Alula CAM-OD-JS1-AI Guide d'installation

Catégorie
Accessoires pour appareil photo
Taper
Guide d'installation
CAM-OD-JS1-AI
Outdoor Bullet Camera
Installation Guide
Save this guide for future reference
What’s in the box
WiFi antenna
wireless camera
mounting hardware
AC power adapter
installation guide
RJ45 connector
MicroSD card
Hardware overview
reset button
MicroSD
card slot
LED
1. Camera setup
a. Insert MicroSD card in slot on back of camera
b. Power on the camera and wait for about one minute until the LED
indicator blinks in a 3-flash repeating pattern
Note: It is best to test the camera’s
functionality with the app prior to
mounting.
a. Open the Alula Security app
b. In the app, browse to Cameras, then tap the ‘+’ icon on the top
right of the screen and follow your device’s on-screen prompts
2. App configuration
Don’t have the app?
Scan the QR code for your device’s app store here
Apple iOS Android
a. When mounted outdoors, the camera connections should be
appropriately protected from the weather. Mount the camera on a
junction box or feed the camera cable into the hole and pull it out
from the interior. Use fish tape to pull the cable through the wall if
needed. Caulk the hole properly to avoid water damage.
3. Camera installation
b. Plug camera into power supply. If connecting your camera with a
wired connection, plug the ethernet cable into your router.
WiFi
Products with CE Marking comply with EMC Directive (2014/30/EU); Low Voltage Directive (2014/35/EU); RED (2014/53/EU);
ROHS Directive (2011/65/EU) issued by the Commission of the European Community. Compliance with these directives
implies conformity to the following European Norms:
EMC: EN 301 489
LVD: EN 62368-1
Radio: EN 300 328
If the camera system no longer functions or can no longer be repaired, it must be disposed of according to the valid statutory
regulations. Disposal of spent batteries/accumulators:
You are required by law (Battery Ordinance) to return all spent batteries and accumulators. Disposing of spent
batteries/accumulators with common household waste is prohibited! Batteries/accumulators that contain hazardous
substances are marked with the symbols on the side. These symbols indicate that it is prohibited to dispose of these
batteries/accumulators in the household waste. The abbreviations for the respective heavy metals are: Cd=cadmium,
Hg=mercury, Pb=lead. You can return spent batteries and accumulators that can no longer be charged to the designated
collection points in your community, outlets or wherever batteries or accumulators are sold. Following these instructions will
allow you to fulfill the legal requirements and contribute to the protection of our environment!
TRADEMARKS
Alula is a trademark owned by Alula Holdings, LLC. Wi-Fi is a trademark of The Wi-Fi Alliance.
Android is a trademark of Google LLC. IOS is a trademark of Cisco in the U.S. and other countries
and is used under license by Apple Inc.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received, including interference that may
cause undesired operation.
Caution: any changes or modifications to this device not explicitly approved by manufacturer could
void the user’s authority to operate this equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Canada Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1) L’appareil ne doit pas produire de brouillage;
2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscepti-
ble d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and
compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and
compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS
102 et la conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne
sur l'exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre
antenne ou émetteur. Cet équipement devrait être installé et actionné avec une distance minimum
de 20 centimètres entre le radiateur et votre corps.
This radio transmitter [enter the device’s ISED certification number] has been approved by Innovation, Science
and Economic Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum
gain indicated for any type listed are strictly prohibited for use with this device.
Le présent émetteur radio [identifier le dispositif par son numéro de certification d’ISDE] a été approuvé par
Innovation, Sciences et Développement économique Canada pour fonctionner avec les types d'antenne
énumérés ci dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et
dont le gain est supérieur au gain maximal indiqué pour tout type figurant sur la liste, sont strictement interdits
pour l'exploitation de l'émetteur.
The antenna (type / gain / impedance) which can be used with the transmitter is: External antenna/2dBi/50Ω
L'antenne (type / gain / impédance) qui peut être utilisée avec l'émetteur est : External antenna/2dBi/50Ω
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Alula CAM-OD-JS1-AI Guide d'installation

Catégorie
Accessoires pour appareil photo
Taper
Guide d'installation

dans d''autres langues