01 02 03 04 05 06 07 08
• If it isn't possible to completely avoid the solar panel
being blocked by obstacles, try to allow as much
exposure to sunlight as possible.
• Pay attention to battery management via the app
to make sure your device receives enough power
to continue operating. If your Solar Wall Light
Cam does not receive enough power to continue
operating, it can be charged manually, or an
additional solar panel (with USB-C extension cable)
can be connected and placed in a location with
sufficient sunlight to stay powered.
CHARGING THE CAMERA
Charging cable and AC adapter are not included.
SETTING UP
1. Download and install the eufy Security app, and sign
up for an account.
2. Follow the on-screen instructions to add your Solar
Wall Light Cam.
MOUNTING
Select a Location
The camera can be mounted on a wall or similar
surface. Select a location where the solar panel will
not be blocked by obstacles such as a roof or leaves.
WHAT’S INCLUDED
UP
QUICK START GUIDE
S120 Solar Wall Light Cam
AT A GLANCE
①
③
②
④
SYNC
⑤
⑥
⑦
Ensure Tight Seal
①Solar Panel ⑤USB-C Charging Port
②Camera ⑥SYNC Button
③LED Indicator ⑦Speaker
④Microphone
Location Height
We recommend mounting 2 m - 2.5 m (6.6 ft - 8.2 ft)
above ground level.
To maximize solar panel efficiency and the camera
field of view, select a location where the camera
receives plenty of sunlight.
Mount the Camera
1. Mark the mounting points on the wall or surface where
drilling will be required, using the mounting bracket as a
template.
2. Drill holes in the wall or surface, then insert the
expansion anchors into the holes.
This step applies if mounting onto hard surfaces
such as brick or concrete. For soft surfaces such as
wood, skip this step.
Quick Start GuideUSB-C Extension
Cable
Camera Fixing Screw
S120 Solar Wall Light Cam
Model: T81A0
Mounting Bracket Mounting Screws
6.6-8.2 ft
(2 - 2.5 m)
UP
Camera Field of View
Motion
Detection
Zone
SYNC
Ensure Tight Seal
09 10 11 12 13 14 15
3. Screw the mounting bracket onto the wall.
4. Slot the camera onto the mounting bracket and make
sure it is attached securely.
5. Insert and tighten the camera fixing screw at the
bottom of the camera.
Anker Innovations Limited. All rights reserved. eufy Security and eufy Security
Logo are trademarks of Anker Innovations Limited, registered in the United
States and other countries. All other trademarks are the property of their
respective owners.
51005003795 V01
SAFETY
• Do not use the product in an environment where the temperature is too
high or too low. Never expose the product to wet environments.
• The suitable temperature for devices and accessories is -20°C to 50°C
(Charging temperature is 0°C to 40°C).
• It is recommended to supply the device in an environment with a
temperature that ranges from 5°C to 25°C.
• Unless specifically indicated that it is safe to do so in the user guide or
instruction manual, do not use this device in an environment that exceeds
the recommended low or high temperature.
• Unless specifically indicated that it is safe to do so in the user guide or
instruction manual, avoid exposing your device to direct sunshine or
excessively wet environments.
• When supplying power, place the device in an environment that has a
normal room temperature and good ventilation.
• The light source contained in this luminaire should only be replaced by the
manufacturer, its service agent or a similarly qualified person.
SÉCURITÉ
• N’utilisez pas le produit dans un environnement où la température
est trop élevée ou trop basse. N'exposez jamais l’appareil à un ou à un
environnement humide.
• La température appropriée pour le produit et les accessoires est comprise
entre -20 °C et 50°C(la température de charge est de 0 °C à 40 °C).
• Il est recommandé d’alimenter l’appareil dans un environnement dont la
température est comprise entre 5 °C et 25 °C.
• À moins qu’il ne soit spécifiquement indiqué dans le guide de l’utilisateur
ou le manuel d’instructions que cela est sans danger, n’utilisez pas cet
appareil dans un environnement qui dépasse les températures basses ou
élevées recommandées.
• Sauf indication contraire dans le guide de l’utilisateur ou le manuel
d’instructions, évitez d’exposer votre appareil aux rayons directs du soleil
ou à des environnements excessivement humides.
• Lors de l’alimentation électrique, placez l’appareil dans un environnement
ayant une température ambiante normale et une bonne ventilation.
• La source lumineuse contenue dans ce luminaire ne doit être remplacée
que par le fabricant, son agent de service ou une personne également
qualifiée.
CAUTION!
THERE IS A RISK OF EXPLOSION IF AN INCORRECT BATTERY TYPE IS USED.
DISPOSE OF USED BATTERIES ACCORDING TO THEIR INSTRUCTIONS.
