SecurUS BLUtag Le manuel du propriétaire

https://v11.veritracks.comhttps://v11.veritracks.com

For 24/7 assistance, contact the STOP

®

Solutions Center

1-866-703-STOP (7867) | techsupport@stopllc.com

Active BluTag

&

VeriTracks 11

Active BluTag

&

VeriTracks 11

2

BluTag®

BluTag complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this

device must accept any interference, including interference that may cause undesired operation of the device.

RF Exposure (SAR) Statement for BluTag (S5E0114BLUT07).

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. It was tested as an ankle worn device in accordance

with the required FCC RF Exposure procedures. The maximum SAR value reported is 3.080 W/Kg for BluTag (S5E0114BLUT07)

WARNING – Changes or modifications to these units not expressly approved by the party responsible for compliance could void the user’s authority to operate

the equipment.

BluBox™ & BluHome™

BluBox and BluHome comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device.

RF Exposure Statement for BluBox™ (FCC ID S5EAA90548) and BluHome™ (FCC ID S5EBH0107A)

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must be

installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or

transmitter.

WARNING – Changes or modifications to these units not expressly approved by the party responsible for compliance could void the user’s authority to operate

the equipment.

Battery Safety

The BluTag Device contains a non-removable lithium-Ion battery. Do not attempt to remove the battery. Do not dispose of The BluTag or the lithium-Ion battery in

a fire. The lithium-Ion battery might present a fire or chemical burn hazard if mistreated. Do not disassemble, crush, or puncture the lithium-Ion battery or the

BluTag Device. Do not heat the battery or BluTag Device above 140°F (60°C).

Please return the Device to Satellite Tracking of People LLC, 1212 North Post Oak Road, Suite 100, Houston, Texas 77055 for disposal otherwise only dispose

of the battery or BluTag device in accordance with the laws and regulations in your area governing disposal of this type of battery.

3

Canadian Compliance (Industry Canada) for BluTag

IC: 9086A-BluT07, MODEL NUMBER: BluTag

This Class B digital apparatus complies with Canadian ICES-003

The BluTag Device has been designed to comply with applicable safety requirements for exposure to radio waves. The radio wave exposure guidelines

employ a unit of measurement known as the Specific Absorption Rate, or SAR. Tests for SAR are conducted according to RSS-102 with the BluTag device

transmitting at its highest certified power level in all used frequency bands. The highest SAR value for the BluTag when tested was 3.080W/Kg . The

BluTag device is designed to be ankle worn. Please follow the instructions included in the user guide for installation around the ankle.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not

cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

Conformité du Canada (Industrie Canada) pour BluTag

IC: 9086A-BluT07, NUMÉRO DU MODÈLE: BluTag

Le présent appareil numérique de Classe B est conforme à la norme canadienne ICES-003.

L'appareil BluTag a été conçu pour être conforme aux normes de sécurité applicables concernant l'exposition aux ondes radioélectriques. Les directives

d'exposition aux ondes radioélectriques utilisent l'unité de mesure connue sous le nom de Taux d'absorption spécifique ou TAS. Des tests de TAS ont été

exécutés conformément à la norme RSS-102 avec l'appareil BluTag émettant à son niveau de puissance certifié le plus élevé dans toutes les bandes de

fréquences utilisées. La valeur de TAS la plus élevée pour BluTag pendant le test était de 3.080 W/kg . L'appareil BluTag a été conçu pour être porté à la

cheville. Veuillez respecter les instructions relatives à l'installation de l'appareil à la cheville stipulées dans le guide de l'utilisateur.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux

conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,

même si le brouillage est susceptible d'en compromettre le fonctionnement.

SÉCURITÉ DES PILES

Les appareils BluTag contiennent une pile au lithium-ion non amovible. Ne pas tenter de retirer la pile. Ne pas jeter BluTag ou la pile au lithium-ion dans

un feu. La pile au lithium-ion présente un risque d'incendie ou de brûlure chimique en cas de mauvais traitement. Ne pas désassembler, écraser ni percer

la pile au lithium-ion ou l'appareil BluTag. Ne pas chauffer la pile ou l'appareil BluTag à des températures supérieures à 60 °C (140 °F).

Veuillez renvoyer l'appareil à Satellite Tracking of People LLC, 1212 North Post Oak Road, Suite 100, Houston, Texas 77055 U.S.A. pour élimination ou si

vous voulez vous charger vous-même de l'élimination de la pile ou de l'appareil BluTag, veuillez vous conformer aux lois et à la réglementation de votre

région régissant la mise au rebut de ce type de pile.

