Aube TH209/U Mode d'emploi

TH209

Non-programmable Thermostat

Owner’s

Guide

69-2771EF-07

69-2771EF_D.book Page -2 Wednesday, January 27, 2021 12:06 PM

Do you need assistance?

We are here to help.

For assistance with this product please call

Customer Care toll-free at

1-800-468-1502.

69-2771EF_D.book Page -1 Wednesday, January 27, 2021 12:06 PM

TH209

Table of Contents

About your new thermostat ......................................................1

Temperature display and setting............................................2

Removing the faceplate .............................................................3

Wiring ................................................................................................4

Installing the faceplate...............................................................5

Selecting the temperature display format..........................6

In case of difficulty.......................................................................7

Specifications.................................................................................8

3-year limited warranty ..............................................................9

69-2771EF_D.book Page 0 Wednesday, January 27, 2021 12:06 PM

OWNER’S GUIDE

1

About Your New Thermostat

This thermostat can be used to control an electric heating system

such as a baseboard heater or a convector.

The thermostat CANNOT be used with:

• a resistive load under 0.83 A

• a resistive load over 8.3 A

• a system driven by a contactor or a relay (inductive load)

• a fan-forced heating system (e.g. : fan-forced convector)

• a central heating system

SUPPLIED PARTS

• One (1) thermostat

• Two (2) 6-32 mounting screws

• Two (2) solderless connectors

69-2771EF_D.book Page 1 Wednesday, January 27, 2021 12:06 PM

TH209

2

Temperature Display and Setting

The thermostat normally displays the actual (ambient) temperature.

• To view the setpoint temperature, briefly press the Up or Down button. The setpoint

will be displayed for 5 seconds.

• To change the setpoint temperature, press the Up or Down button until the desired

value is displayed.

Temperature

display

Heating intensity

indicator

(No image appears

when heating is

off.)

Up button

Down

button

Appears when the

setpoint is

displayed

69-2771EF_D.book Page 2 Wednesday, January 27, 2021 12:06 PM

OWNER’S GUIDE

3

Removing the

Faceplate

TURN OFF POWER OF THE

HEATING SYSTEM AT THE

MAIN POWER PANEL TO

AVOID ELECTRIC SHOCK.

Loosen the screw holding

the faceplate to the base.

The screw cannot be

completely removed and

remains captive on the

base. Remove the faceplate

from the base by pulling the

bottom half.

69-2771EF_D.book Page 3 Wednesday, January 27, 2021 12:06 PM

TH209

4

Wiring

Connect either one of

the thermostat wires

to the heater wire and

the other one to the

power supply wire

using solderless

connectors for copper

wires.

NOTE: All cables and

connections

must conform

to the local

electrical code. Special CO/ALR solderless connectors must be

used when connecting with aluminum conductors.

2-wire installation 4-wire installation

Power supply

69-2771EF_D.book Page 4 Wednesday, January 27, 2021 12:06 PM

OWNER’S GUIDE

5

Installing the

Faceplate

Install the base onto

an electrical box.

Reinstall the faceplate

on the base and

secure it in place with

the screw.

NOTE: Keep the air vents of thermostat clean and unobstructed at

all times.

69-2771EF_D.book Page 5 Wednesday, January 27, 2021 12:06 PM

TH209

6

Selecting the Temperature Display Format

To select the temperature display format:

1. Press the Up and Down buttons for three seconds. The

format currently used will be indicated on the screen.

2. Press the Up or Down button to change the format.

3. P

ress

the Up and Down buttons

for one second (or wait

for one minute) to return to the normal display

.

69-2771EF_D.book Page 6 Wednesday, January 27, 2021 12:06 PM

OWNER’S GUIDE

7

Table 1. In Case of Difficulty

Problem Solutions

Thermostat is hot. This is normal.

Displayed

temperature is wrong. Remediate if any the following conditions exists:

The thermostat is exposed to air draft.

The sticker on the thermostat’s screen has not been removed.

The thermostat is located near or above a heat source such as a

light dimmer.

Display disappears

and reappears after a

few minutes.

The thermal protection device on the heater has temporarily

opened. This can happen if the heater is obstructed by furniture

or curtain and has overheated, or if the heater’s thermal

protection device is too sensitive.

69-2771EF_D.book Page 7 Wednesday, January 27, 2021 12:06 PM

TH209

8

Specifications

Supply: 120/208/240 VAC, 50/60 Hz

Minimum load:

0.83 A (resistive only)

200 W @ 240 VAC

100 W @ 120 VAC

Maximum load:

8.3 A (resistive only)

2000 W @ 240 VAC

1000 W @ 120 VAC

Display range: 0°C to 50°C (32°F to 99°F)

Setpoint range: 5°C to 30°C (40°F to 85°F)

Storage: -20°C to 50°C (-4°F to 120°F)

Permanent memory:

You do not need to adjust the temperature following a power

outage.

ICES-3 Class B Notice: This Class B digital apparatus complies with

Canadian ICES-3.

Energy Verified

Only

69-2771EF_D.book Page 8 Wednesday, January 27, 2021 12:06 PM

OWNER’S GUIDE

9

3-Year Limited Warranty

Resideo warrants this product to be free from defects in workmanship or materials,

under normal use and service, for a period of three (3) years from the date of first

purchase by the original purchaser. If at any time during the warranty period the product

is determined to be defective due to workmanship or materials, Resideo shall repair or

replace it (at Resideo’s option).