ATTENTION!
IL EXISTE UN RISQUE D’EXPLOSION EN CAS D’UTILISATION D’UN TYPE DE
PILE INCORRECT. ÉLIMINEZ LES PILES USAGÉES CONFORMÉMENT AUX
INSTRUCTIONS.
Warning:
– Replacing a battery with an incorrect type may bypass safeguards and
create danger;
– Disposal of a battery in a fire or other source of significant heat, or
by crushing, or cutting, may result in an explosion as well as leakage of
flammable liquids and gases;
– Leaving a battery in an extremely hot environment may result in an
explosion as well as leakage of flammable liquids and gases;
– A battery subjected to extremely low air pressure may result in an
explosion as well as leakage of flammable liquids and gases.
Attention:
-Le remplacement d’une batterie par un type incorrect peut contourner
les protections et créer un danger ;
-L’élimination d’une pile dans un feu ou une autre source de chaleur
importante, ou par écrasement ou découpage, peut entraîner une
explosion ainsi qu’une fuite de liquides et de gaz inflammables ;
-Le fait de laisser une batterie dans un environnement extrêmement
chaud peut entraîner une explosion ainsi qu’une fuite de liquides et de
gaz inflammables ;
-Une batterie soumise à une pression d’air extrêmement faible peut
provoquer une explosion ainsi qu’une fuite de liquides et de gaz
inflammables.
NOTICE
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible or compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures: (1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver. (3)
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected. (4) Consult the dealer or an experienced
radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure
requirements. The device can be used in fixed/mobile exposure
condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using
shielded cables to maintain compliance with FCC regulations.
The following importer is the responsible party:
Company Name: POWER MOBILE LIFE, LLC
Address: 10900 NE 8th St, Ste 501, Bellevue WA 98004
Telephone:1-800-988-7973
IC Statement
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement."
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
IC RF Statement
When using the product, maintain a distance of 20cm from the body to
ensure compliance with RF exposure requirements.
Lors de l'utilisation du produit, maintenez une distance de 20 cm du
corps afin de vous conformer aux exigences en matière d'exposition RF.
Declaration of Conformity
This product complies with the radio interference requirements
of the European Community.
Hereby, Anker Innovations Limited declares that this device is in
compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. For the declaration of conformity,
visit the Web site: https://uk.eufylife.com/.
This product complies with the radio interference requirements
of the United Kingdom.
Hereby, Anker Innovations Limited declares that this product is in
compliance with Radio Equipment Regulations 2017(SI2017/1206). The
full text of the UK declaration of conformity is available at the following
internet address: https://uk.eufylife.com
RF exposure information:
The Maximum Permissible Exposure (MPE) level has been calculated
based on a distance of d=20 cm between the device and the human
body. To maintain compliance with RF exposure requirements, use
product that maintains a 20cm distance between the device and the
human body.
Frequency bands and power as below:
Function Bands Operation Frequency Max. Power
Wi-Fi 2.4GHz 2412-2472MHz EIRP 19.94 dBm
The following importer is the responsible party (contract for EU matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807
Munich, Germany
The following importer is the responsible party (contract for UK matters):
Anker Technology (UK) Limited I GNR8, 49 Clarendon Road,
Watford,Hertfordshire, WD17 1HP, United Kingdom
This product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
This symbol means the product must not be discarded as
household waste, and should be delivered to an appropriate
collection facility for recycling. Proper disposal and recycling
helps protect natural resources, human health and the
environment. For more information on disposal and recycling of
this product, contact your local municipality, disposal service, or
the shop where you bought this product.
UP
UP
UP
UP
CUSTOMER SERVICE
12-month limited warranty
(US) +1 (800) 988-7973
(UK) +44 (0) 1604 936200
(DE) +49 (0) 69 9579 7960
(中国 ) +86 400 0550 036
(日本 ) +81 03 4455 7823
(AU) +61 3 8331 4800
(Egypt) +20 8000000826
(UAE) +971 8000320817
(Kuwait) +965 22069086
(Saudi Arabia) +966 8008500030
(Middle East & Africa) +971 520750842
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road,
Mongkok, Kowloon, Hong Kong
@EufyOfficial @EufyOfficial @EufyOfficial
-
1
-
2
dans d''autres langues
- English: Eufy S120 User guide
Documents connexes
-
Eufy AM 2C Wire-Free HD Security Camera Mode d'emploi
-
Eufy T8350 Mode d'emploi
-
-
Eufy T8920 Mode d'emploi
-
-
Eufy T8441 Mode d'emploi
-
Eufy E8453JW1 Mode d'emploi
-
Eufy C210 Mode d'emploi
-
-
Eufy T8160 Mode d'emploi