FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC SAR
Exposure to Radio Frequency Energy (SAR) To maintain compliance with FCC RF
exposure guidelines when you carry this device on your body, use only belt clips, holsters or
similar accessories that have no metallic component in the assembly. Use of other non-
approved accessories might violate FCC RF exposure guidelines. This equipment has been
evaluated as a body worn device with 0 cm separation and complies with FCC radiation
exposure limits set forth for an uncontrolled environment. In order to comply with FCC RF
exposure safety guidelines, the antenna(s) used for this transmitter must not transmit
simultaneously with any other antenna or transmitter, except in accordance with FCC multi-
transmitter product procedures. The user of this device should ensure that the operation of
this device is in compliance with these provisions.