Topband 24GA4D Remote Controller Manuel utilisateur

Marque
Topband
Modèle
24GA4D Remote Controller
Taper
Manuel utilisateur
1 set
Packing List：
Remote controller
User manual 1 set
Remote controller
User Manual
This user manual is applicable to A4D product model. Please read this manualcarefully and
keep it properly before using the product.
CAUTIONS AND NOTE
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the followingtwo conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesiredoperation of the device.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct
theinterference by one or more of the following measures:
□Reorient or relocate the receiving antenna.
□Increase the separation between the equipment and receiver.
□Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
□Consult the dealer or an experienced radio/TV technician for help.
This appliance has a polarized plug (one blade is wider than the other).As a safety
feature, this plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug.If it still does not fit, contact a qualified electrician. Do not
attempt to defeat this safety feature.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference,and (2) this device
must accept any interference received, including interference that may cause undesired
operation. 1
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptibled’en compromettre le fonctionnement.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety
precautions should always be followed, including the following:
DANGER – To reduce the risk of electrocution:
4.Do not place in or drop into water or other liquid.
3.Do not place or store appliance where it can fall or be pulled into a tub or sink.
2. Do not use while bathing.
5.Do not reach for an appliance that has fallen into water. Unplug immediately
1. Always unplug this appliance immediately after using.
WARNING – To reduce the risk of burns, electrocution, fire, or injury to persons:
1. An appliance should never be left unattended when plugged in.
7. Never use while sleeping.
2. Close supervision is necessary when this appliance is used by, on, or near children or
individuals with certain disabilities.
3. Use this appliance only for its intended use as described in this manual.Do not use
attachments not recommended by the manufacturer.
6. Never block the air openings of the appliance or place it on a soft surface,such as a
bed or couch, where the air openings may be blocked. Keep the air openings free of
lint, hair, and the like.
4. Never operate this appliance if it has a damaged cord or plug,if it is not working
properly, or if it has been dropped, damaged,or dropped into water.Return the
appliance to a service center for examination and repair.
5. Keep the cord away from heated surfaces. Do not wrap the cord around the
appliance.
8. Never drop or insert any object into any opening or hose.
9. Do not use outdoors or operate where aerosol (spray) products are being used or
where oxygen is being administered.
10. Do not use an extension cord with this appliance.
11. Household use only.
1. Do not direct hot air toward eyes or other heat sensitive areas.
2. Attachments may be hot during use. Allow them to cool before handling.
3. Do not place appliance on any surface while it is operating.
4. While using the appliance, keep your hair away from the air inlets.
5. Do not operate with a voltage converter.
SAVE THESE INSTRUCTIONS
2
READ ALL INSTRUCTIONS BEFORE USING
5-speed temperature display
3-stage wind speed
adjustment
5-speed temperature
adjustment
Power off
This symbol represents“Do not use this device in a bathtub,shower,or water-filled reservoir”
Product introduction
3
Telescopic rod
Remote control
placement
Base
Power cable
Negative ion release display
3-stage wind speed display
OF F
1. Press the power button .the mood light turn on, and you will hear a "beep".
Quickly to start on-o ffbutton .the hair dryer is on.
Installation guide
Touchable area
OFF OF F
1
2
1
2
2. Press the button to illuminate the screen ,then you can adjust the hair
1
dryer with the remote controller.
You can press the button to close the hair dryer when the screen is on.
11
If the hair dryer is not powered on, please check whether the connection between the rod and the base is tightened.
CR 2032 button battery
please note “+”is upward
Pull out while pressing the
left side to extract the
battery compartment. Push in the compartment and
you can use it normally
When the dryer is powered on normally, if the remote control has power but cannot control the hair dryer, please re-
pair the remote control as follows:
Prepare：Make sure the hair dryer is powered on and the power
button switch is pressed
Press the ffbutton of the
remote control
Note:When the battery is replaced, if the remote controller can not control the hair dryer, please re-connect with the main body
Remote controller Re-Connect
The instructions of remote controller battery replacement
Abnormal status operation guide
Press and hold the button for about 3
seconds, the hair dryer will make a "beep"
sound, the mood light will flash, you can
let go at this time.
After the hair dryer receives the pairing signal
from the remote control, the mood light changes
from blinking to steady light, the hair dryer starts
to blow hot air, and the pairing is successful.
If the display does not light up after the remote control is turned on, the battery may be insufficient. Please
replace the battery as follows:
4
OFF
Specification
Product name
Product model
Rated voltage
Date of manufacture
Remote controller
A4D
3V
See commodity for details
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Topband 24GA4D Remote Controller Manuel utilisateur

Marque
Topband
Modèle
24GA4D Remote Controller
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents