Otterbox 77-89452 Manuel utilisateur

Taper
Manuel utilisateur
2 in 1 Power Stand with Magsafe
SKU # 77-89452
RMN# OBFTC-0120-A
United States:
FCC Compliance:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help
FCC RF EXPOSURE COMPLIANCE:
This certified solution complies with the FCC portable RF exposure limits set forth for an uncontrolled
environment and are safe for intended operation as described in the User manual. Further RF exposure
reduction can be achieved if the product can be kept as far as possible from the user body or set the
device to lower output power if such function is available.
2 in 1 Power Stand with Magsafe
SKU # 77-89452
RMN# OBFTC-0120-A
Canada:
ISED COMPLIANCE STATEMENT: This Certified Solution contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada’s license-exempt RSS(s). Operation of the Certified Solution is subject to the following
two conditions: (1) This Certified Solution may not cause interference; and (2) This Certified
Solution must accept any interference, including interference that may cause undesired
operation of the Certified Solution.
DÉCLARATION DE CONFORMITÉ D’ISDE : Cette solution Certifiée contient un ou des
émetteurs/récepteurs exempts de licence conformes aux RSS exempts de licence d'Innovation,
Sciences et Développement économique Canada. Le fonctionnement de la Solution certifiée est
soumis aux deux conditions suivantes : (1) Cette Solution Certifiée ne doit pas provoquer
d'interférences ; et (2) Cette Solution Certifiée doit accepter toute interférence, y compris les
interferences susceptibles d'entraîner un fonctionnement indésirable de la Solution Certifiée.
IC RF EXPOSURE COMPLIANCE: The product complies with the Canada portable RF exposure limit set
forth for an uncontrolled environment and is safe for intended operation as described in the user
manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible
from the user body or set the device to lower output power if such function is available.
Déclaration d'exposition aux radiations: Le produit est conforme aux limites d'exposition pour les
appareils portables RF pour les Etats-Unis et le Canada établies pour un environnement non contrôlé.
Le produit est sûr pour un fonctionnement tel que décrit dans le manuel de l’utilisateur. La réduction
aux expositions RF peut être augmentée si l'appareil peut être conservé aussi loin que possible du corps
de l'utilisateur ou que le dispositif est réglé sur la puissance de sortie la plus faible si une telle fonction
est disponible.
Verified Energy Performance:
2 in 1 Power Stand with Magsafe
SKU # 77-89452
RMN# OBFTC-0120-A
European Declaration of Conformity:
2 in 1 Power Stand with Magsafe
SKU # 77-89452
RMN# OBFTC-0120-A
UKCA Declaration of Conformity:
2 in 1 Power Stand with Magsafe
SKU # 77-89452
RMN# OBFTC-0120-A
Taiwan RoHS Compliance:
設備名稱
: 行動電源
Equipment Name: 2 in 1 Power Stand with
Magsafe
型號(型式)
: OBFTC-0120-A
Type Designation: OBFTC-0120-A
單元
Unit
限用物質及其化學符號
Restricted Substances and its Chemical Symbols
Lead
(Pb)
Mercury
(Hg)
Cadmium
(Cd)
六價鉻
Hexavalent
Chromium
(Cr+6)
多溴聯苯
Polybrominated
Biphenyls
(PBB)
多溴二苯
Polybrominated
Diphenyl Ethers
(PBDE)
電池Battery
O
O
O
O
O
O
電路板PCBA
-
O
O
O
O
O
塑膠Plastics
O
O
O
O
O
O
五金Metal
O
O
O
O
O
O
電纜Cable
O
O
O
O
O
O
備考
1.〝超出0.1 wt %〞及〝超出0.01 wt %〞係指限用物質之百分比含量超出百分比含量基準
Note 1: “Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicate that the percentage content of the restricted substance exceeds the reference percentage value
of presence condition.
備考
2.〝o〞係指該項限用物質之百分比含量未超出百分比含量基準
Note 2: “○” indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence.
備考
3.〝-〞係指該項限用物質為排除項目。
Note 3: The “−” indicates that the restricted substance corresponds to the exemption
WEEE:
This symbol on the product and/or accompanying documents means that used electrical and electronic products
should not be mixed with general household waste. For proper treatment, recovery and recycling, please take this
product to a designated collection point where it will be accepted free of charge. Alternatively, in some countries
you may be able to return your product to your local retailer upon purchase of an equivalent new product.
Disposing of this product correctly will help save valuable resources and prevent any potential negative effects on
human health and the environment, which could otherwise arise from inappropriate waste handling. Please
contact your local authority for further details of your nearest designated collection point.
2 in 1 Power Stand with Magsafe
SKU # 77-89452
RMN# OBFTC-0120-A
IMPORTANT SAFETY INSTRUCTIONS
1. Do not drop, disassemble, open, crush, bend, deform, puncture, shred, microwave, incinerate, paint,
submerge in a liquid, or insert foreign objects into the power bank.
2. Keep power banks out of the reach of children. Children should be supervised when a power bank is in
use.
3. Do not expose power banks to heat or fire.
4. Do not store in direct sunlight or in a vehicle.
5. Do not use or charge a damaged power bank.
6. In the event of a power bank leaking, keep away from skin and eyes. Wash any affected area with large
amounts of water and seek medical attention.
7. Power banks need to be charged before use. Always use the correct cable and refer to the power bank
manufacturer’s instructions for proper charging instructions. Do not use any cable other than that
specifically provided or recommended by the power bank manufacturer. Do not use a damaged cable to
charge or discharge a power bank.
8. Do not leave a power bank on prolonged charge when not in use. Disconnect the power bank from the
charging source once full.
9. Observe the dedicated input and output ports for receiving and providing power on the power bank and
the device to be charged to ensure correct use.
10. Do not use any power bank which is not designed for use with the device you wish to charge. Refer to the
device’s manual for proper charging instructions.
11. When possible, detach cable(s) from power bank when not in use.
12. Only use the power bank in the application for which it was intended.
13. Store the power bank in a cool, dry place when not in use.
14. When a power bank is not used for prolonged periods, the power bank should be charged periodically to
maintain power bank life.
15. Dispose of power bank properly.
Keep all instructions provided with the power bank for future reference.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Otterbox 77-89452 Manuel utilisateur

Taper
Manuel utilisateur

dans d''autres langues