If the product is defective,

(i) return it, with a bill of sale or other dated proof of purchase, to the place from which

you purchased it; or

(ii) call Resideo Customer Care at 1-800-468-1502. Customer Care will make the

determination whether the product should be returned to the following address: Resideo

Return Goods, Dock 4 MN10-3860, 1985 Douglas Dr. N., Golden Valley, MN 55422, or

whether a replacement product can be sent to you.

This warranty does not cover removal or reinstallation costs. This warranty shall not

apply if it is shown by Resideo that the defect was caused by damage which occurred

while the product was in the possession of a consumer.

69-2771EF_D.book Page 9 Wednesday, January 27, 2021 12:06 PM

TH209

10

Resideo’s sole responsibility shall be to repair or replace the product within the terms

stated above. RESIDEO SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY

KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING,

DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR

IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT. Some states do not allow the

exclusion or limitation of incidental or consequential damages, so this limitation may

not apply to you.

THIS WARRANTY IS THE ONLY EXPRESS WARRANTY RESIDEO MAKES ON THIS

PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE

WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, IS

HEREBY LIMITED TO THE THREE YEAR DURATION OF THIS WARRANTY. Some states

do not allow limitations on how long an implied warranty lasts, so the above limitation

may not apply to you.

This warranty gives you specific legal rights, and you may have other rights which vary

from state to state. If you have any questions concerning this warranty, please write

Resideo Customer Care, 1985 Douglas Dr, Golden Valley, MN 55422

or call 1-800-468-1502.

69-2771EF_D.book Page 10 Wednesday, January 27, 2021 12:06 PM

OWNER’S GUIDE

This product is manufactured by Resideo Technologies, Inc. and its affiliates.

www.resideo.com

Resideo Technologies, Inc.

1985 Douglas Drive North, Golden Valley, MN 55422

1-800-468-1502

69-2771EF—07 M.S. Rev. 01-21 | Printed in United States

CAUTION: ELECTRONIC WASTE NOTICE

The product should not be disposed of with other household waste. Check for the

nearest authorized collection centers or authorized recyclers. The correct disposal of

end-of-life equipment will help prevent negative consequences for the environment and

human health.

69-2771EF_D.book Page 11 Wednesday, January 27, 2021 12:06 PM

TH209

Thermostat non programmable

Guide de

l’utilisateur

69-2771EF-07

69-2771EF_D.book Page -2 Wednesday, January 27, 2021 12:06 PM

Besoin d'aide?

Nous sommes là pour vous aider.

Pour obtenir de l’aide sur ce produit, joindre le service à

la clientèle en composant sans frais le 1-800-468-1502.

69-2771EF_D.book Page -1 Wednesday, January 27, 2021 12:06 PM

TH209

Table des matières

À propos du thermostat..............................................................1

Affichage et réglage de la température ...............................2

Enlever la façade...........................................................................3

Branchement..................................................................................4

Installer la façade .........................................................................5

Selectionner le format d’affichage de la température...6

En cas de difficulté.......................................................................7

Fiche technique.............................................................................8

Garantie limitée de 3 ans...........................................................9

69-2771EF_D.book Page 0 Wednesday, January 27, 2021 12:06 PM

GUIDE DE L’UTILISATEUR

1

À propos du thermostat

Ce thermostat a été conçu pour commander un appareil de

chauffage électrique tel qu’une plinthe chauffante ou un convecteur.

Ce thermostat NE PEUT être utilisé avec :

• une charge résistive inférieure à 0,83 A

• une charge résistive supérieure à 8,3 A

• un appareil muni d’un contacteur ou d’un relais (charge inductive)

• un appareil muni d’un ventilateur (exemple : ventiloconvecteur)

• un système de chauffage central

PIÈCES FOURNIES

• Un (1) thermostat

• Deux (2) vis de montage 6-32

• Deux (2) connecteurs sans soudure

69-2771EF_D.book Page 1 Wednesday, January 27, 2021 12:06 PM

TH209

2

Affichage et réglage de la température

Le thermostat affiche normalement la température mesurée (ambiante).

• Pour afficher la température de consigne, appuyer brièvement sur le bouton Haut

ou Bas. La température de consigne sera affichée pendant 5 secondes.

• Pour modifier la température, appuyer sur le bouton Haut ou Bas jusqu’à ce que la

valeur désirée apparaisse.

Indicateur de l’intensité

du chauffage. (L’absence

de l’image indique l’arrêt

du chauffage.)

Affichage de la

température Bouton

Haut

Bouton

Bas

Apparaît lorsque la

température de

consigne est affichée

69-2771EF_D.book Page 2 Wednesday, January 27, 2021 12:06 PM

GUIDE DE L’UTILISATEUR

3

Enlever la façade

METTRE LE SYSTÈME DE

CHAUFFAGE HORS TEN-

SION AFIN D’ÉVITER

TOUT RISQUE DE CHOC

ÉLECTRIQUE.

Desserrer la vis qui retient

la façade du thermostat à

la base. La vis ne peut être

complètement enlevée et

reste captive sur la base.

Séparer la façade de la

base en tirant sur la partie

inférieure du thermostat.

69-2771EF_D.book Page 3 Wednesday, January 27, 2021 12:06 PM

La page est en cours de chargement...

Aube TH209/U Mode d'emploi

Ce manuel convient également à

Aube TH209/U Mode d'emploi

dans d''autres langues

Documents connexes

Autres documents