Table of

Contents

Table of

Contents

4

EnrollmentEnrollment

19 - 22

ZonesZones

23 - 30

SchedulesSchedules

31 - 41

InstallationInstallation

42 - 49

UnassignmentUnassignment

80 - 82

OverviewOverview

5 - 18

SupervisionSupervision

50 - 72

NotificationsNotifications

73 - 79

• BluTag Basics

• Battery Life

• Charging

• BluTag Specifications

• How GPS Works

• How BluTag Uses GPS

• Track Types

• How BluTag Uses Cellular

Communication

• VeriTracks Tracking Software

• Tile Totals

• The Update Available Bar

• Using the Find & Search Menus

OverviewOverview

5

 Lightweight (6oz), one-piece device

 Attempts GPS once every minute

 Calls every 10 minutes or less using

 Recharges in only one hour per day

 Or, 30 minutes twice daily

OverviewOverview

BluTag Basics

6

 40-60 hour battery capacity

 Multi-level battery alerts to enrollee and

agent

 Low – Approx. 10 hours left

 Vibrates twice every 10 minutes

until charged or completely dead

 Critical – Approx. 4 hours left

 Agent is alerted

 Dead – Approx. 20-30 min left

 Agent is alerted

 24-month+ battery life expectancy

OverviewOverview

Battery Life

7

 LED Charging Indicator

 Amber = Charging

 Green = Full

 Off = Idle

 Portable charging cradle (included)

 Optional charging accessories (additional

fees may apply):

 10-Unit Multicharger (for in-office preparation)

 Mobile Cradle (battery-powered charger)

 Automobile Charger

OverviewOverview

Charging

8

• Tamper-resistant, fiber optic

strap

• Status/Call Push Button

• Waterproof to 50 feet

• Memory capacity of 6+ days

• GPS Interference Detection

• Shielding Possible

• Jamming Possible

OverviewOverview

BluTag Specifications

9

OverviewOverview

How GPS Works

• GPS (Global

Positioning System)

is a constellation of

satellites that orbit

the Earth.

• Reception and

accuracy are best

when moving and

there is an open and

unobstructed view

of the sky.

• GPS tracking is

possible when at

least 3 satellites can

be heard.

10

 Begin charging BluTag at least 4 hours prior to the install.

 Charge BluTag in an area where it can also acquire GPS.

• If GPS is not available, acquire GPS elsewhere for at least 45 minutes.

• Though GPS might be present within the first few minutes of exposure - for optimal

performance, allow BluTag time to update its almanac prior to use.

Important:

• Do not leave BluTags charging for more than two weeks.

• Avoid charging in the heat of direct sunlight.

OverviewOverview

Preparing BluTag for GPS

11

• BluTag

attempts to

acquire GPS

once every

minute.

OverviewOverview

How BluTag Uses GPS

12

Type Description Example

Trackpoint A successful attempt to track BluTag’s location at a

particular minute. Attempts are made once each minute.

Visit Five or more consecutive minutes of tracks, no greater

than 300 feet and 2 minutes apart.

Visit Point A track within a Visit.

Cell Tower When GPS reception is unavailable for one or more

minutes, a successful approximation of a responding cell

tower’s location may be displayed.

Cell Track When 5 or more minutes of Cell Tower Tracking has

occurred, an approximation of BluTag’s direction in

reference to the Cell Tower may appear.

Five types of tracks may be displayed that indicate BluTag’s approximate location.

OverviewOverview

13

Track Types

• Nationwide cellular coverage

• BluTag waits only 10 minutes between calls

• However, any of the following will produce an immediate call:

• Request Position (below): Requests an immediate call/upload

• Rapid Reporting (below): Makes calls occur every 2 minutes for 1 hour.

• Push Button: Pressing BluTag’s button until it beeps forces it to call

• All other events/violations, i.e. charging, zone violations, strap tampers, etc.

• Online requests can command BluTag to buzz (beep) or vibrate

OverviewOverview

How BluTag Uses Cellular Communication

Buzz

Vibrate

Rapid

Reporting

Request

Position

14

VeriTracks Tracking Software

• Universal software for all hardware

• Web-based application (nothing to install)

• Phone & Tablet-friendly

• Google maps

• Multi-shape, private, global, and hidden zone options

• Crime Scene Correlation

OverviewOverview

15

Tile Totals

Tile totals reflect the following:

OverviewOverview

16

Enrollee

Number of assigned enrollees for the selected agency

Events

Number of open events

Zones

Number of existing zones (assigned & unassigned)

Reports

Number of processed reports

The Update Available Bar

The Update Available bar displays above enrollee cards when an update is

available for an enrollee listed on the current page of cards.

Clicking the bar is optional, as updated enrollee data will display upon

navigating between tabs and tiles.

Do not click the Update Available bar while viewing unsaved data. By doing

so, unsaved data will be lost.

OverviewOverview

17

Find / Search menus remember

their settings from session to

session. Therefore, to return to the

default criteria:

1. Click the Find or Search menu.

2. Click the Clear button to reset

the criteria to its defaults.

3. Click Find.

OverviewOverview

18

Using the Find & Search Menus

Each Tile has its own Find / Search menu. Each is designed to display results that

are based on default search criteria or that chosen by the agent.

1

2 3

EnrollmentEnrollment

• Creating an Enrollee Profile

• Adding Enrollee Addresses

19

1. Click the Enrollees tile.

2. Click Add.

3. Fill in the required fields: Primary ID,

First Name, and Last Name.

4. Confirm or change the Organization,

Agent, and Risk Level.

5. Click Save.

EnrollmentEnrollment

Creating an Enrollee Profile

3

4

20

5

La page charge ...

SecurUS BLUtag Le manuel du propriétaire

SecurUS BLUtag Le manuel du propriétaire

dans d''autres langues

Autres documents