Mark Bass 001.086 Nano Mark II Minimark 802 N 300 Le manuel du propriétaire

Marque: Mark Bass

Modèle: 001.086 Nano Mark II Minimark 802 N 300

Catégorie: Équipement musical supplémentaire

Taper: Le manuel du propriétaire

OWNER’S MANUAL

v. 01.December.2020

Minimark 802 N 300

Nano Mark II

V.03.September.2022

IMPORTANT SAFETY INSTRUCTIONS

Read these instructions;

Keep these instructions;

Heed all warnings;

Follow all instructions;

Do not use this apparatus near water;

Clean only with dry cloth;

Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions;

Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including ampliers)

that produce heat;

Do not defeat the safety purpose of the polarized or ground-type plug. A polarized plug has two blades with one

wider than the other. A grounding type plug has two blades and a third grounding prong.

The wide blade or the third prong are provided for your safety. If the provided plug does not t into your outlet,

consult an electrician for replacement of the obsolete outlet;

10) Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the

point where they exit from the apparatus;

11) Only use attachments/accessories specied by the manufacturer;

12) Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer, or sold with the apparatus.

When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from the tip-over (and

Fig 21 DU Tipping Cart Symbol).

13) Unplug this apparatus during lightning storms or when unused for long periods of time;

14) Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any

way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus,

the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped;

15) “Warning: to reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture; and objects

lled with liquids, such as vases, should not be placed on this apparatus”;

16) To completely disconnect this apparatus from the AC mains, disconnect the power supply cord plug fron the AC

receptacle;

17) The mains plug of the power supply cord shall reamin readily accessible.

18) In case of voltage selector make sure the switch on the rear panel is on the correct voltage before connecting it to the

AC power, and the fuse is the right value for that voltage (This selector is not available on the 100V version).

Please change the voltage/fuse values label located near the voltage selector matching the voltage/fuse values when

you need to change the voltage of the apparatus.

19) “WARNING: this apparatus must be securely attached to the oor or wall in accordance with installation istruction.

Tipping, shaking, or rocking the machine may cause injury or death.”

PRÉCAUTIONS D’EMPLOI

1) Lire ces instructions;

2) Conserver ces instructions;

3) Suivre tous les conseils d’utilisations;

4) Suivre toutes les instructions;

5) Ne pas utiliser cet appareil au bord de l’eau;

6) Nettoyer uniquement avec un chion humide;

7) Ne pas bloquer le système de ventilation. Installer conformément aux instructions du fabricant;

Ne pas installer l’appareil près d’une source de chaleur tel qu’un radiateur, un fourneau, ou bien un autre appareil qui

produit de la chaleur;

9) Ne pas modier le système de sécurité de la che polarisée ou de de la che pour les prises de terre. Une che

polarisée a deux broches, l’une étant plus distante de l’autre. Une che pour prise de terre a deux broches et une

pointe pour la masse.

La broche plus distante et la pointe pour la masse ont été installées pour votre sécurité. Si la che fournie de rentre

pas dans votre prise de courant consulter un électricien pour la substitution;

10) Protéger le cordon d’alimentation an qu’il ne soit pas piétiné ou écrasé tout particulièrement au niveau des ches,

des prises de courant femelles, et des parties qui sortent de l’appareil;

11) Utiliser uniquement les accessoires recommendés par le fabricant;

12) Utilisez uniquement avec le chariot, le socle, le trépied, le support ou la table spéciés par le fabricant ou vendu avec

l’appareil.

Lorsque vous utilisez un chariot, soyez prudent lorsque vous déplacez l’ensemble chariot / appareil pour éviter toute

blessure du renversement (et la gure 21 DU Tipping panier Symbol).

13) Ne pas branché l’appareil en cas d’orage accompagné d’éclairs. Le débrancher en cas de non utilisation prolongée;

14) S’adresser à un service assistance agréé si l’appareil a subi des dommages, si le cordon d’alimentation ou la che a été

endommagé, si un liquide a été renversé sur l’appareil ou bien si un object est tombé dans l’appareil, si ce dernier a

été exposé à la pluie ou à l’humidité, s’il ne fonctionne pas correctement ou s’il est tombé;

15) “Avertissant: pour réduire le risque du feu ou de décharge électrique, n’exposez pas cet appareil à la pluie ou

l’humidité et les objets remplis de liquides; tels que des vases, ne devraient pas être placés sur cet appareil”;

16) Pour déconnecter totalement cet appareil du secteur, débranchez la cordon d’alimentation che de la prise secteur;

17) La prise de courant doit être facilement accessible.

