Watchguard Firebox T20/T20-W Guide de démarrage rapide

Catégorie
Points d'accès WLAN
Taper
Guide de démarrage rapide
Activation de votre appliance Firebox
1. Rendez-vous à l’adresse www.watchguard.com/activate
2. Connectez-vous à votre compte WatchGuard ou créez un nouveau compte.
Si vous créez un nouveau compte, retournez à l’adresse www.watchguard.com/
activate à la n duprocessus de création du compte.
Branchement et mise sous tension de votre
appliance Firebox
Assurez-vous que votre ordinateur est configuré pour utiliser le protocole DHCP.
Lorsque vous connectez votre appliance Firebox, elle attribue une adresse IP sur
le réseau 10.0.1.0/24.
Connexion à l’interface utilisateur Web
1. Rendez-vous à l’adresse https://10.0.1.1:8080
Votre appliance Firebox utilisant un certicat auto-signé, vous pouvez, sans
risque, ignorer les avertissements liés aux certicats.
2. Connectez-vous avec le nom d’utilisateur admin et le mot de passe
readwrite.
3. Suivez les instructions de l’Assistant de configuration Web pour configurer
votre appliance Firebox.
4. Installez l’appliance Firebox sur votre réseau.
Pour plus d'informations, rendez-vous sur www.watchguard.com/start
Active su Firebox
1. Visite www.watchguard.com/activate
2. Inicie sesión con su cuenta de WatchGuard o cree una cuenta nueva.
Si usted crea una cuenta nueva, regrese a www.watchguard.com/activate luego
de nalizar el proceso.
Conecte su Firebox y Enciéndalo
Asegúrese de que su equipo esté configurado para usar DHCP. Cuando se
conecte a su Firebox, este le asignará una dirección IP en la red 10.0.1.0/24.
Conéctese a la Interfaz de Usuario Web
1. Visite https://10.0.1.1:8080
De manera segura, puede ignorar cualquier certicado de advertencia debido a
que el Firebox usa un certicado con rma automática.
2. Inicie sesión con el nombre de usuario admin y la frase de contraseña
readwrite.
3. Siga las directivas en el asistente de instalación web para configurar su
Firebox.
4. Instale el Firebox en su red.
Para más información, vaya a www.watchguard.com/start
Guía Rápida Guide de
démarrage rapide
Quick Start Guide
Firebox
®
T20 / T20-W
HW Models: FS2AE5 & FS2AE5W
FRANÇAIS
Activate Your Firebox
1. Go to www.watchguard.com/activate
2. Log in to your WatchGuard account, or create a new account.
If you create a new account, return to www.watchguard.com/activate after
you nish the account creation process.
Connect Your Firebox and Power It On
Make sure your computer is configured to use DHCP. When you connect to
the Firebox, it will assign an IP address on the 10.0.1.0/24 network.
Connect to the Web UI
1. Go to https://10.0.1.1:8080
You can safely ignore certicate warnings, because the Firebox uses a
self-signed certicate.
2. Log in with the user name admin and the passphrase readwrite.
3. Follow the directions in the Web Setup Wizard to configure your Firebox.
4. Install the Firebox in your network.
For more information, www.watchguard.com/start
ENGLISH
ESPANOL
Equipo
Computer
Internet
Internet
Internet
Ordinateur
IMPORTANT NOTES
CE Notice:
The CE symbol on your WatchGuard Technologies equipment
indicates that it is in compliance with the Electromagnetic
Compatibility (EMC) directive and the Low Voltage Directive
(LVD) of the European Union (EU).
Europe – EU Declaration of Conformity (Wireless)
This device complies with the essential requirements of the RED 2014/53/
EU. The following test methods have been applied in order to prove
presumption of conformity with the essential requirements of the RED
2014/53/EU:
EN 60950-1 - Safety of Information Technology Equipment
EN 50385 - Generic standard to demonstrate the compliance of electronic
and electrical apparatus with the basic restrictions related to human
exposure to electromagnetic fields (0 Hz - 300 GHz)
EN 300 328 - Electromagnetic compatibility and Radio spectrum Matters
(ERM); Wideband Transmission systems; Data transmission equipment
operating in the 2,4 GHz ISM band and using spread spectrum modulation
techniques; Harmonized EN covering essential requirements under article
3.2 of the RED Directive
EN 301 893 - Broadband Radio Access Networks (BRAN); 5 GHz high
performance RLAN; Harmonized EN covering essential requirements of
article 3.2 of the RED Directive
EN 301 489-1 - Electromagnetic compatibility and Radio Spectrum Matters
(ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment
and services; Part 1: Common technical requirements
EN 301 489-17 - Electromagnetic compatibility and Radio spectrum
Matters (ERM); ElectroMagnetic Compatibility (EMC) standard for radio
equipment and services; Part 17: Specific conditions for 2.4 GHz wideband
transmission systems and 5 GHz high performance RLAN equipment
EN 623681:2014+A11:2017
This device is a 5GHz wideband transmission system (transceiver),
intended for use in all EU member states and EFTA countries, except in
France and Italy where restrictive use applies.
In Italy the end-user should apply for a license at the national spectrum
