MC4
4-SeriesControl System
Product Information - 8538B
(2054549)
03.20
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/8489
For additional information on the Crestron® MC4, visit
www.crestron.com/model/6510432.
Pair with Apple® HomeKit® Technology
The MC4 can be paired with Apple® HomeKit® technology to enable
communication between the control system and Apple HomeKit
devices and accessories.
To pair the MC4 with an Apple HomeKit system, open the Apple Home
app on an iOS® device, and then use the device camera to scan the
QR code provided below.
NOTE: To ensure the control system is paired with the homeowner's
Apple HomeKit system, the QR code must be scanned by an iOS
device associated with the homeowner's Apple ID.
l For more information on pairing the device with an Apple HomeKit
system, refer to https://support.apple.com/en-us/HT204893.
l For more information on integrating the control system with
Apple HomeKit devices, refer to
www.crestron.com/Partners/Integrated-Partners/Apple.
Certification and Compliance
Regulatory Model: M201910001
IMPORTANT NOTE: To comply with ISED CANADA and FCC RF
exposure compliance requirements, the antenna used for this
transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
REMARQUE IMPORTANTE: Pour être conforme aux exigences de
conformité d’ISED CANADA et de la FCC en matière d’exposition aux
radiofréquences, l’antenne utilisée pour cet émetteur doit être
installée de manière à assurer une distance de séparation d’au moins
20 cm de toutes les personnes. toute autre antenne ou émetteur.
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment and receiver.
l Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
l Consult the dealer or an experienced radio/TV technician for help.
ISED Canada: This device contains licence-exempt transmitter
(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions: 1. This device may not cause
interference. 2. This device must accept any interference, including
interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : 1. L’appareil ne doit pas produire de brouillage; 2.
L’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
This product is listed to applicable UL® Standards and requirements
tested by Intertek® services.
Ce produit est homologué selon les normes et les exigences UL
applicables par Intertek Prestations de service.