Kodak T20 Manuel utilisateur

T20 AutoCamera

Consumer Imaging

EASTMAN KODAK COMPANY

Rochester, NY 14650

Kodak

ENGLISH/ESPAÑOL/FRANÇAIS

User’s Manual

Pt. No. 20230091

New 11/02

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause

undesired operation.

NOTE: Your model camera has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits provide

reasonable protection against interference in residential use. The camera generates, uses

and can radiate radio frequency energy and, if not used in accordance with the instructions,

may cause interference to radio communications. There is no guarantee that interference

will not occur. If this camera does cause interference to radio or television reception, which

can be determined by turning the camera off and on, you may reduce the interference by

the following:

— Reorient or relocate the receiving antenna.

— Increase the separation between the camera and the receiver.

— Consult the dealer or an experienced radio/television technician for help.

Changes or modifications not approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

This Class B digital apparatus meets all requirements of the Canadian Interference-

Causing Equipment Regulations.

1

ENGLISH

KODAK ADVANTIX

NEED HELP WITH YOUR CAMERA OR MORE

INFORMATION ABOUT THE ADVANCED PHOTO SYSTEM?

Visit our Web site at http://www.kodak.com (for US) or

http www.kodak.ca (for Canada) or call: Kodak (US only) from

9:00 a.m. to 7:00 p.m. (Eastern time) Monday through Friday

at 1-800-242-2424.

Kodak (Canada only) from 8:00 a.m. to 5:00 p.m. (Eastern time)

Monday through Friday at 1-800-465-6325, ext. 36100; for the

Toronto area, call 416-766-8233, ext. 36100.

Have your camera available when you call.

For warranty purposes, keep your sales receipt as

proof of the date of purchase.

T20 Auto Camera

2

CONTENTS

CAMERA IDENTIFICATION..... 3

CAMERA FEATURES .............. 6

ATTACHING THE STRAP ....... 8

LOADING THE BATTERIES .... 9

Low-batteries indicator....... 10

Battery tips......................... 10

Power shutdown ................ 12

LOADING THE FILM.............. 12

TAKING PICTURES .............. 14

Typical print sizes

(formats).......................... 16

Tips for better pictures ....... 17

TAKING FLASH PICTURES .. 18

Flash-to-subject distance ... 19

UNLOADING THE FILM ........ 19

Automatic rewind ............... 19

Manual rewind ................... 20

CARING FOR

YOUR CAMERA .................. 21

TROUBLESHOOTING ........... 22

SPECIFICATIONS ................. 24

3

CAMERA IDENTIFICATION

1 shutter button

2 LCD panel

3 picture counter

4 battery symbol

5 viewfinder

6 flash

7 lens-cover switch

8 lens

9 film-door lever

1

3

6

2

7

8

5

9

4

10 print-format

switch

11 viewfinder

eyepiece

12 film-rewind button

13 flash-ready lamp

14 strap post

11

12

10

13

14

5

15 film chamber

16 film door

17 tripod socket

18 battery door

15

17

16

18

6

CAMERA FEATURES

Three Print Formats

• Choose from 3 picture sizes:

Classic (C), Group/HDTV (H),

or Panoramic (P). The masking

inside the viewfinder changes to

match each format selection.

Double Exposure Protection (DEP)

• You don’t need to worry about

accidentally re-exposing your

film. Your camera reads the Film

Status Indicator (FSI) on the film

cassette to prevent double

exposures.

Easy, Drop-in Loading

• Easy, drop-in loading is fast and

virtually error-free. The camera

uses KODAK ADVANTIX Film.

The film cassette communicates

the status of film and becomes

the carrier and storage container

for the processed film.

Safety-Locked Film Door

• The safety interlock on the film

door prevents the door from

opening before the film is

completely rewound.

7

Film Status Indicator (FSI)

• An indicator advances from one

symbol to another to identify the

status of the film inside the

cassette.

4

3

2

1

Processed negatives

Unexposed

Partially exposed

Fully

exposed

Look for this logo to be certain that the film you

buy is made for this camera.

Look for this logo to select a certified photofinisher

for developing your film and to assure that you get

all the features of the Advanced Photo System.

8

ATTACHING THE STRAP

Thread the strap’s shorter looped

end under the strap post (14). Pull

the longer end through the shorter

loop and pull it tight.

NOTE: You can use the knob on

the clasp of the camera strap to

actuate the buttons on the camera.

9

LOADING THE BATTERIES

This camera uses 2 AAA-size

alkaline batteries that supply power

for all camera operations.

NOTE: Insert the batteries before

you load the film.

1. Open the battery door (18).

2. Place the batteries over the

battery-pull strap and insert into

the chamber as shown.

3. Close the battery door.

NOTE: Before you remove the old

batteries, slide the lens-cover

switch (7) to turn off the camera.

10

Battery tips

• Dispose of batteries according

to local and national regulations.

• Keep spare batteries with you at

all times.

• Keep batteries away from

children.

• Store the batteries in their

original packaging prior to use.

• Remove the batteries when you

store the camera for an

extended time.

• Do not use rechargeable

batteries.

• Replace both batteries at the

same time with the same brand

and alkaline type.