18) En cas de sélecteur de tension s’assurer que l’interrupteur sur le panneau arrière est sur la bonne tension avant de le

raccorder à l’alimentation secteur et le fusible est la bonne valeur pour que la tension (Ce sélecteur n’est pas

disponible sur la version 100V). S’il vous plaît changer la tension / valeurs de fusibles étiquette située près du

sélecteur de tension correspondant aux valeurs /fusibles de tension lorsque vous avez besoin de changer la tension

de l’appareil.

19) “AVERTISSEMENT: cet appareil doit être assujetti au plancher ou au mur conformément aux instructions d’installation.

Le fait de l’incliner, de le balancer ou de l’agiter peut causer des blessures ou la mort.”

“To be used only

where the climate

is not tropical”

“The Lightning Flash with arrowhead symbol

within an equilateral triangle, is intended

to alert the user to the presence of uninsulated

“dangerous voltage” within the product enclosure

that maϐto constitute

a risk of shock to persons.”

“The exclamation point within an equilateral

triangle is intended to alert the user to the

presence of important operating and

maintenance (servicing) instructions in the

literature accompanying the product.”

“To be used only

with altitude

not exceeding 2000 m”

MORE INFORMATION

For warranty and service information, please contact your local Markbass distributor (contact information available at www.mark

bass.it). For more technical information, please visit us at www.markbass.it and ll out the form on the

Support page. We hope you enjoy your power amp and use it to make great music!

FRONT PANEL

1) UNBALANCED ¼” INPUT JACK

2) SOLID STATE GAIN

3) CLIP LED

4) LOW EQUALIZATION CONTROL KNOB

5) MID LOW EQUALIZATION CONTROL KNOB

6) MID HIGH EQUALIZATION CONTROL KNOB

7) HIGH EQUALIZATION CONTROL KNOB

8) MASTER VOLUME LEVEL KNOB

9) SCOOPED-MID EQ LED

10) MAIN ON/OFF SWITCH

1 2 3 4 5 6 7 8 109

REAR PANEL

11) AC POWER SOCKET

12) FOOTSWITCH INPUT

13) RETURN EFFECT ¼” JACK

14) SEND EFFECT ¼” JACK

15) PRE/POST EQUALIZATION CONTROL SWITCH

16) GROUND LIFT CONTROL SWITCH

17) LINE OUT XLR

18) SPEAKER OUT SPEAKON / ¼” COMBO JACK

11 12 13 14 15 16 17 18

TECHNICAL SPECS

INPUTS

INPUT: impedance 1 Mohm, max. voltage 15 Vpp

EFFECT RETURN: impedance 33 Kohm, max. voltage 10 Vpp

CONTROLS

GAIN: –60x dB to +23 dB range

PRE/POST EQ (for line out): switch on rear panel

GROUND LIFT: switch on rear panel

MASTER VOLUME

EQUALIZATION

LOW: center frequency: 60 Hz; level: ±16 dB

LOW MID: center frequency: 360 Hz, level: ±16 dB

HIGH MID: center frequency: 800 Hz, level: ±16 dB

HIGH: center frequency: 5 kHz, level: ±16 dB

OUTPUTS

LINE OUT: balanced XLR, max. voltage 10 Vpp

EFFECT SEND: unbalanced, max. voltage 20 Vpp (pre-EQ)

TUNER OUT: unbalanced, max. voltage 2 Vpp

SPEAKER OUT: speakon/1/4” combo

OTHERS

WEIGHT: 3.20 lbs / 1.45 kg

DEPTH: 8.27 in. / 21 cm

WIDTH: 7.87 in. / 20 cm

HEIGHT: 2.09 in. / 5.3 cm

OUTPUT POWER: 300W RMS @ 4 ohms,

150W RMS @ 8 ohms

BI-BAND LIMITER

OPTIONAL FOOTSWITCH: at/scooped MID/FSW EQ

BLOCK DIAGRAM

NANO MARK II

POWER REQUIREMENT

MULTIVOLTAGE 120V÷240V*

*(not available on the 100V version manufactured for Japan)

FUSE

EUROPE 3.15A 250V T 5x20

AUSTRALIA/UK 3.15A 250V T 5x20

USA/CANADA 6.3A 250V T 5x20

JAPAN 6.3A 250V T 5x20

Markbass oers an international limited warranty on Markbass products purchased from any authorized Markbass dealer, eective from the day of purchase. The terms of this warranty vary from

country to country; please contact the Markbass distributor in your country for details.

