NOVA H1 Audio Earrings
by NOVA Products GmbH
Weight and dimensions
Earring 7.7g
Charger 57g, 61mm x 61mm x 24mm
Gift box 179g, 120mm x 121mm x 61mm
Total weight 251g
Power
Earring battery 3.7V / 24mAh Li-Ion battery
Charger battery 3.7V / 320mAh Li-Ion battery
Earring current supply max. 33mA
Charging case current max. 450mA / 5V
Charging connector USB-C (no data lines)
Wireless charging WPC 1.2
Charging time 90 minutes
Playtime (music) 4h*
Speaking time 2.8h*
Standby time 48h*
Number of full recharges from the
charging case
Up to 3 times, for additional 12 hours
of playtime (16h total)
Connectivity
Bluetooth version 5.2
Bluetooth profiles A2DP, HFP, HSP, AVRCP
Audio Codecs SBC, AptX, AAC
Operating range 10m
Frequency band 2400 – 2483 MHz
Enviromental conditions
Storage temperature -20°C – 60°C
Operating temperature 0°C - 45°C
Charging temperature 15°C - 45°C
Waterproof no
Materials
Gold / Silver plating nickel-free
*Based on internal testing. Audio playback time tested by pairing a set of pre-production NOVA H1 Audio Earrings to a recently
released Android smartphone. Actual battery life and charging time may vary by usage conditions, number of times charged and
many other factors
*Play time may vary based on settings.
Product description
Intended use:
• The product is designed for listening to music and making phone calls.
• The earrings connect to a smartphone via Bluetooth.
• The earrings can be charged by putting them in the charging case and closing
the charging case.
• The charging case can be charged through the USB-C connector or alternatively
by placing the charging case on a wireless charging pad. The LEDs of the
charging case will indicate that the charging process is ongoing.
Operating frequencies:
2400 – 2483 MHz
RF output power:
Max. EIRP average 6.0dBm (4mW)
max RF peak output power: 8.5dBm
Rated antenna gain: -1dBi
Supply voltages and currents:
Charging case Input: 5V / 450mA
Charging case Output: 5V / 80mA
Earring Input: 5V / 33mA
Additional intended environmental conditions:
Humidity: 10% – 90%, non-condensing
Soft- and hardware versions of the product:
Software Version: V1
Hardware Version: V1
Compliance information:
- USA
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance voids the user's authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• • Consult the dealer or an experienced radio/TV technician for help.
- Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment and meets RSS-102 of the ISED radio frequency (RF)
Exposure rules as this equipment has very low levels of RF energy.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est
conforme aux CNR d’Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est sus ceptible d’en compromettre le fonctionnement.
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées
pour un environnement non contrôlé et respecte les règles d’exposition aux
fréquences radioélectriques (RF) CNR-102 de l’ISDE puisque cet appareil a une niveau
tres bas d'energie RF.
-
1
-
2
-
3
-
4
-
5
