Durabook U11I Rugged Tablet 2-Bay Battery Charger Manuel utilisateur
- Taper
- Manuel utilisateur
©2023 Twinhead International Corp and/or its affiliates. All rights reserved.
1
U11I Rugged Tablet
2-Bay Battery Charger
P/N: 62+031130+01
2-Bay Battery Charger
2
Package Contents
If any of following items is damaged, please contact your retailer.
Battery Charger
Adapter
Power code
NOTE
The pictures are for reference only, actual items may slightly differ.
2-Bay Battery Charger
3
BATTERY CHARGER
With this external 2-bay battery charger, you can charge the approved batteries
directly without plugging them into the tablet.
About the Battery Charger
LED indicators
DC-OUT cable
Charging bays
DC-IN jack
LED Indicators
Icon
Item
LED Color and Status
/
Battery
indicator
Green
Charging complete
Orange
Battery charging
Red
Charging error
Off
No battery is inserted
❖ The Green LED lights up when the battery is at 95%
charged. For 100% fully charged pack, user will need to
leave the pack to be charged for longer.
Power indicator
Green
19V DC power is supplied
Off
No power supply
FRONT VIEW
REAR VIEW
2-Bay Battery Charger
4
Using the Battery Charger
1. Connect the charger unit to an electrical outlet using the power adapter.
2. Insert battery into the designated charging bay.
• The charger bay supports both main and second batteries. Once seated, it
can automatically determine the battery specification.
Charger has two charging bays and can support chain connection to another
charger using the attached DC-OUT cable, for at most up to total of 3 chargers.
When chargers are connected, the charging starts from the last charger of the
chain. (The charging sequence is shown in the right figure: 1-1, 1-2, 2-1, 2-2, 3-
1, 3-2)
Normal charging time will vary by the capacity of the battery pack.
▪ When charging the standard battery pack(s) on a single charger, the charging
time is approximately 2.5 hours.
▪ When charging two high-capacity battery packs on a single charger, the
charging time is approximately 3.5 hours for the first battery and 5 hours for
the second battery.
NOTE
Use only the designated power adapter (19V/65W) to avoid damage to
the charger.
Charging time may vary depending on the remaining battery capacity.
CHAIN CONNECTION
(Charging sequence)
2-Bay Battery Charger
5
Federal Communications Commission
Statement
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Warning: Operation of this equipment in a residential environment could
cause radio interference.
IC Regulations
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause
interference; and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d'en compromettre le fonctionnement.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conform à la norme NMB-003
du Canada.
Twinhead International Corp.
11F, No.550, Ruiguang Rd., Neihu, Taipei 11492, Taiwan, R.O.C.
-
1
-
2
-
3
-
4
-
5
