A4L | 01
GENERAL SAFETY The assembly pack contains small parts
which can pose a choking hazard to children and pets. Place on
solid and even ground.
Only use in an upright stable position.
Do not overload the product as this may result in damage to the
product or personal injury.
LPG GAS WARNINGS
LP gas is ammable and hazardous if handled improperly.
Propane Characteristics:
Flammable, explosive under pressure, heavier than air, and settles
in pools in low areas. In its natural state, propane has no odour.
For your safety, an odourant is typically added. Contact with
propane could burn the skin.
Propane is extremely ammable and hazardous if handled
improperly.
LP GAS WARNINGS
Cylinders must be stored outdoors in a well-ventilated area out of
reach of children.
Disconnected cylinders must have threaded valve plugs tightly
installed and must not be in a building, garage or any other
enclosed area.
Never use a propane cylinder with a damaged body, valve, collar
or footing.
Dented or rusted propane cylinders may be hazardous and should
be checked by your propane gas supplier.
LP gas tank must be arranged for vapor withdrawal.
The LP gas tank must have a tank collar to protect the tank valve.
Never use an LP gas tank with a damaged body, valve, collar, or
footing. Dented or rusted LP gas tanks may be hazardous and
should be checked by your LP gas supplier prior to use.
The LP gas tank should not be dropped or handled roughly.
Tanks must be stored outdoors out of the reach of children. Do not
store in a building, garage, or any other enclosed area.
Never store your LP gas tank where temperatures can reach over
125°F/50 °C.
Do not store the LP gas cylinder in direct sunlight or near a source
of heat or combustion.
Never keep a lled LP gas tank in a hot car. Heat will cause the
gas
pres-sure to increase, which may open the relief valve and allow
gas to escape.
Place a dust cap on valve outlet whenever the LP gas tank is not
in use. Only install the type of dust cap on the LP gas tank valve
outlet that is provided with the LP gas tank valve. Other types of
caps or plugs may result in leakage of propane.
Do not store a spare LP gas cylinder under or near this appliance.
Never ll the LP gas cylinder beyond 80% full.
If the information is not followed exactly, a re causing death or
serious injury may occur.
LP gas cylinders should be lled only by a certied LP gas dealer.
The pressure regulator is set for the gas pressure of the local state
Regulator outlet pressure is in line with the gas pressure of the
local state.
Never attempt to attach this appliance to the self-contained LP
gas system of a camper trailer, motor home or house.
Always use the pressure regulator and hose assembly provided
with the appliance to connect to a LP gas cylinder. Never connect
to an unregulated LP gas supply.
Hand turn the manual gas control valve. Never use tools. If the
valve will not turn by hand, do not try to repair it. Call a certied
gas technician. The use of force or any self attempted repair may
result in a re or explosion.
Use only the type of gas and the type of LPG cylinder specied by
the manufacturer.
Appliance is tted with gas regulator, exible gas rubber pipe and
clamps..
Appliance must use an approved gas regulator (approved for a
working temperature not lower than 125°F/50 °C)
When a replacment is necessary, you have to purchase a suitable
gas regulator, exible gas rubber pipe and clamps from your local
gas dealer; gas regulator should be replaced before 10 years use.
Never use a damaged gas regulator.
Never connect this appliance to an unregulated LPG source (gas
regulator is mandatory to be used).
When the appliance is not in use, turn the LPG cylinder in “OFF”
position.
Always perform a leakage test on gas connections whenever a
LPG cylinder is connected. If bubbles form in
Flexible gas rubber pipe must be located in the LPG compartment
carefully, avoiding any twisting.
Never use a damaged gas regulator.
Always perform a leakage test on gas connections whenever a
LPG cylinder is connected. If bubbles form in the leakage test
solution, do not use it. Never use a ame to test for leakages. It is
strictly forbidden and dangerous.
Always change the gas cylinder in an amply ventilated area, away
from any ignition source.
REGULATOR & HOSE
These items are not supplied with the Fire Pit but are available
separately.