Please register this product online at www.markbass.it to establish the date of purchase. However, please note that you are required to retain a copy of your receipt as proof of purchase in order to

receive warranty service.

This warranty does not apply to any damage to the product caused by misuse, mishandling, accident, abuse, alteration, modication or unauthorized repairs. Product appearance and normal wear and

tear (worn paint, scratches, etc.) are not covered by this warranty. Markbass reserves the right to be the sole arbiter regarding the misuse or abuse of this product.

Markbass assumes no liability for any incidental or consequential damages, which may result from the failure of this product. Any warranties implied in fact or by law are limited to the duration of this

express limited warranty. Your legal rights related to the warranty will vary depending on the country of purchase.

WARRANTY CARD

This product is guaranteed by the warranty provided in the country of purchase, under the following conditions:

A - The Markbass warranty is only applicable if this document been properly completed (here or online) and if the original invoice/bill of sale, mentioning model, serial number and purchase date, is

presented together with this document.

B - The obligations of Markbass are limited to the repair of defects. Warranty repair eligibility will be decided at the sole discretion of Markbass or its representatives. Freight, freight insurance costs, and

any other costs related to the repair of this product are not covered by this warranty.

C - All warranty repairs must be made by Markbass or an authorized Markbass (PARSEK) service center.

D - This warranty does not apply in the following instances:

• if the damage was caused by accident, negligence or modications; use of non Markbass spare parts; or improper use, installation or packing;

• if the serial number on the equipment is illegible;

• if the damage was caused by lightning, water, re, incorrect main voltage, insucient ventilation or any other cause beyond the control of Markbass.

E - Markbass reserves the right to redesign or improve/modify its product at any time without any obligation to modify previously manufactured products.

Parsek srl. - Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52 - Tel. +39 085 446 37 55 - Fax +39 085 440 77 64 - www.markbass.it - [email protected]

LIMITED WARRANTY

We’d like to thank you for choosing a Markbass product.

If any problem occurs, please don’t hesitate to contact our support team at service@markbass.it.

You can ll out this form and send a copy to Markbass (Parsek srl, Via Po 52, 66020 San Giovanni Teatino, CHIETI ITALY) or, even better, you can now register your warranty online in a matter of

minutes, using our online registration form at www.markbass.it. Simply point, click and type in your information...and you’re done!

Registering your warranty identies you and your product, in case you are ever in need of warranty service. Please note that in order to qualify for warranty service, you must retain a copy of the

sales receipt or bill of delivery as proof of purchase.

The information that you provide here will not be shared with any third parties and will be used for Markbass internal business purposes only.

PRODUCT INFORMATION

Model _________________________ Serial Number _________________________

Date of Purchase _________________________(mm/dd/yyyy)

DEALER INFORMATION

Dealer _________________________ Dealer City _________________________ Dealer Country _________________________

PERSONAL INFORMATION

Purchased by:

First Name _________________________ Last Name _________________________ Your Email Address _________________________

Address _________________________ City _________________________ State/Prov _________________________

Zip _________________________ Country _________________________

Do you want to join our mailing list? Ƒ YES Ƒ NO

MORE INFO (* not mandatory)

*Age _________________________ *Sex _________________________ *Occupation _________________________

WHERE DO YOU PLAY YOUR INSTRUMENT?

Ƒ Stage / Performing Musician Ƒ School / Student Ƒ Classroom / Educator Ƒ Home Ƒ Studio Recording

WHAT LEVEL OF PLAYER ARE YOU?

Ƒ Beginner Ƒ Amateur Ƒ Semi-Professional Ƒ Professional

PRODUCT PURCHASED VIA:

Ƒ Internet Ƒ Retail Store

WHAT MOST INFLUENCED YOUR BUYING DECISION?

_________________________________________________________________________________________________________________________________________________________________

WARRANTY CARD