authorities in order to obtain authorization to use the device for
setting up outdoor radio links and/or for supplying public access to
telecommunications and/or network services.
This device may not be used for setting up outdoor radio links in France
and in some areas the RF output power may be limited to 10 mW EIRP in
the frequency range of 2454 – 2483.5 MHz. For detailed information the
end-user should contact the national spectrum authority in France.
RoHS Statement
The member states of the European Union approved directive 2002/95/
EC, Restrictions of Hazardous Substances (“RoHS directive”‘) that became
valid on July 1, 2006. It states that all new electrical and electronic
equipment put on the market within the member states must not contain
certain hazardous materials. This device complies with the European
Unions R0HS directive 2002/95/EC and similar regulations that may be
adopted by other countries for European Sales.
To see additional certification information and languages, go to
watchguard.com/start
Declaration of Conformity
WatchGuard Technologies, Inc.
505 Fifth Ave. S., Suite 500
Seattle, WA 98104 USA
WatchGuard Technologies Inc. hereby declares that the product(s) listed below conform to the
European Union directives and standards identified in this declaration.
Product (s):
WatchGuard Model: Firebox T20-W and Firebox T20, Hardware Model: FS2AE5W and FS2AE5
EU Directive(s):
Low Voltage (2014/35/EU)
Electromagnetic Compatibility (2014/30/EU)
RoHS (2002/95/EC)
WEEE Directive 2002/96/EC
REACH EC 1907/2006
The Radio Equipment Directive (2014/53/EU)
Common Standard(s):
EN 60950-1:2006+A11+A1+A12+A2 Safety for ITE
EN 62368-1:2014+A11:2017 Safety for ITE
EN 55032:2012 Class A Emissions for ITE
EN 55024:2010 Immunity for ITE
EN 50385:2017
EN 61000-3-2:2014 Class A
EN 61000-3-3:2013
EN 61000-4-2:2009
EN 61000-4-3:2006+A1:2008+A2:2010
EN 61000-4-4:2004
EN 61000-4-5:2006
EN 61000-4-6:2009
EN 61000-4-11:2004
Wireless Standard(s):
EN 301 489-1 v2.2.3 EMC and Radio Spectrum Matters
EN 301 489-17 v3.1.1 EMC and Radio Spectrum Matters
EN 300 328 v2.1.1 Radio Spectrum Matters
EN 301 893 v2.2.1 Broadband Radio Access Networks
This device complies with Directive 2014/53/EU issued by the Commission of the European Community.
Manufacturer / Hersteller: WatchGuard Technologies
505 5th
Ave S. Suite 500, Seattle, WA 98104 USA
Radio Equipment / Funkanlage: Wireless Access Point
Type Designation / Typenbezeichnung: Firebox T20-W and Firebox T20
Specifications / Technische Daten: 802.11a,b,g,n,ac (2.4Ghz & 5GHz)
Intended Purpose / Verwendungszweck: Indoor Access Point
Equipment Class / Betriebsmittel der Klasse: Class III
The above device complies with the essential requirements and other relevant provisions to Directive
2014/53/EU when used for its intended purpose. This equipment may be operated in the USA, Canada, & Europe
Union.
Warning! This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
The frequency and maximum transmitted power limit in EU are listed as belows,
2412 - 2472 MHz: 20 dBm
5150 - 5350 MHz: 20 dBm
Restrictions: France les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une
utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant
les mêmes canaux
Warnung! Dies ist eine Einrichtung der Klasse A. Diese Einrichtung kann im Wohnbereich Funkstörungen
verursachen. In diesem Fall kann vom Betreiber verlangt werden, angemessene Maßnahmen durchzuführen
Einschränkungen: Frankreich Geräte, die im Band 5150-5250 MHz ist nur für den Innenbereich, um das Risiko
von Störungen des mobilen Satelliten-Systeme, die die gleichen Kanäle
Signature
Full Name: Laurence Huang
Position:
Manufacturing Program Manager Date: Jan 7, 2020
ADDRESS: 505 Fifth Avenue South, Suite 500, Seattle, WA 98104
U.S. SALES: 1.800.734.9905 • INTERNATIONAL SALES: +1.206.613.0895
WEB: www.watchguard.com
© 2020 WatchGuard Technologies, Inc. All rights reserved. WatchGuard, the WatchGuard Logo, Fireware,
and LiveSecurity are registered trademarks of WatchGuard Technologies, Inc. in the United States and/or
other countries. All other trademarks and tradenames are the property of their respective owners.
P.N. 352-T200-001_011420 Rev A
1.877.232.3531
(U.S. and Canada)
WATCHGUARD TECHNICAL SUPPORT
+1.206.613.0456
(all other countries)
www.watchguard.com/support
Firebox
する
1. www.watchguard.com/activate
クセスします。
2.
登録済みの
WatchGuard
アカウントにログインするか新しいアカウントを
成します。
カウを作成する場合は、ト作成プロセスが完てか一度
www.watchguard.com/activate
アクスしてく
Firebox
して
ピュー
DHCP
を使用すに設定さを確認ます
Firebox
への接続時に、
10.0.1.0/24
ネッワーク上
IP
割り当てら
れます
Web UI
する
1. https://10.0.1.1:8080
クセスします。
Firebox
は自己署名証明書を使用するため、証明書に関す警告は無視
かまいません
2.
ユーザー名
admin
とパスフレーズ
readwrite
ログインします。
3.
ブセプ・ザードの手順に従、Firebox を設定ます
4.
ィザしたら、アカウン
admin
ウィ
た管理用パレーズで
Web UI
ログインします。
詳細については www.watchguard.com/start
日本
コン ピューインターネッ
  • Page 1 1
  • Page 2 2

Watchguard Firebox T20/T20-W Guide de démarrage rapide

Catégorie
Points d'accès WLAN
Taper
Guide de démarrage rapide