Low-batteries indicator

It’s time to replace the batteries

when the battery symbol (4)

appears in the LCD panel (2) or

when the flash-ready lamp (13)

takes longer than 12 seconds to

turn on.

11

CAUTION: Do not put the batteries

in your pocket or in a container that

contains coins or metal objects.

If the batteries touch the metal

objects, they may short circuit,

discharge energy, become hot,

or leak.

CAUTION: Do not try to take apart,

recharge or short circuit the

batteries, or subject them to high

temperature or fire.

WARNING: In the unlikely event

that battery fluid leaks onto your

skin, rinse immediately with plenty

of water. For additional information,

contact Kodak Health, Safety and

Environment Information in the U.S.

at 1-585-722-5151. Customers

outside the U.S. can contact their

local health care provider.

WARNING: In the unlikely event

that battery fluid leaks inside the

camera, U.S. customers can

contact the Kodak Information

Center (KIC) at 1-800-242-2424.

Customers outside the U.S. can

contact their local Kodak Customer

Service representative.

12

LOADING THE FILM

You can load film with the camera

on or off.

Power shutdown

To conserve battery power, the

camera automatically goes to sleep

after 4 minutes of nonuse. To wake

up the camera, take a picture or

close and reopen the lens cover.

Turn off the camera when it is not

in use to further extend the

battery life.

NOTE: Insert the batteries before

you load the film.

1. Push the film-door lever (9)

to open the film door (16).

13

3. Close the film door to start the

automatic film prewind.

• The picture counter (3) in the

LCD panel (2) displays the

number of pictures remaining

on the film.

• After you close the safety-

interlocked film door and the

film starts to prewind, you

cannot open the door until the

film is completely rewound into

the film cassette.

2. Insert the film cassette completely

into the film chamber (15).

• Make sure the Film Status

Indicator (FSI) on the film

cassette is at

●

(#1 position)

for a new cassette.

• Do not force the film cassette

into the film chamber.

14

TAKING PICTURES

You can take Classic (C), Group/

HDTV (H)*, and Panoramic (P)

pictures on the same film cassette.

Your photofinishing costs are based

on the format used.

1. Slide the lens-cover switch (7)

to uncover the lens (8) and

to turn on the camera.

* High Definition Television (HDTV) prints

are the same aspect ratio as the TV for

CD interface capabilities.

2. Slide the print-format switch (10)

to C, H, or P. The viewfinder

changes to show the selected

field of view.

P

H

C

CH P

15

4. Press the shutter button (1)

to take the picture.

3. Frame your subject within the

viewfinder eyepiece (11).

For a sharp picture, stand at

least 3.3 ft (1.0 m) from

your subject.

• For low-light conditions, wait

until the flash-ready lamp (13)

glows green.

16

Typical print sizes (formats)

CH P

Classic Group (HDTV) Panoramic

3.5 x 5 in. or 4 x 6 in. 3.5 x 6 or 4 x 7 in. 3.5 x 8.5 in. to 4 x 11.5 in.

(88.9 x 127 mm or (88.9 x 152 mm or (88.9 x 216 mm to

102 x 152 mm) 102 x 178 mm) 102 x 292.7 mm)

NOTE: Your photofinisher generally provides 4 x 6, 4 x 7 and 4 x 11.5 in.

(102 x 152, 102 x 178 and 102 x 292.7 mm) sizes. Some local printers may

offer 3.5 x 5, 3.5 x 6, and 3.5 x 8.5 in. (88.9 x 127, 88.9 x 152 and

88.9 x 216 mm) sizes.

17

• Hold your camera vertically with

the flash positioned upward to

capture tall, narrow subjects,

such as a waterfall, skyscraper,

or a person.

• Add interest to your picture by

framing it with a tree branch,

a window, or even the rails of

a fence.

• Stand at an angle to shiny

surfaces like windows or mirrors

to avoid flash reflection

and bright spots in your pictures.

• Turn on all the room lights and

have your subject look at the

lights to reduce red eyes in

flash pictures.

Tips for better pictures

• Hold your camera steady by

keeping your elbows close to

your body when you press the

shutter button to avoid blurry

pictures.

• Keep your pictures simple.

Move close enough to your

subject so that it fills the

viewfinder but not closer

than 3.3 ft (1.0 m).

• Take pictures at the subject’s

level. Kneel down to take

pictures of children and pets.

• Keep the sun behind you to

provide the best subject

illumination.

18

TAKING FLASH PICTURES

In dim light, such as indoors or

outdoors in heavy shade, or on

dark overcast days, you need

flash. Your camera has a built-in

automatic flash that fires when

needed.

• Don’t take pictures beyond

the maximum distance or

your pictures will be dark.

4. Wait for the flash-ready

lamp (13) to glow green.

5. Press the shutter button (1)

to take a picture.

1. Slide the lens-cover switch (7)

to uncover the lens (8) and

to turn on the camera.

2. Frame your subject within the

viewfinder eyepiece (11).

3. Keep the subject within the

distance range for the speed

of film in your camera (see

Flash-to-subject distance table).

La page charge ...

Kodak T20 Manuel utilisateur

Ce manuel convient également à

Kodak T20 Manuel utilisateur

dans d''autres langues

Documents connexes