Use only regulators and hoses intended for use with LPG at
the pressures indicated above. The service life of a regulator is
estimated at 10 years. It is recommended that you change the
regulator 10 years after its date of manufacture.
The hose should be changed when national regulations require. It
is recommended that you change the hose 5 years after its date
of manufacture.
Using an unsuitable regulator or hose is dangerous. Ensure that
the products that you have are suitable for use with your Fire Pit.
The hose used must comply with the standards in force in the
country of use. The hose must be a minimum of 0.6 metres long
and a maximum of 1.5 metres. A damaged regulator or hose must
be replaced. Ensure that the hose is not blocked, kinked or in con-
tact with any part of the barbecue other than the connection point.
LEAKAGE TESTING
This appliance needs to be periodically checked for leakages
and an immediate check is required if the smell of gas is
detected.
Make a soap solution using 1 part of liquid dish-washing soap
to 3 parts water. The soap solution can be applied with a soap
bottle, brush, or rag to the leakage tested points shown in the
gure beside.
The valve of the LPG cylinder should be in the “OFF” position at
this point of the leakage test. Once the soapy solution is applied
to the gas connections, the valve of the LPG cylinder needs to
be turned to the “ON” position.
Soap bubbles will begin to form in the soapy solution if any
leakage is present.
In the event of gas leakage, the appliance must not be used.
The gas supply must be shut-o and the appliance must be
investigated and rectied before it is used again. Tighten any
leaking ttings, then turn on gas supply and recheck.
If necessary, substitute gasket (according to EN 549 Class B2)
or material used to guarantee tightness (according to EN 751-1
Class I).
CLEANING & MAINTENANCE Do not clean the product with any
abrasive cloths or chemicals. Solvents or detergents can cause
damage to the surface.
Periodically check and re-tighten ttings where necessary.
To clean, sponge down with warm water, a soft cloth and mild
detergent.
Airow must be unobstructed. Keep controls, burner and
circulation air passageways clean. Signs of possible blockage
include:
Gas odour with extreme yellow tipping of ame / Appliance glow
is excessively uneven / Appliance makes popping noises.
Spiders and insects can nest in burner or orices. This can cause
damage to the appliance and render it unsafe for use. Clean
burner holes by using a heavy duty pipe cleaner. Compressed air
may help clear away smaller particles.
Carbon deposits may create a re hazard. If any carbon deposits
develop, clean dome and engine with warm soapy water.
After the burner and lava rocks are completely cooled down,
remove it from the bowl and use a soft brush to get rid of the mild
stains, loose dirt and soil. Wipe with a soft cloth. Clean the bowl
and afterward put lava rocks again in proper position.
STORAGE AFTER USE
Store the appliance indoors only if the cylinder has been
disconnected and removed. If the appliance is not used for a long
period, it should be stored under the Weather Protector supplied
in a dry, dust-free location.
Ensure you have all the pieces listed. If you are missing any
components, contact our customer services department at
DO NOT proceed with assembly if any components are
missing.
