August 2023
QSG1_A_EN
Quick Start Guide
@ReolinkTech https://reolink.com
58.03.001.0351
Apply to：
B800W
English English1 2
What's in the Box ··················································· 2
Camera Introduction ···············································3
Connection Diagram ···············································4
Access the NVR via Smartphone or PC ······························6
Mount Tips for the Camera ·········································7
Troubleshooting ···················································· 8
Specication ·······················································9
Notication of Compliance ·········································9
What's in the Box
EN
Contents
Waterproof Lid
Bullet Camera
Mounting Hole
Template
1m Ethernet
Cable
Camera Power
Adapter
Surveillance
Sticker
Quick Start
Guide
Pack of
Screws
Power Extension
Cable
English English3 4
Connection Diagram
1.Connect the included power adapter to the NVR and a power outlet.
2.Connect the NVR to your router with an Ethernet cable (if you hope
to use it remotely).
Next, connect the mouse to the USB port of the NVR.
3.Connect the NVR to the monitor with a VGA or HDMI cable.
NOTE: There is no VGA cable and monitor included in the package.
HDMI
VGA
NVR
Router
1
2
3
4
Camera Introduction
1
4
3
2
5
6
7
10
8
9
11 12
Antenna
Mount
Metal Aluminum Case
Spotlight
IRLEDs
High Denition Lens
Network Port
Daylight Sensor
Reset Button
Built-in Mic
Power Port
Speaker
1
2
3
4
5
6
10
7
11
8
12
9
* Press for about 10
seconds to restore the
device to factory
settings.
English English5 6
4.Follow the steps on the monitor to complete the initial setup.
NOTE: In the second step, UID is disabled by default. You’re
recommended to enable it for remote access on smartphones or
computers. Or you can set it later in “Settings > System >Info”.
5.Power on your WiFi Cameras and connect them to the LAN ports
(for IPC) on the NVR via Ethernet cables.
6.Click Sync WiFi Info to connect the cameras to the NVR’s WiFi.
7.After the sychronization succeeded, remove the Ethernet cables
and wait for a few seconds for them to be reconnected wirelessly.
installedatthedesiredlocation.
NOTE: There is no NVR included in the package.
8.Afterthewirelessconnectionissuccessful,thecameracanbe
Sync Wi-Fi info
NVR
Router
• On Smartphone
Scan to download the Reolink App.
• On PC
Download path: Go to https://reolink.com > Support > App & Client.
1. Connect the NVR to a router using the included Ethernet cable.
2.Download and launch the Reolink App or Client and follow the
instructions to access the NVR.
Access the NVR via Smartphone or PC
English English7 8
Mount Tips for the Camera
• Do not face the camera towards any light sources.
• Do not point the camera towards a glass window. Or, it may result in
poor image quality because of the window glare by infrared LEDs,
ambient lights or status lights.
• Do not place the camera in a shaded area and point it towards a
well-lit area. Or, it may result in poor image quality. To ensure best image
quality, the lighting condition for both the camera and the capture object
shall be the same.
• To ensure better image quality, it’s recommended to clean the lens with
a soft cloth from time to time.
• Make sure the power ports are not directly exposed to water or
moisture and not blocked by dirt or other elements.
• With IP waterproof ratings, the camera can work properly under
conditions like rain and snow. However, it doesn't mean the camera can
work underwater.
• Do not install the camera at places where rain and snow can hit the lens
directly.
• The camera may work in extreme cold conditions as low as -10°C.
Because when it is powered on, the camera will produce heat. You may
power on the camera indoors for a few minutes before installing it
outdoors.
Installation Tips
NOTE: Please install the cameras within the NVR’s signal range.
Troubleshooting
Solutions:
• Cover the camera’s IR LEDs to see if they light up.
• lf you have a 12V power adapter, power up the camera with the power
adapter.
Cause 1：Camera is not Powering on
Solution:
Login to the NVR, go to Settings > Channel page and click Modify to input
the correct password for the camera. lf you forget your password, please
reset your camera to reset the password to default (blank).
