Mitsubishi Electric Himeji Works SKE45A03 Manuel utilisateur

Marque
Mitsubishi Electric Himeji Works
Modèle
SKE45A03
Taper
Manuel utilisateur
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
FCC/ISED
This device complies with part 15 of FCC Rules and Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des
CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'appareil doit accepter tout brouillage subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
(14/15)
【
Confidential
】
1.Smart Keyless functions
The Smart Keyless functions (Keyless entry system) enables the following operations while the
Hand Unit is being carried.
・
When the operator pushes the Start Button, the system is activated and the engine start
propriety (permission / prohibition) is determined.
・
The engine start is permitted if the operator is only within operational range while the Hand
Unit is being carried.
・
The operational range for the engine start permission is up to 80 cm (2.6 feet) from the center
of the Start Button in the control panel.
1) Engine start permission
(1) In the case of permission
The buzzer sounds 3 times, and LED on the control panel turn on.
(2) In the case of permission
The buzzer sounds 4 times, and LED on the control panel turn off after flashing.
2) The System stop
The System will run out when pushing the Start Button in the engine stop state.
The buzzer sounds 1 time, and LED on the control panel turned off.
(3) Emergency engine stop
The engine is stopped by pushing the Start Button (1 second or more) at the engine
operating state.
The buzzer continues to sounding, and LED on the control panel turned off.
The buzzer is stopped by pushing the Start Button again.
2. Remote system off function
1) In the engine stop state, the Remote function can be turned off the system by pushing the
button on the Hand Unit. Then, (when the button on the Hand Unit is pushed), the buzzer
sounds 1 time, and LED on the control panel turned off.
The operating range is up to 80 cm (2.6 feet) from the center of the Start Button in the
control panel.
2) With the system off state, the engine can not be started.
3. Child Lock mode of the Hand Unit
1) When you continue pushing the button on the Hand Unit (1 second or more), it will be the
Child Lock mode.
When it comes to tte Child Lock mode, LED of the Hand Unit is turned on 0.5 seconds.
In the Child Lock mode, the function of the 1 and 2 above can not operate.
2) To cancel the Child Lock mode, you must push the button of the Hand Unit (1 second or
more) again.
When the Child Lock mode is released, LED of the Hand Unit is turned on 0.1 seconds.
User's Mmanual_SKE45A-03.xls
(15/15)
  • Page 1 1
  • Page 2 2

Mitsubishi Electric Himeji Works SKE45A03 Manuel utilisateur

Marque
Mitsubishi Electric Himeji Works
Modèle
SKE45A03
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents