APG BlueProTM 510 Manuel utilisateur

APG
Marque
APG
Modèle
BlueProTM 510
Taper
Manuel utilisateur
APG doc no. M-23G-510-06 Rev J 1 (7)
BluePRO
TM
Model 510 Bluetooth External Device
Product Specification – Part Numbers and Descriptions
APG Part Number Description
BA-0510-0101A-02
BluePRO
TM
Model 510 Bluetooth Interface Adapter for Direct Drive
Printer-Kick Cash Drawer with CD-101A Cable and USA power adapter
BA-0510-0102A-02
BluePRO
TM
Model 510 Bluetooth Interface Adapter for Direct Drive
Printer-Kick Cash Drawer with CD-102A Cable and USA power
adapter
BA-0510-0101A-03
BluePRO
TM
Model 510 Bluetooth Interface Adapter for Direct Drive
Printer-Kick Cash Drawer with CD-101A Cable and Multi-Country
power adapter
BA-0510-0102A-03
BluePRO
TM
Model 510 Bluetooth Interface Adapter for Direct Drive
Printer-Kick Cash Drawer with CD-102A Cable and Multi-Country
power adapter
BluePro
TM
Model 510 Bluetooth
Cash Drawer Interface Adapter
User’s Guide
APG doc no. M-23G-510-06 Rev J 2 (7)
Contents
Product Specification – Part Numbers and Descriptions ....................................... 1
Introduction and Product Overview .................................................................. 3
Operational Description and Antenna Information .............................................. 5
Declaration of Comformity .............................................................................. 5
Product Label Information ............................................................................... 6
Device Dimension and Resource ...................................................................... 7
APG doc no. M-23G-510-06 Rev J 3 (7)
Introduction and Product Overview
This document describes the APG BluePRO
TM
Model 510 Bluetooth-enabled Cash Drawer Interface
Adapter and the APG BluePRO
TM
Application (App) behavior and all elements that are involved.
The application’s operation is based on Bluetooth communication (IEEE 802.15) between a
Bluetooth-enabled device and the APG BluePRO
TM
Model 510 Bluetooth-enabled Cash Drawer
Interface Adapter and a printer-kick cash drawer.
APG BluePRO
TM
Model 510 Bluetooth-enabled Cash Drawer Interface Adapter is constructed per
Bluetooth version 2.1 (Classic Bluetooth Mode with EDR). The operating frequency range is
2402-
2480 MHz.
The APG BluePRO
TM
sample application supports up to a maximum of seven (7) APG Model 510
BluePRO
TM
Bluetooth-enabled Cash Drawer Interface Adapters.
Bluetooth-Enabled
Thin Client Device
APG Cash Drawer's
BluePRO Model 510
Bluetooth-Enabled Cash
Drawer Interface
Adapter
Low-Cost
'Printer Kick'
Cash Drawer
Power Adapter
- US
- Multi-Country
Bluetooth 802.15
Class 3 Radio
Limited Range
TM
Bluetooth 802.15
Class 2 Radio
Limited range
APG doc no. M-23G-510-06 Rev J 4 (7)
Operational Description and Antenna Information
Operation Description:
The APG BluePRO 510 interface is a cash drawer controller that utilizes Bluetooth signals to
communicate to the host device to operate a cash drawer. The product implements Bluetooth
version 2.1 (Classic Bluetooth Mode with EDR).
- The interface is paired to a Bluetooth-enabled host device e.g. tablet or handheld.
- Once paired, an application running on that host may transmit commands to control a cash
drawer.
- The BluePRO 510 device controls only the APG Model 237A and 437A interface
o Drawer Kick
o Query cash drawer status
- Default: the BluePRO 510 does not provide a cash drawer open/closed status reporting.
Drawer status reporting feature must be activated by the user.
- The device is power by a 24VDC power adapter.
- The device connects to a host as a peripheral device and transmits the commands to
operate the cash drawer via Bluetooth signals.
- The operating frequency ranges from 2402-2480 MHz.
- The Bluetooth signal of the device reaches a radius of approximately 15 foot from the
device.
Antenna Information:
The BluePRO 510 interface uses the internal antenna of the Bluetooth controller chip to transmit
the Bluetooth signal to the host device.
APG doc no. M-23G-510-06 Rev J 5 (7)
Declaration of Conformity
FCC
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
RF Exposure Guidance: This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter, except in accordance with FCC multi-transmitter product
procedures.
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
APG doc no. M-23G-510-06 Rev J 6 (7)
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner
avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par
Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des
autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope
rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une
communication satisfaisante.
Label Affixed to the Product
Mechanical Specifications:
Style Direct thermal label
Material Low-cost paper
Adhesive Permanent
Overlay None
Size 1.20in wide x 0.85in tall
Text Color Black
Font and Size for Text Reasonably large, easily readable and as shown
APG doc no. M-23G-510-06 Rev J 7 (7)
Device Dimension
Resources
For product assistance, contact your reseller partner or APG Cash Drawer.
Technical Services and Support Group
APG Cash Drawer, LLC
5250 Industrial Blvd NE
Minneapolis, MN 55421
+1.763.571.5000 ext. 160
E: apgsupport@apgcd.com
t: @apgtechsupport
w: http://cashdrawer.com
Dimension
Height = 1.02IN
Width = 2.50IN
Length = 2.65IN
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7

APG BlueProTM 510 Manuel utilisateur

APG
Marque
APG
Modèle
BlueProTM 510
Taper
Manuel utilisateur
Télécharger le PDF
rapport

dans d''autres langues

Autres documents