Solution:
GotoSettings> Channelpage, clickthechannelyouwant, andthense-
lectyour cameraforthatchannel.If all channels are already in use,
please delete the oine camera from the NVR. Then the channel this
camera was taken is free now.
Camera Not Displaying lmages on the Monitor
Cause 2：Incorrect Account Name or Password
Cause 3：Camera is not Assigned to a Channel
English English9 10
Solutions:
• Connect the camera to the NVR with an Ethernet cable. Go to Network
> Wi-Fi > Settings on the monitor to sync the NVR’s WiFi.
• Install the camera within the NVR’s signal range.
• Install antennas on the camera and the NVR.
If these won‘t work, please contact Reolink
Support https://support.reolink.com
Cause 4：No WiFi After Removing the Ethernet Cable
Specication
Operating Temperature:
-10°C to 55°C (14°F to 131°F)
Operating Humidity: 10%-90%
B800W Size: Φ67 x 187mm
Weight: 485.7g, for B800W
For more Specications, visit https://reolink.com/.
Camera
Notication of Compliance
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
English English11 12
Caution: Changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your
body.
This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada’s
licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
L’ émetteur/récepteur exempt de licence contenu dans le présent
appareil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L’ exploitation est autorisée aux deux conditions suivantes :
(1) L’ appareil ne doit pas produire de brouillage;
(2) L’ appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
FCC Radiation Exposure statement
ISED Compliance Statements
ISED Radiation Exposure statement
WiFi Operating Frequency
This equipment complies with IC RSS-102 radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20 cm between the radiator and
your body.
Cet équipement est conforme aux limites d’exposition aux radiations IC
CNR-102 établies pour un environnement non contrôlé. Cet équipement
doit être installé et utilisé avec une distance minimale de 20 cm entre
le radiateur et votre corps. Cet émetteur ne doit pas être colocalisé ou
fonctionner en conjonction avec une autre antenne ou un autre émetteur.
Operation of 5150-5250 MHz is restricted to indoor use only.
Le fonctionnement de 5150-5250 MHz est limité à une utilisation en
intérieur uniquement.
OPERATING FREQUENCY :
2.4 GHzEIRP< 20dBm 5 GHzEIRP< 20dBm 5.8GHz EIRP< 14dBm
Reolink declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU and
Directive 2014/30/EU.
Simplied EU Declaration of Conformity
The functions of Wireless Access Systems including Radio Local
Area Networks(WAS/RLANs) within the band 5150-5350 MHz for
this device are restricted to indoor use only within all European
English13
UKCA Declaration of Conformity
Reolink declares that this product is in compliance with Electromagnetic
Compatibility Regulations 2016 and Electrical Equipment Safety
Regulations 2016.
Union countries (BE/BG/CZ/DK/DE/EE/IE/EL/ES/FR/HR/ IT/CY/LV/LT/
LU/HU/MT/NL/AT/PL/PT/RO/SI/SK/FI/SE/TR/N O/CH/IS/LI/UK(NI)
This marking indicates that this product should not be disposed with other
household wastes.throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmentally safe recycling.
Correct Disposal of This Product
This product comes with a 2-year limited warranty that is valid only if
purchased from Reolink Ocial Store or a Reolink authorized reseller.
Learn more: https://reolink.com/warranty-and-return/.
Limited Warranty
Use of the product is subject to your agreement to the Terms of Service
and Privacy Policy at reolink.com. Keep out of reach of children.
Terms and Privacy
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
dans d''autres langues
- English: REOLINK B800W User guide
Documents connexes
-
REOLINK RLN12W 4K WiFi 6 12 Channel Security System Mode d'emploi
-
REOLINK 2012A Manuel utilisateur
-
-
REOLINK RLC-523WA Mode d'emploi
-
-
-
-
REOLINK RLC-810A Manuel utilisateur
-
REOLINK RLC-520 Manuel utilisateur
-
REOLINK E1 Outdoor Mode d'emploi