Polycom VTX 1000 Mode d'emploi

Marque: Polycom

Modèle: VTX 1000

Taper: Mode d'emploi

Polycom® Wireless Microphone Quick Start Guide Polycom® Wireless Microphone Quick Start Guide

Polycom®

Wireless Microphone

Quick Start Guide

For use with Polycom SoundStation VTX 1000®,

Polycom SoundStation2TM EX and

Polycom SoundStation® IP 6000

Linking the Receivers and Microphones

Turning On the Microphone

After you charge the microphone, turn on the microphone so it can

establish a link with the receiver.

To turn on the microphone:

• Switch the Power On/Off switch on the bottom of the

microphone to the On position (the position marked with the “--”

symbol).

The microphone will establish a radio link with the receiver. When a link

is established, the Microphone Pair/Power LED and the Receiver

Status LED glow a solid green, and the microphone is ready to use.

If a link is not established, the Microphone Pair/Power LED and

the Receiver Status LED will ash green to indicate that the microphone

and receiver may not be paired. (To pair, see below.)

Pairing the Microphone and Receiver

Your microphones and receivers are automatically “paired” at the factory.

However, if the Microphone Pair/Power LED and the Receiver

Status LED ash green, you may need to re-pair the microphone and

receiver.

To pair the microphone and receiver:

1. Press and hold the Pair/Page button on the bottom of the receiver

for at least ve seconds, until the Receiver Status LED fast-ashes

green (“pairing” mode). The LED will fast-ash green for 30 seconds.

2. While the Receiver Status LED fast-ashes green, press and hold the

Mute/Pair button on the microphone for at least ve seconds, until

the Microphone Pair/Power LED glows solid green (“pairing”

mode). The microphone is ready to use.

Paging the Microphone

You can page a microphone to identify the microphone that is paired with

a particular receiver, or to locate a microphone.

To page a microphone:

• Press and release the Pair/Page button on the bottom of the

receiver. The paired microphone will beep and the Microphone

Pair/Power LED will glow red. To stop the microphone from

beeping, press the Pair/Page button again, or press the Mute/Pair

button on the microphone.

Warranty, Copyright, Safety Notices

LIMITED WARRANTY. Polycom warrants to the end user (“Customer”) that this

product will be free from defects in workmanship and materials, under normal use

and service, for one year from the date of purchase from Polycom or its authorized

reseller.

Polycom’s sole obligation under this express warranty shall be, at Polycom’s

option and expense, to repair the defective product or part, deliver to Customer

an equivalent product or part to replace the defective item, or if neither of the two

foregoing options are reasonably available, Polycom may, on its sole discretion,

refund to Customer the purchase price paid for the defective product. All products

that are replaced will become the property of Polycom. Replacement products or parts

may be new or reconditioned. Polycom warrants any replaced or repaired product

or part for ninety (90) days from shipment, or the remainder of the initial warranty

period, whichever is longer.

Products returned to Polycom must be sent prepaid and packaged appropriately for

safe shipment, and it is recommended that they be insured or sent by a method that

provides for tracking of the package. Responsibility for loss or damage does not

transfer to Polycom until the returned item is received by Polycom. The repaired or

replaced item will be shipped to Customer, at Polycom’s expense, not later than thirty

(30) days after Polycom receives the defective product, and Polycom will retain risk of

loss or damage until the item is delivered to Customer.

EXCLUSIONS. Polycom will not be liable under this limited warranty if its testing and

examination disclose that the alleged defect or malfunction in the product does not

exist or results from:

• Failure to follow Polycom’s installation, operation, or maintenance instructions.

• Unauthorized product modiﬁcation or alteration.

• Unauthorized use of common carrier communication services accessed through the

product.

• Abuse, misuse, negligent acts or omissions of Customer and persons under

Customer’s control; or

• Acts of third parties, acts of God, accident, ﬁre, lightening, power surges or

outages, or other hazards.

WARRANTY EXCLUSIVE. IF A POLYCOM PRODUCT DOES NOT OPERATE AS WARRANTED

ABOVE, CUSTOMER’S SOLE REMEDY FOR BREACH OF THAT WARRANTY SHALL BE

REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT POLYCOM’S

OPTION. TO THE FULL EXTENT ALLOWED BY LAW, THE FOREGOING WARRANTIES AND

REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, TERMS,

OR CONDITIONS, EXPRESS OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW,

STATUTORY OR OTHERWISE, INCLUDING WARRANTIES, TERMS, OR CONDITIONS OF

MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, SATISFACTORY QUALITY,

CORRESPONDENCE WITH DESCRIPTION, AND NON-INFRINGEMENT, ALL OF WHICH

ARE EXPRESSLY DISCLAIMED. POLYCOM NEITHER ASSUMES NOR AUTHORIZES ANY

OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE

SALE, INSTALLATION, MAINTENANCE OR USE OF ITS PRODUCTS.

SERVICE AGREEMENTS. Please contact your Polycom Authorized Reseller for

information about service agreements applicable to your product.

SOFTWARE SUPPORT. Polycom will provide support for software running on the

Product if all of the following conditions are satisﬁed:

• The product is under warranty or is covered by a Polycom service contract;

• The product is operating on a Polycom-approved partner platform; and

• The product software is the current major version or the next preceding major

version (software revisions are labeled as “x.y.z,” with the ﬁrst two digits

designating major versions).

• The product software comes with 90-day software warranty, providing for

software updates (minor releases/bug ﬁxes). To continue to receive support,

purchasing a maintenance contract is the most economical solution.

Requests for software support should be made through the Polycom Reseller from

whom the product was purchased.

