Chief PAC715 Guide d'installation

Catégorie
Mur
Taper
Guide d'installation

Ce manuel convient également à

INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Video Conferencing Shelf
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
PAC715
PAC715 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
DEFINITIONS
MOUNTING SYSTEM: A MOUNTING SYSTEM is the
primary Chief product to which an accessory and/or component
is attached.
ACCESSORY: AN ACCESSORY is the secondary Chief
product which is attached to a primary Chief product, and may
have a component attached or setting on it.
COMPONENT: A COMPONENT is an audiovisual item
designed to be attached or resting on an accessory or mounting
system such as a video camera, CPU, screen, display,
projector, etc.
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
IMPORTANT SAFETY INSTRUCTIONS!
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all mounting systems/
accessories are properly assembled and installed using the
instructions provided.
WARNING: Failure to provide adequate structural strength
for this accessory can result in serious personal injury or
damage to equipment! It is the installers responsibility to
make sure the structure to which this accessory is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
accessory.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all equipment and accessories mounted on the PAC715 does
not exceed 10 lbs (4.54 kg).
WARNING: RISK OF INJURY TO PERSONS! Do not use
this accessory to support video equipment such as
televisions or computer monitors.
WARNING: Do not use this accessory outdoors.
--SAVE THESE INSTRUCTIONS--
DIMENSIONS
9.00
228.6
4.33
110.1
8.77
222.8
9.00
228.6
6.88
174.6
1.90
48.3
3.25
82.6
1.125 INCREMENTS
28.6
0.27
6.8 0.125
3.2
8.77
222.8
8.47
215.2
0.98
25
MINIMUM EXTENSION
14.56
369.8
10.27
260.9
MAXIMUM EXTENSION
Installation Instructions PAC715
3
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Phillips Screwdriver
Destornillador Phillips
Kreuzschlitzschraubendreher
Chave de fendas Phillips
Cacciavite a stella
Kruiskopschroevendraaier
Tournevis à pointe cruciforme
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
By Hand
A mano
Von Hand
Com a mão
A mano
Met de hand
À la main
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Pencil Mark
Marcar con lápiz
Stiftmarkierung
Marcar com lápis
Segno a matita
Potloodmerkteken
Marquage au crayon
Drill Hole
Perforar
Bohrloch
Fazer furo
Praticare un foro
Gat boren
Percez un trou
Adjust
Ajustar
Einstellen
Ajustar
Regolare
Afstellen
Ajuster
Remove
Quitar
Entfernen
Remover
Rimuovere
Verwijderen
Retirez
Optional
Opcional
Optional
Opcional
Opzionale
Optie
En option
Security Wrench
Llave de seguridad
Sicherheitsschlüssel
Chave de segurança
Chiave di sicurezza
Veiligheidssleutel
Clé de sécurité
PAC715 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
5/32" 1/4"
#2
A (1)
B (2) C (4)
[Video conferencing shelf]
1/4-20"
1/4-20 x 3/4"
D (1)
[medium faceplate adapter]
F (1)
1/4-20 x 3/8"
Installation Instructions PAC715
5
Installation
NOTE: The PAC715 video conferencing shelf can be mounted
before or after the display is mounted to the faceplate.
It may be mounted above or below the display if
mounting to a large faceplate. It may only be mounted
above the display if mounting to a medium faceplate.
NOTE: The PAC715 may also be installed to center of the
PAC722 accessory. See "Attach to PAC722 Center"
Section.
Attach to Large Faceplate
1. Position video conferencing shelf (A) above or below the
faceplate making sure to line up the holes on the shelf with
the holes on the faceplate. (See Figure 1 or 2)
2. Install two 1/4-20 x 3/4" button head cap screws (B) through
holes in shelf and faceplate. (See Figure 1 or 2)
3. Thread two 1/4-20" lock nuts onto screws to secure shelf to
faceplate. (See Figure 1 or 2)
Figure 1
Figure 2
Attach to Medium Faceplate
NOTE: The PAC715 may only be mounted above the display
when mounting to a medium faceplate.
1. Use two 1/4-20" lock nuts (C) to secure medium faceplate
adapter (D) to top or bottom of medium faceplate. (See
Figure 3)
2. Thread two 1/4-20" lock nuts (C) onto screws to secure
shelf to medium faceplate adapter (D). (See Figure 3)
Figure 3
1
(A)
3
(B) x 2
(C) x 2
2
faceplate
(top installation)
large
(bottom installation)
(B) x 2
2
faceplate
3
(C) x 2
1
(A)
large
(A)
2
(C) x 2
(D)
1
(C) x 2
medium
faceplate
PAC715 Installation Instructions
6
Attach to PAC722 Center
The PAC722 accessory has two threaded holes in the center
section which allows the PAC715 shelf to be mounted to it.
1. Install PAC722 accessory and displays following the
PAC722 installation instructions.
2. Position video conferencing shelf (A) above the center of
PAC722 making sure to line up the holes on the shelf with
the holes on the PAC722. (See Figure 4)
3. Install two 1/4-20 x 3/4" button head cap screws (B) through
holes in shelf and PAC722. (See Figure 4)
Figure 4
Camera Mounting
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all equipment and accessories mounted on the PAC715 does
not exceed 10 lbs (4.54 kg).
NOTE: Mounting options will vary depending on the type of
camera being mounted.
1. Install 1/4-20 x 3/8" Phillips pan machine screw (F) through
holes on shelf and into hole on bottom of camera. (See
Figure 5)
NOTE: Camera can be secured to mount by threading a tie
through outside slots on camera mount and around the
camera.
NOTE: It is also acceptable to mount the camera directly to the
shelf without any screws or ties.
Figure 5
Adjustments
Height Adjustment
1. Loosen two adjustment knobs on the back of the video
conferencing shelf (A). (See Figure 6)
2. Raise or lower shelf to desired height. (See Figure 6)
3. Tighten two adjustment knobs on the back of the shelf until
mount is secure. (See Figure 6)
Figure 6
(A)
(B) x 2
3
camera (example)
(F)
1
123
Installation Instructions PAC715
7
Shelf Extension Adjustment
1. Loosen two button head cap screws on video conferencing
shelf (A). (See Figure 7)
2. Adjust shelf to desired mounting position. (See Figure 7)
3. Tighten two button head cap screws on shelf until mount is
secure. (See Figure 7)
Figure 7
123
PAC715 Installation Instructions
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P800.582.6480 / 952.225.6000
F877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P+31 (0) 495 580 852
F+31 (0) 495 580 845
Asia Pacific A Office No. 918 on 9/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P852 2145 4099
F852 2145 4477
Chief, a products division of
Milestone AV Technologies
8807-002000 Rev05
2016 Milestone AV Technologies
www.milestone.com
07/16
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief PAC715 Guide d'installation

Catégorie
Mur
Taper
Guide d'installation
Ce manuel convient également à

dans d''autres langues