TECHNICAL SPECIFICATION
Types of gas Butane Gas
Gas Category I3+(28-30/37)
Heat input (Hs) 13 kW(946.4g/h)
Gas pressure G30 at 28-30mbar, G31
at 37mbar
Injector diameter (Ø) 1.84 mm
Gas regulator Certied regulator according to
EN12864 (ow rate: max. 1.5kg/h)
Gas hose Certied gas hose according to
applicable EN-standard (max3.0m)
Gas cylinder Standard gas cylinder
(recommend to
use 5kg)
Types of gas LPG Gas mixture
Gas Category I3B/P(30)
Heat input (Hs) 13 kW(946.4g/h)
Gas pressure G30/G31 at 30mbar
Injector diameter (Ø) 1.84 mm
Gas regulator Certied regulator according to
EN12864 (ow rate: max. 1.5kg/h)
Gas hose Certied gas hose according to
applicable EN-standard (max3.0m)
Gas cylinder Standard gas cylinder
(recommend to
use 5kg)
Types of gas LPG Gas mixture
Gas Category I3B/P(37)
Heat input (Hs) 13 kW(946.4g/h)
Gas pressure G30/G31 at 37mbar
Injector diameter (Ø) 1.74 mm
Gas regulator Certied regulator according to
EN12864 (ow rate: max. 1.5kg/h)
Gas hose Certied gas hose according to
applicable EN-standard (max3.0m)
Gas cylinder Standard gas cylinder
(recommend to
use 5kg)
Types of gas LPG Gas mixture
Gas Category I3B/P(50)
Heat input (Hs) 13 kW(946.4g/h)
Gas pressure G30/G31 at 50mbar
Injector diameter (Ø) 1.59 mm
Gas regulator Certied regulator according to
EN12864 (ow rate: max. 1.5kg/h)
Gas hose Certied gas hose according to
applicable EN-standard (max3.0m)
Gas cylinder Standard gas cylinder
(recommend to
use 5kg)
EN
INTENDED USE WARNING! The product is for outdoor use only.
DO NOT use indoors. This product should NOT be used in motor
homes, tents, sheds or any similar locations where ventilation is
limited. Use only in an uncovered, well ventilated area. Position
on a suitable heat-resistant surface such as a concrete patio slab.
This product is not intended as a climbing structure and it is not a
toy. Children should be supervised to ensure that they do not play
with the product. Keep children and pets away from the product
at all times when cooling. Flammable materials and heat-sensitive
items should be kept away from the product during use and when
cooling. Keep loose tting clothing away and long hair tied back.
Do not overload the product.
IMPORTANT SAFETY INFORMATION
IMPORTANT: Pay close attention to all warnings and instructions
provided with any lighting equipment/fuels. Always keep a re
extinguisher, garden hose, or bucket of sand nearby to smother
the re if necessary.
NEVER SMOKE NEAR A GAS CYLINDER
This product is designed for outdoor use, well away from any
ammable material. Ensure that
any item located above the appliance cannot obstruct it and that
both sides and the front of the
appliance are at least 1 metre from any item that could impede its
operation. Ensure that the
appliance’s ventilation holes are not obstructed. the product
should be place on a at, stable
surface. The product should be protected from direct draughts
and bad weather (rain, etc.).
WARNING! DANGER OF CARBON MONOXIDE POISIONING.
Do not light this product or let it smoulder or cool down in
conned spaces. Do not use under awnings, parasols or gazebos.
Never handle charcoal after lighting. Always use the Poker
provided. Always use the Mesh Guard when a re is lit.
WARNING! The product will become extremely hot during use
and cannot be moved. To avoid injury, be aware that the resting
surface directly underneath the product will become very hot
during operation and will remain hot for some time afterwards.
Keep feet, other limbs and all property/items well away from this
area.
To avoid burns, do not touch metal parts of the product until it
has completely cooled. Handles will become very hot and unsafe
to touch during use, unless you are wearing rated protective
gear (pot holders, thermal proof mittens, hot pad etc). Standard
household oven gloves will NOT oer sucient protection and
should not be used. Hot embers may be emitted during use.
Never leave a burning re unattended.Extinguish immediately after
use. Do not splash water over a re to extinguish as the resulting
smoke can cause eye/respiratory irritation. Carefully douse using
a suitable extinguishing medium, keeping sucient distance for
safety. The product may appear cool but may still be retaining
dangerous heat. Exercise extreme caution when handling.
Ensure the coals have completely burnt before removing the ash.
Do not dump ashes where they could start a re. Always dispose
of ashes in a proper receptacle.
The product should only be moved and stored when it has
completely cooled and all ammable materials have been
extinguished and disposed of safely.
Store away ONLY when the product is completely extinguished
and cool. This may take some time after use.
BEFORE FIRST USE Follow each step of the assembly as
outlined by the steps in this Instruction Manual.
Assemble close to the products intended position.
Locate the product in a suitable area where it will not create an
obstruction. Locate away from sources of combustion.