• Be sure to disconnect the plug of the microwave oven from the electrical outlet

before installing the Builtin Kit. Remove the turntable from the oven cavity.

• The kit includes metal parts, due caution should be used in handling and

installation to avoid the possibility of injury.

• Do not remove permanently afxed labels, warnings or plates from the

product. Doing so may void the warranty.

The electrical requirements for this oven are 115-120 volts AC, 15 amps or larger.

Scissors Tape measure

T15H Torx driver

CENTER

LINE

A

A

A

C

P3

P2

P6

P8P7

P4

A : 5 1/8" (130 mm)

B : 6 7/8" (175 mm)

C : 9 3/8" (238.5 mm)

D : 8 23/32" (221.3 mm)

P5

P6

P7

P8

1. Folding the underline of Template

2. Folding the topline of Template and

CUTOUT DIMENSIONS

Height 16 3/4" ± 1/16"

Width 25 1/2" ± 1/16"

Depth 21 1/2" ± 1/16"

TRIM DIMENSIONS

To avoid risk of electrical shock, personal injury, or death:

• Before drilling into the wall, note where electrical outlets are and where

• Locate and disconnect the power to any electrical circuits that could be

To avoid personal injury, wear gloves when handling the metal parts. Parts are

sharp and can cause cuts and abrasions.

4. Tight 2 screws together on the

Install hook by using provided

SCREW A. (2 EA)

You may not be assembled when using

the thicker Drill bit.

1. Remove 4 screws from the lower

2. Plug the Power cord into the

3. Tight 2 screws to Duct base and

Be aware when you put a oven into the

cabinet because cabinet may be moved.

Align the Center with cabinet

4. Tight 4 screws to Duct base and

Duct side on the left side by using

provided SCREW C. (4 EA)

5. Remove 2 Screw C on top of the

back. In addition, Remove 1 Torx

Screw to use Torx driver on bottom

of the back. Do not scrap Screw.

(3 EA)

6. Tight a Torx Screw and 3 Screw C

on top of the back.

2. Open the oven door. Tight 4 screws

5. Tight Install Bracket 4 holes by

using provided SCREW A. (4 EA)