LIMITATION OF LIABILITY. TO THE FULL EXTENT ALLOWED BY LAW, POLYCOM

EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY LIABILITY, WHETHER BASED IN

CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL,

INDIRECT, SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF

REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR DATA, OR

OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE,

INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE, OR INTERRUPTION

OF ITS PRODUCTS, EVEN IF POLYCOM OR ITS AUTHORIZED RESELLER HAS BEEN

ADVISED OF THE POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO

REPAIR, REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT POLYCOM’

S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES WILL NOT BE AFFECTED IF

ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.

DISCLAIMER. Some countries, states, or provinces do not allow the exclusion or

limitation of implied warranties or the limitation of incidental or consequential

damages for certain products supplied to consumers, or the limitation of liability

for personal injury, so the above limitations and exclusions may be limited in their

application to you. When the implied warranties are not allowed to be excluded in

their entirety, they will be limited to the duration of the applicable written warranty.

This warranty gives you speciﬁc legal rights which may vary depending on local law.

GOVERNING LAW. This Limited Warranty and Limitation of Liability shall be

governed by the laws of the State of California, U.S.A., and by the laws of the United

States, excluding their conﬂicts of laws principles. The United Nations Convention on

Contracts for the International Sale of Goods is hereby excluded in its entirety from

under International and Pan-American Copyright Conventions. No part of the

contents of this manual may be copied, reproduced, or transmitted in any form or by

any means, or translated into another language or format, in whole or part, without

written consent from Polycom, Inc. Do not remove (or allow anybody else to remove)

any product identiﬁcation, copyright or other notices. Polycom, the Polycom logo

design, and SoundStation are trademarks of Polycom, Inc. in the U.S. and various

other countries.

Conventions. No part of the contents of this manual may be copied, reproduced, or

transmitted in any form or by any means, or translated into another language or

format, in whole or part, without written consent of Polycom, Inc.

Polycom® and the logo design are registered trademarks and Polycom SoundStation

Wireless Microphone is a trademark of Polycom, Inc. in the United States, and

various countries.

Do not remove (or allow any third party to remove) any product identiﬁcation, copyright

or other notices.

SAFETY AND REGULATORY INFORMATION. This device complies with Part 15 of the FCC

Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device must

accept any interferences received, including interference that may cause undesired

operation.

Note: This equipment is tested and complies with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

This PWM-10T is marked with the CE mark. This mark indicates compliance with

EC Directives 2006/95/EC and 2004/108/EC. A full copy of the Declaration of

Conformity can be obtained from Polycom Ltd., 270 Bath Road, Slough, Berkshire,

SL1 4DX, UK.

In accordance with Part 15 of the FCC Rules, the user is cautioned that any changes

or modiﬁcations not expressly approved by Polycom, Inc. could void the user’s

authority to operate the equipment.

Installation must be performed in accordance with all relevant national wiring rules.

L’Installation doit être exécutée conformément à tous les règlements nationaux

applicable au ﬁlage électrique.

The outlet to which this apparatus is connected must be installed near the

equipment and must always be readily accessible.

La prise électrique à laquelle l’appareil est branché doit être installée près de l’

équipement et doit toujours être facilement accessible.

This Class [B] digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe [B] sera conforme à la norme NMB-003 du

Canada.

Operating Temperature: 5°C ~ 35°C

Storage Temperature: -20°C ~ 60°C

Contact Information:

Please contact your Polycom Authorized Reseller for assistance.

http://www.polycom.com

Polycom, Inc. 4750 Willow Road, Pleasanton, CA 94588-2708 USA

1725-32400-001 Rev A

Polycom® Wireless Microphone Quick Start Guide

Parts List

Polycom Wireless Microphones connect to your Polycom

SoundStation VTX 1000, Polycom SoundStation2 EX, or Polycom

SoundStation IP 6000 conference phone, providing a high quality

extended audio pick-up range up to 30 feet from the conference phone.

The following items are included in your Polycom Wireless

Microphone package. If you are missing any items, contact your

Polycom Wireless Microphone reseller.

Wireless Microphone (2)

Power Adapter (2)

(Not shown: Country-Specic Power Cable)

Charging Cradle Receiver (2)

Adhesive Tape (2)

Mute/Unmute LED

Mute/Pair Button

Power On/Off Switch

Battery Door

Pair/Power LED

Charging Cradle Connector

Power Connector Jack

Status LED

Pair/Page Button

Features

Connecting the Receivers to the

Conference Phone

Charging the Wireless Microphones

Note: Polycom recommends that you fully charge the

microphones before you use them for the rst time. You can

charge the microphones while they are turned on or off.

You can charge the microphones using the charging cradle or the

power adapters. When you use the charging cradle, you can charge

one or both microphones. When charging completes, the Pair/Power

LED glows green.

To charge the microphones using the charging cradle:

1. Attach a power adapter to the charging cradle, and then plug the

power adapter into an electrical outlet.

2. Place the microphones in the charging cradle. Charging begins.

To charge the microphones using the power adapters:

• Attach a power adapter to a microphone, and then plug the power

adapter into an electrical outlet. Repeat the process with the other

microphone, if needed. Charging begins.

Adhesive Tape

Receiver

Attach the adhesive tape to the receivers.

2Place the receivers on the

conference phone.

3Connect the receiver cables to the microphone

extension ports on the conference phone.

Arrow should point to

the outside rim of the

conference phone

4For best results, place the SoundStation conference phone in

the center of the table and place the wireless microphones at

each end of the table.

Polycom VTX 1000 Mode d'emploi

Marque: Polycom

Modèle: VTX 1000

Taper: Mode d'emploi

Télécharger le PDF

rapport

dans d''autres langues

English: Polycom VTX 1000 User guide

Polycom VTX 1000 Mode d'emploi

Polycom VTX 1000 Mode d'emploi

dans d''autres langues

Documents connexes

Autres documents