SmartPower SYSTEMS TBF15P-1120 Mode d'emploi

Taper
Mode d'emploi
USER'S GUIDE
USER'S GUIDE
Thank you for purchasing this Guardian Electronic Power
Conditioner. Smart Power Systems is dedicated to developing
and manufacturing the highest performance power protection
and filtration devices for your electronic equipment. Proper
use of this device will provide the protection needed for your
connected equipment.
16005550 Rev.05/22
GUARDIAN
ELECTRONIC POWER CONDITIONER
WITH SMART GROUND
1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Guardian unit.
3. Plug the Guardian unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Guardian where monitoring lights
can be observed.
Installation of TBF™
Use this user's guide for the following products:
Modem & Data Protection (model dependent)
Protection is extended to your phone and network lines with the addition of RJ11 and RJ45 jacks
on the Guardian unit, creating ideal protection for Fax/Internet/Network users. Power surges can
pass to the connected equipment through phones lines and network cables.
CAUTION
CAUTION
CAUTION
CAUTION
• Use only in dry locations indoors.
Avoid dropping the unit.
• Only plug the Guardian into a three pronged grounded outlet. This unit is not to be used with any
type of ground “lift” or pin eliminator.
• Do not open the Guardian unit, there are no serviceable parts inside. Opening the unit will void
your warranty.
This device features an internal protection that will disconnect the surge protective component
at the end of its useful life but will maintain power to the load now unprotected. If this situation
is undesirable for the application, follow the manufacturer's instructions for replacing the device.
Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the
electrical outlet and the electrical service panel.
Risk of Electric Shock. Do not plug into another relocatable power tap.
FEATURES
If you have any questions call us at our Tech Support line toll free
1-800-772-7633 or email us at [email protected]
DESCRIPTIONMODEL / PART NUMBER
120V/15A, two 5-15R outlets
TBF15P-1120
120V/15A, two 5-15R outlets, RJ11 + RJ45
120V/15A, one pigtail 5-15R outlet, RJ11 + RJ45
TBF15P-1121TN
TBF15P-1111TN
•• Utiliser uniquement dans des endroits secs à l'intérieur.
• Évitez de faire tomber l'appareil.
• Brancher le Guardian en trois volets prise de terre. Cette unité ne doit pas être utilisé avec
tout type de terrain "ascenseur" ou broches éliminateur.
• Ne pas ouvrir l'unité Guardian, il n'y a pas de pièces réparables. Ouverture de l'unité
annulera votre garantie.
Cet appareil dispose d'une protection interne qui va déconnecter le composant de protection contre
les surtensions à la fin de sa vie utile mais se maintenir au pouvoir à la charge maintenant sans
protection. Si cette situation est souhaitable pour l'application, suivez les instructions du fabricant
pour le remplacement de l'appareil.
Ne pas installer cet appareil si il n'y a pas au moins 10 mètres (30 pieds) ou plus de fil entre la prise
électrique et le panneau de service électrique.
ATTENTION
ATTENTION
ATTENTION
ATTENTION
Risque de choc électrique. Ne branchez pas dans une autre puissance robinet délocalisables.
Guardian
Power Cord
Installation for Protection for Telephone Line and Network Cable
Installation for Protection for Network Cable
TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "DEVICE"
on the Guardian.
2. Plug the provided telephone cable to the RJ11 jack "LINE" on the Guardian.
3. Plug the other end of the telephone cable into the RJ11 wall jack.
CAUTION: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.
Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.
Connected
Equipment with
Tel./Modem Jack
Power Cord
Power Cord
Phone Cord
Phone Cord
Network Cord
Network Cord
LINE
LINE
DEVICE
DEVICE
Phone
Wall Jack
Network Jack/ HUB
Connected
Equipment with
Network Jack
IMPORTANT: The Guardian is designed to be compatible with a GFCI (Ground Fault
Circuit Interrupter), however, during plug in the GFCI might trip. Press the reset button to
restart the circuit.
Note: Do Not plug more than 3 Guardian products to a circuit that has a GFCI circuit
breaker or GFCI wall outlets.
The RED light indicates over voltage, improper ground connection or
reversed power wires which needs to be corrected. In an over voltage
incident, power is disconnected to protect the connected equipment.
Important: If the RED Light comes on, contact your electrician to
inspect and correct the outlet wiring in order to receive the maximum
protection for your connected equipment.
The green light confirms properly the connected equipment is fully protected.
GREEN LIGHT
RED LIGHT
NETWORK
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"DEVICE" on the Guardian.
2. Plug the provided CAT5 cable to the RJ45 jack "LINE" on the Guardian.
3. Plug the other end of the CAT5 cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the Guardian where monitoring lights can be observed.
Telephone Line Protection clamping voltage 250-350 vdc.
TRANSFORMER BASED FILTER SERIES (TBF™) POWER FILTERS
Considered to be one of the most significant developments in the power protection industry. TBF
Filters contain innovative technology that combines Surge Suppression and Noise Isolation which
filters the noise on the ground to less than 0.5 Volts (US Patent # 6229682). Exclusive "POVP"
Prolonged Over Voltage Protector (US Patent # 6560086) disconnects the output power if voltage
exceeds 155 volts. Exclusive Smart Technology (US Patent #5721661) protects microprocessor
based equipment against reverse polarity or no ground. The patented TBF™ filters prevent 90% of
the power problems experienced by your POS system, computer, copier and facsimile machine.
7409 Railhead Ln. - Houston, Texas 77086 - Tel:(713)464-8000 - Fax:(713)984-0841
E-mail: [email protected] - www.smartpowersystems.com
UL 1449 3rd. Edition Listed
AUTOMATIC VOLTAGE REGULATOR - AVR SERIES
Regulates the voltage to protect equipment against voltage sags and brownouts. Electronic
systems are designed to operate based on a clean and constant supply of AC voltage.
Smart Power Systems' AVR line provides boost & buck capability to eliminate under or over
voltage fluctuations.
UNINTERRUPTIBLE POWER SUPPLIES - UPS SERIES
Smart Power Systems' Uninterruptible Power Supplies (UPS) integrated TBF™ Technology
provide on-line power conditioning.
OTHER POWER PROTECTION PRODUCTS
IMPORTANT
If for any reason you need to return the Guardian unit to the manufacturer, you should
obtain an RMA (Return Material Authorization) number before returning the unit.
To request an RMA number please call 1-800-772-7633 or visit the website at
www.smartpowersystems.com/main/rma.htm
WARRANTY
All Guardian Filters are guaranteed free of defects in material or workmanship for the life to the
original purchaser --or, they will be repaired or replaced free of charge. See our website for
more details - www.smartpowersystems.com
Limited Lifetime Warranty
If the Smart Power Systems equipment fails and this failure allows a surge to pass through and
damage the connected equipment, Smart Power Systems will pay for the repair or replacement of
the connected equipment of the original purchaser . Please take the time to register each Smart
Power Systems' product along with the connected equipment devices connected to it within 10
days of date of purchase in order for you to take advantage of this product warranty and connected
equipment protection policy. See our website for more details - www.smartpowersystems.com
$25,000 Connected Equipment Warranty
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

SmartPower SYSTEMS TBF15P-1120 Mode d'emploi

Taper
Mode d'emploi

dans d''autres langues