
equipment and must always be readily accessible.
La prise électrique à laquelle l’appareil est branché doit être installée ps de l’
équipement et doit toujours être facilement accessible.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] sera conforme à la norme NMB-003 du
Canada.
Operating Temperature: 5°C ~ 35°C
Storage Temperature: -20°C ~ 60°C
Contact Information:
Please contact your Polycom Authorized Reseller for assistance.
http://www.polycom.com
Polycom, Inc. 4750 Willow Road, Pleasanton, CA 94588-2708 USA
1725-32400-001 Rev A
Polycom® Wireless Microphone Quick Start Guide
Polycom® Wireless Microphone Quick Start Guide
Polycom® Wireless Microphone Quick Start Guide
Parts List
Polycom Wireless Microphones connect to your Polycom
SoundStation VTX 1000, Polycom SoundStation2 EX, or Polycom
SoundStation IP 6000 conference phone, providing a high quality
extended audio pick-up range up to 30 feet from the conference phone.
The following items are included in your Polycom Wireless
Microphone package. If you are missing any items, contact your
Polycom Wireless Microphone reseller.
Wireless Microphone (2)
Power Adapter (2)
(Not shown: Country-Specic Power Cable)
Charging Cradle Receiver (2)
Adhesive Tape (2)
Mute/Unmute LED
Mute/Pair Button
Power On/Off Switch
Battery Door
Pair/Power LED
Charging Cradle Connector
Power Connector Jack
Status LED
Pair/Page Button
Features
Connecting the Receivers to the
Conference Phone
Charging the Wireless Microphones
Note: Polycom recommends that you fully charge the
microphones before you use them for the rst time. You can
charge the microphones while they are turned on or off.
You can charge the microphones using the charging cradle or the
power adapters. When you use the charging cradle, you can charge
one or both microphones. When charging completes, the Pair/Power
LED glows green.
To charge the microphones using the charging cradle:
1. Attach a power adapter to the charging cradle, and then plug the
power adapter into an electrical outlet.
2. Place the microphones in the charging cradle. Charging begins.
To charge the microphones using the power adapters:
Attach a power adapter to a microphone, and then plug the power
adapter into an electrical outlet. Repeat the process with the other
microphone, if needed. Charging begins.
1
Adhesive Tape
Receiver
Attach the adhesive tape to the receivers.
2Place the receivers on the
conference phone.
3Connect the receiver cables to the microphone
extension ports on the conference phone.
Arrow should point to
the outside rim of the
conference phone
4For best results, place the SoundStation conference phone in
the center of the table and place the wireless microphones at
each end of the table.
  • Page 1 1
  • Page 2 2

Polycom VTX 1000 Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues