CEN-IO Series
Wi-Fi® Network I/O Extenders
Product Information - 8534B
(2054545)
02.20
Getting Started
Scan the QR code to view the Quick Start Guide.
www.crestron.com/docs/7875
For additional information on the Crestron®
CEN-IO Series, visit the applicable product page at
www.crestron.com.
Certification and Compliance
Regulatory Model: CEN-IO
Federal Communications Commission (FCC)
Compliance Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following conditions:
(1) This device may not cause harmful interference
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
l Reorient or relocate the receiving antenna.
l Increase the separation between the equipment
and receiver.
l Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
l Consult the dealer or an experienced radio/TV
technician for help.
Please note that any modifications to the device
software or configuration, including but not limited
to the init file(s), can cause device performance to
vary beyond the scope of the currently referenced
FCC authorization. Accordingly, if any user
modifications are sought to be made to the device
software or configuration, the user may be
required to independently seek fresh FCC and other
regulatory authorizations as relevant prior to
distributing or marketing the devices or products
incorporating the same.
Industry Canada (IC) Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
This device contains licence-exempt transmitter
(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s
licence-exempt RSS(s).
Operation is subject to the following two
conditions:
1. This device may not cause interference.
2. This device must accept any interference,
including interference that may cause
undesired operation of the device.