lawn, to avoid any bumps and scratches. First, lay out all your pieces and

washer and bolt sets [W] - double

check you’re using the correct

bolts. You need 12 sets of washers

and bolts [W] in total for one stool.

Don’t fully tighten all the bolts

until all the parts are in place. Once

everything is connected, tighten

with the Allen key provided, but

take care not to over-tighten.

TABLE: STEP 1

Place the tabletop [A] face-down

leg frame [B] using 4x bolt and

washer sets [R].

Don’t fully tighten any of the bolts

until all the parts are in place.

TABLE: STEP 3

table onto its feet. Then, very

carefully lower the tempered glass

table top onto the frame. Your

tabletop. Use 1x bolt + washer

Once everything is connected

correctly, go ahead and tighten all

the bolts with the Allen key provided,

but take care not to over-tighten.

set [Q] on one side of the hole and

secure with washer + nut set [S] on

the other side of the hole. Repeat

as illustrated across the 4 holes.