VTech Switch & Go® Triceratops Fire Truck Manuel utilisateur
- Catégorie
- Jouets d'apprentissage
- Taper
- Manuel utilisateur
Instruction Manual
Triceratops Fire TruckTriceratops Fire Truck
2
INTRODUCTION
Switch into fun with the Switch & Go® Triceratops Fire Truck.
Transform a cool Fire Truck into a Triceratops and back in just a
few simple steps. Launch the Water Burst and release the Rescue
Motorcycle. Let’s go!
Off/Low/High
Volume Selector
Rev-Up
Lever
Water Burst Button
LCD Screen
Voice Button
Launchpad
Motorcycle
Launcher
3
INCLUDED IN THE PACKAGE
• Switch & Go® Triceratops Fire Truck
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les
produits d’emballage tels que rubans adhésifs, feuilles de plastique,
attaches, étiquettes, cordons et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’utilisation car il comporte
des informations importantes.
WARNING
Do not aim at eyes or face. Do not discharge any object other than
the projectile provided with this toy.
ATTENTION
Ne viser ni les yeux ni le visage. Ne pas utiliser d’autres projectiles
que ceux fournis avec ce jouet.
NOTE
Please remove all the cable ties before playing Triceratops Fire Truck.
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit and use
a screwdriver to loosen the screw, then open the battery cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended.).
5. Replace the battery cover and tighten
the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
6
IMPORTANT : INFORMATIONS CONCERNANT LES
PILES
Les piles fournies avec le produit permettent de tester le jouet en
magasin mais ne sont pas des piles longue durée.
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-
carbone et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES :
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.
7
PRODUCT FEATURES
1. Off/Low/High Volume Selector
To turn the unit On or to adjust the volume,
slide the Off/Low/High Volume Selector to
the Low or High volume position. To turn
the unit Off, slide the selector to the Off
position.
2. Voice Button
Press the Voice Button to hear fun phrases
and cool dinosaur sounds in Dino mode. In
Vehicle mode, press the Voice Button to hear
fun phrases and cool fire truck sounds.
3. Water Burst Button
Insert the Water Burst into the Water
Launcher, the Light in the Water Launcher will
be activated, and then press the Water Burst
Button to launch the Water Burst.
4. Rescue Motorcycle
Pull out the Launchpad, and then activate
the Rev-Up Lever several times. Press the
Motorcycle Launcher lever to launch the
Rescue Motorcycle.
5. LCD Screen
The LCD Screen displays dino eye animations
in Dino mode and shows driver animations in
Vehicle mode.
8
6. LED Lights
The LED lights flash along with the sounds in
Dino mode and Vehicle mode.
7. AUTOMATIC SHUT-OFF
To preserve battery life, the Triceratops Fire Truck will
automatically shut off after approximately 20 seconds without
input. The unit can be turned on again by pressing the Voice
Button or by switching between Dino and Vehicle modes.
NOTE
If the unit powers down or if the light fades out during play, please
install a new set of batteries.
2. Rotate the crest down and
then push the head in.
Transformation
1. Begin in Dino mode.
Flip the horns and
close the jaw.
9
3. Adjust the water launcher
launcher backward.
4. Aim the water launcher
forward.
5. Flip up the tail. 6. Flip out the rear legs.
7. Flip the rear legs up. 8. Rotate the lower legs up.
10
9. Rotate the lower legs. 10. Flip the front legs up.
11. Rotate each front leg and
shoulder.
12. Flip the front bumpers out.
13. Push the front bumpers
and wheels in.
14. The unit is now in
Vehicle mode.
To switch back to Dino mode, reverse the steps above.
11
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to play again.
5. If the unit still does not work, install a new set of batteries.
12
IMPORTANT NOTE
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and filling
out our Contact Us form located under the Customer Support
link. Creating and developing VTech products is accompanied by
a responsibility that we take very seriously. We make every effort
to ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions you might
have. A service representative will be happy to help you.
NOTE
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
13
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5494
Product Name: Switch & Go® Triceratops Fire Truck
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-003(B)/NMB-003(B)
TM & © 2023 VTech Holdings Limited.
All rights reserved.
IM-549400-000
Version:0
Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
VTech Switch & Go® Triceratops Fire Truck Manuel utilisateur
- Catégorie
- Jouets d'apprentissage
- Taper
- Manuel utilisateur
dans d''autres langues
Documents connexes
-
VTech Switch & Go® 3-in-1 Rescue Rex Manuel utilisateur
-
VTech Switch & Go® Hatch & Roaaar Egg Triceratops Race Car™ Manuel utilisateur
-
VTech Switch & Go® Triceratops Roadster Manuel utilisateur
-
-
-
-
-
-
VTech Switch & Go® Velociraptor Race Car Manuel utilisateur
-